Delivery of Goods 2.1 All Goods are supplied Ex Works (Incoterms 2020) Supplier’s premises unless specifically agreed to the contrary in any Order. Any dates quoted for delivery are approximate only and the time of delivery is not of the essence. 2.2 If Goods are ready for delivery and Purchaser fails to take delivery on the date required by the Contract, or after seven (7) days’ written notice from Supplier where no such date is specified, Supplier shall be entitled to: (a) issue an invoice for such Goods; and (b) charge Purchaser for all additional costs and expenses (including, without limitation, warehousing and insurance) until delivery takes place. 2.3 If Purchaser fails to take delivery within thirty (30) days of the date of invoice it shall be deemed to have waived its rights under the Contract, and without prejudice to any other right that Supplier may have against Purchaser, including the right to recover the purchase price in full, Supplier shall be entitled to resell the Goods. 2.4 Any right of Purchaser to reject the Goods and/or terminate the Contract for late delivery of the Goods shall not be exercisable unless Purchaser has first served written notice on Supplier requiring Supplier to complete delivery of the Goods within not less than thirty (30) days of service of that notice on Supplier in accordance with Section 14. Supplier shall not be liable for any delay in delivery of the Goods caused by Purchaser's action or inaction including, without limitation, failure to provide Supplier with adequate delivery instructions or any other information, applicable to the supply of the Goods. If Supplier fails to deliver, or is late in delivering the Goods, Supplier’s liability shall be limited to the price of the Goods. 2.5 Purchaser shall promptly inspect all delivered Goods and shall notify Supplier in writing of any issues regarding the Goods delivered, including, without limitation, as to quantity, type and quality, within ten
Delivery of the Goods 19.1 Unless otherwise expressly specified in the written acknowledgement of order, delivery of the Goods will be made ex-works as defined in INCOTERMS 2000. 19.2 Delivery of the Goods will be made during Supplier’s usual business hours. 19.3 Supplier will use reasonable endeavours to deliver and perform each of Buyer’s orders for the Goods within the time agreed when Buyer places an order and Supplier provides the acknowledgement of order and, if no time is agreed, then within a reasonable time, but the time of delivery will not be of the essence. If, despite those endeavours, Supplier is unable for any reason to fulfil any delivery on the specified date, Supplier will be deemed not to be in breach of this Contract, nor (for the avoidance of doubt) will Supplier have any Liability to Buyer for any delay or failure in delivery except as set out in this condition. Any delay in delivery will not entitle Buyer to cancel the Contract unless and until Buyer has given one hundred and twenty days’ written notice (or such longer period specified in the written acknowledgement of Contract) to Supplier requiring the delivery to be made and Supplier has not fulfilled the delivery within that period. If Buyer cancels the Contract in accordance with this clause then: 19.3.1 Supplier will refund to Buyer any sums which Buyer has paid to Supplier in respect of that Contract or part of the Contract which has been cancelled and has not been delivered or is not ready for delivery; and 19.3.2 Buyer will be under no liability to make any further payments under clause 4.1 in respect of that Contract or part of the Contract which has been cancelled. 19.4 Buyer will provide at its expense at the Delivery Point adequate and appropriate equipment and manual labour for loading the Goods. 19.5 If Buyer fails to take delivery of any of the Goods when they are ready for delivery or to provide any instructions, documents, licences or authorisations required to enable the Goods to be delivered on time (except solely on account of Supplier’s default), the Goods will be deemed to have been delivered on the due date and (without prejudice to its other rights) Supplier may: 19.5.1 store or arrange for storage of the Goods until actual delivery or sale in accordance with this clause and charge Buyer for all related costs and expenses (including, without limitation, storage and insurance); and/or 19.5.2 following written notice to Buyer, sell any of the Goods at the best price reasonably obtainable in the circumstances and charge Buyer for any shortfall below the price under the Contract or account to Buyer for any excess achieved over the price under the Contract, in both cases having taken into account any charges related to the sale. 19.6 Buyer shall provide or procure the provision to Supplier of all facilities and such other assistance and services as may be necessary to the extent and quality necessary to enable Supplier to fulfil its obligations under the Contract. This assistance shall include (but not be limited to) the timely provision of and access to information, data, accommodation, computing resources, appropriate Buyer employees and a safe working environment.
Delivery of Software 1. SAP will deliver the Software as described in the Documentation and the Price List and will also provide the appropriate license key for the relevant End User. With regard to the features, quality and functionality of the Software the product description in the Documentation and the Price List is solely decisive. SAP does not own any additional features, quality or functionality. Distributor can, in particular, not assert any additional feature, quality or functionality from any public statements, publications or advertisements by SAP except to the extend SAP has expressly confirmed such additional feature, quality or functionality in writing. Any representation, warranty, undertaking or guarantee regarding additional features, quality or functionality is effective only if expressly confirmed by SAP’s management in writing. 2. After acceptance of an order, SAP will deliver to Distributor one copy of the relevant Software: a) on discs or other data media (“Physical Shipment”); or b) by making it available for downloading through the internet (usually on the SAP ServiceMarket Place (xxxx://xxxxxxx.xxx.xxx/swdc)) (“Electronic Delivery”). 3. The relevant Software and Documentation will be deemed delivered (including but not limited for the purpose of fixed delivery dates or timely delivery) and the risk passes to Distributor: a) in case of Physical Shipment, when the relevant disc or other data media thereof is handed over to the freight carrier (FCA - Free Carrier (named place of delivery), Incoterms 2010); or b) in case of Electronic Delivery, when SAP has made an electronic copy thereof available for downloading and has informed Distributor accordingly, (“Delivery”). 4. Upon Distributor’s request or if stipulate in the order, SAP may agree to provide Software and/or the appropriate license key directly to the relevant Open Ecosystem Partner instead (“Open Ecosystem Partner Delivery”). In case of Open Ecosystem Partner Delivery, the provisions set out in this Article 5 (Delivery of Software) will apply analogously; delivery to Distributor will be deemed to occur upon Delivery to the Open Ecosystem Partner. 5. Upon Distributor’s request or if stipulate in the order, SAP may agree to provide Software and/or the appropriate license key directly to the relevant End User instead (“End User Delivery”). In case of End User Delivery, the provisions set out in this Article 5 (Delivery of Software) will apply analogously; delivery to Distributor will be deemed to occur upon Delivery to the End User. 6. SAP might be entitled to suspend the delivery of the Software, Maintenance Services, applicable license key or both to Distributor, Open Ecosystem Partner or End User or both as further set out in this Sell On Premise Distribution Model as well as the Distribution GTCS. 7. If Distributor receives a new copy of the Software, Documentation and/or other SAP Materials that replaces previously provided Software, Documentation and/or other SAP Materials, Distributor must distribute that newest copy provided and either destroy or upon SAP’s request return previous copies. 8. Distributor must not make the Software, Documentation and/or other SAP Materials available to the Open Ecosystem Partner or End User by any means other than by delivering the Software, Documentation and/or other SAP Materials as originally provided by SAP. Distributor’s right to pass on the Software, Documentation and/or other SAP Materials is subject to the provisions of this Agreement.
DELIVERY OF CALCULATIONS On or before November 1 of each year for which this Agreement is effective, the Third Party appointed pursuant to Section 4.3 of this Agreement shall forward to the Parties a certification containing the calculations required under this Article IV, Article V, Article VI, of this Agreement in sufficient detail to allow the Parties to understand the manner in which the calculations were made. The Third Party shall simultaneously submit his, her, or its invoice for fees for services rendered to the Parties, if any fees are being claimed, which fee shall be the sole responsibility of the District, but subject to the provisions of Section 4.8, below. Upon reasonable prior notice, the employees and agents of the Applicant shall have access, at all reasonable times, to the Third Party’s calculations, records, and correspondence pertaining to the calculation and fee for the purpose of verification. The Third Party shall maintain supporting data consistent with generally accepted accounting practices, and the employees and agents of the Applicant shall have the right to reproduce and retain for purpose of audit, any of these documents. The Third Party shall preserve all documents pertaining to the calculation until four (4) years after the Final Termination Date of this Agreement. The Applicant shall not be liable for any of the Third Party’s costs resulting from an audit of the Third Party’s books, records, correspondence, or work papers pertaining to the calculations contemplated by this Agreement.
Inspection of Goods 8.1 The Buyer shall inspect the goods upon delivery. 8.2 Where goods are damaged the Buyer shall notify the Supplier. The Buyer may reject the damaged goods and the following provisions shall apply: 8.2.1 the Supplier shall collect the damaged goods from the Buyer at the Supplier’s expense; 8.2.2 during the period between delivery of the goods to the Buyer and collection by the Supplier, the Buyer shall not be liable for any loss or further damage caused to the damaged goods; 8.2.3 all sums payable by the Buyer in relation to the damaged goods shall cease to become payable; 8.2.4 all sums paid by the Buyer in relation to the damaged goods shall be repaid by the Supplier immediately; 8.2.5 the Buyer shall be entitled to claim damages from the Supplier for any losses caused to the Buyer as a result of the goods being damaged. 8.3 Where there are shortages in the order the Buyer shall notify the Supplier and the following provisions shall apply: 8.3.1 all sums payable by the Buyer in relation to the missing goods shall cease to become payable; 8.3.2 all sums paid by the Buyer in relation to the missing goods shall be repaid by the Supplier immediately; 8.3.3 the Buyer shall be entitled to claim damages from the Supplier for any losses caused to the Buyer as a result of the shortages. 8.4 If the Buyer so requests, the Supplier shall immediately replace damaged goods or supply goods which are missing at the Supplier’s expense or the Buyer shall be entitled to cancel, without notice, the whole or any unexecuted part of the order and the rights referred to in Clause 5.2 shall apply. 8.5 Where there is an excess of goods in relation to the order the Buyer may reject the excess goods by notice in writing to the Supplier and the following provisions shall apply: 8.5.1 the Supplier shall collect the excess goods from the Buyer at the Supplier’s expense; 8.5.2 during the period between delivery of the goods and collection by the Supplier, the Buyer shall not be liable for any loss or damage caused to the excess goods; 8.5.3 no sum shall be due to the Supplier for the excess goods and in the event that sums are paid to the Supplier for the excess goods, the Supplier shall repay such sums to the Buyer immediately. 8.6 The Buyer may accept excess goods by notifying the Supplier of such acceptance and the price of the excess goods shall be payable by the Buyer. 8.7 The Supplier shall repair or replace free of charge, goods damaged or lost in transit upon receiving notice to that effect from the Buyer. 8.8 The Buyer’s signature on any delivery note of the Supplier is evidence of the number of packages received only and not evidence of the correct quantity of goods received or that the goods are in a good condition or of the correct quality.
Delivery of Materials to Underwriters The Company will deliver to each of the several Underwriters, without charge and from time to time during the period when a prospectus is required to be delivered under the Act or the Exchange Act, such number of copies of each Statutory Prospectus, the Prospectus and all amendments and supplements to such documents as such Underwriters may reasonably request.
Procurement of Goods and Services (a) If the HSP is subject to the procurement provisions of the BPSAA, the HSP will abide by all directives and guidelines issued by the Management Board of Cabinet that are applicable to the HSP pursuant to the BPSAA. (b) If the HSP is not subject to the procurement provisions of the BPSAA, the HSP will have a procurement policy in place that requires the acquisition of supplies, equipment or services valued at over $25,000 through a competitive process that ensures the best value for funds expended. If the HSP acquires supplies, equipment or services with the Funding it will do so through a process that is consistent with this policy.
Procurement of Goods Part A: General Goods shall be procured in accordance with the provisions of Section I of the "Guidelines for Procurement under IBRD Loans and XXX Credits" published by the Bank in January 1995 and revised in January 1996 (the Guidelines) and the following provisions of this Section, as applicable. Part B: International Competitive Bidding
Supply of Goods 6.1 In consideration of UKRI’s agreement to pay the Charges, the Supplier shall supply all Goods in accordance with the Agreement and any Contract. In particular, the Supplier warrants that the Goods shall: (a) conform with their description in the specifications (including the Specification), drawings, descriptions given in quotations, estimates, brochures, sales, marketing and technical literature or material (in whatever format made available by the Supplier) supplied by, or on behalf of, the Supplier; (b) be of satisfactory quality (within the meaning of the Sale of Goods Act 1979) and fit for any purpose held out by the Supplier or made known to the Supplier by UKRI, expressly or by implication, and in this respect UKRI relies on the Supplier's skill and judgement. The Supplier acknowledges and agrees that the approval by UKRI shall not relieve the Supplier of any of its obligations under this sub-clause; (c) where applicable, be free from defects (manifest or latent), in materials and workmanship and remain so for 12 months after Delivery; (d) be free from design defects; (e) comply with all applicable statutory and regulatory requirements relating to the manufacture, labelling, packaging, storage, handling and delivery of the Goods; (f) be supplied in accordance with all applicable legislation in force from time to time; and (g) be destined for supply into, and fully compliant for use in, the United Kingdom (unless specifically stated otherwise in the Specification). 6.2 In supplying the Goods, the Supplier shall co-operate with UKRI in all matters relating to the supply of the Goods and comply with all of UKRI’s instructions. 6.3 The Supplier shall ensure that at all times it has and maintains all the licences, permissions, authorisations, consents and permits that it needs to carry out its obligations under the Agreement. 6.4 UKRI and its representatives shall have the right to inspect and test the Goods at any time before Delivery. 6.5 If following such inspection or testing UKRI considers that the Goods do not conform or are unlikely to comply with the Supplier's undertakings at clause 6.1, UKRI shall inform the Supplier and the Supplier shall immediately take such remedial action as is necessary to ensure compliance. 6.6 Notwithstanding any such inspection or testing, the Supplier shall remain fully responsible for the Goods and any such inspection or testing shall not reduce or otherwise affect the Supplier's obligations under this Agreement, and UKRI shall have the right to conduct further inspections and tests after the Supplier has carried out its remedial actions. 6.7 UKRI’s rights under the Agreement are without prejudice to and in addition to the statutory terms implied in favour of UKRI under the Sale of Goods Act 1979, the Supply of Goods and Services Act 1982 and any other applicable legislation as amended.
Delivery of Equipment (a) We will try to deliver Equipment to you on the delivery date (Delivery Date) and at the address (Site) indicated on your Application during normal business hours in that area. (b) Variations at your request to Delivery Date or Site: (i) are at our discretion; and (ii) may be subject to conditions, including extra Charges.
