Design Approval Procedures for DGCA STC Sample Clauses

Open Split View

Download

Share

Cite

Design Approval Procedures for DGCA STC. (a) DGCA STCs may be issued by the DGCA under the provisions of CAR 21, Subpart E.

Sample 1Sample 2

Save

Copy

Related to Design Approval Procedures for DGCA STC

• Approval Procedure 1. To request approval to receive shared leave hours, an employee or their representative must submit the following documentation to Human Resource Services:

• Required Procurement Procedures for Obtaining Goods and Services The Grantee shall provide maximum open competition when procuring goods and services related to the grant-assisted project in accordance with Section 287.057, Florida Statutes.

• Procedures for LNP Request The Parties shall provide for the requesting of End Office LNP capability on a reciprocal basis through a written request. The Parties acknowledge that Verizon has deployed LNP throughout its network in compliance with FCC 96-286 and other applicable FCC Regulations.

• Approval Process Tenant shall notify Landlord whether it approves of the submitted working drawings within three business days after Landlord’s submission thereof. If Tenant disapproves of such working drawings, then Tenant shall notify Landlord thereof specifying in reasonable detail the reasons for such disapproval, in which case Landlord shall, within five business days after such notice, revise such working drawings in accordance with Tenant’s objections and submit the revised working drawings to Tenant for its review and approval. Tenant shall notify Landlord in writing whether it approves of the resubmitted working drawings within one business day after its receipt thereof. This process shall be repeated until the working drawings have been finally approved by Landlord and Tenant. If Tenant fails to notify Landlord that it disapproves of the initial working drawings within three business days (or, in the case of resubmitted working drawings, within one business day) after the submission thereof, then Tenant shall be deemed to have approved the working drawings in question. Any delay caused by Tenant’s unreasonable withholding of its consent or delay in giving its written approval as to such working drawings shall constitute a Tenant Delay Day (defined below). If the working drawings are not fully approved (or deemed approved) by both Landlord and Tenant by the 15th business day after the delivery of the initial draft thereof to Tenant, then each day after such time period that such working drawings are not fully approved (or deemed approved) by both Landlord and Tenant shall constitute a Tenant Delay Day.

• PROCEDURES FOR CONDUCTING NEGOTIATIONS Either party may request negotiations for a successor Agreement by issuing a notice to negotiate to the other party between one hundred twenty (120) and ninety (90) days prior to the expiration of this Agreement. The State Employment Relations Board will also be notified of the intent to open negotiations at this time. Within fifteen (15) days of receipt of said notice, representatives of the parties shall meet and submit proposals for the successor Agreement. Said proposals shall be comprehensive in nature and no additional issues shall be introduced after the first session without mutual agreement. Subsequent bargaining sessions shall be set at times and dates as are mutually agreed to by the teams. Negotiation teams will be limited to five (5) members each. Both sides may agree to change this size by mutual agreement. Negotiation sessions shall be conducted in executive session; however, this does not prohibit the flow of information to either party’s constituency. The style of bargaining shall be mutually decided by the parties prior to negotiations. Upon request of either bargaining team, a bargaining session may be recessed to permit a caucus. When negotiations are conducted during regular school hours, release time shall be provided for the Association’s bargaining team. (Reference: Article 18) There shall be three (3) signed copies of the final agreement. One (1) copy shall be retained by the Board, one (1) by the Association, and one (1) shall be submitted to the State Employment Relations Board. As tentative agreement is reached on each issue, it shall be so noted and initialed by each party. When consensus is reached covering the areas under discussion, the proposed Agreement shall be reduced to writing as a tentative agreement and submitted to the Association and the Board for approval. Following approval by the Association and Board, a contract shall be entered into by both parties. The Association and the Board agree to abide by the terms of the Agreement. The final Agreement, as adopted by the Board and ratified by the Association, will be printed and presented within thirty (30) days. The cost of such printing, including labor and material shall be borne by the Board In the event an agreement is not reached after forty-five (45) days from the first bargaining session, either of the parties shall have the option of requesting the assistance of a federal mediator under the guidelines of the Federal Mediation and Conciliation Service. In the event that the services of a mediator are called upon, the mediation process will last twenty-one

• Project Delivery Order Procedures The TIPS Member having approved and signed an interlocal agreement, or other TIPS Membership document, may make a request of the awarded vendor under this Agreement when the TIPS Member has services that need to be undertaken. Notification may occur via phone, the web, email, fax, or in person. Upon notification of a pending request, the awarded vendor shall make contact with the TIPS Member as soon as possible, but must make contact with the TIPS Member within two working days. Scheduling of Projects Scheduling of projects (if applicable) may be accomplished when the TIPS Member issues a Purchase Order and/or an Agreement or Contract that will serve as “the notice to proceed” as agreed by the Vendor and the TIPS Member. The period for the delivery order will include the mobilization, materials purchase, installation and delivery, design, weather, and site cleanup and inspection. No additional claims may be made for delays as a result of these items. When the tasks have been completed the awarded vendor shall notify the client and have the TIPS Member or a designated representative of the TIPS Member inspect the work for acceptance under the scope and terms in the Purchase Order and/or Agreement or Contract. The TIPS Member will issue in writing any corrective actions that are required. Upon completion of these items, the TIPS Member will issue a completion notice and final payment will be issued per the contractual requirements of the project with the TIPS Member. Any Construction contract prepared by the TIPS Member’s Legal Counsel may alter the terms of this subsection, “Scheduling of Projects”.

• Change Order Procedure The Agency may at any time request a modification to the Scope of Work using a change order. The following procedures for a change order shall be followed:

• Procurement procedures 11.1 The Recipient must secure the best value for money and shall act in a fair, open and non-discriminatory manner in all purchases of goods and services.

• Procedures for Providing NP Through Full NXX Code Migration Where a Party has activated an entire NXX for a single Customer, or activated at least eighty percent (80%) of an NXX for a single Customer, with the remaining numbers in that NXX either reserved for future use by that Customer or otherwise unused, if such Customer chooses to receive Telephone Exchange Service from the other Party, the first Party shall cooperate with the second Party to have the entire NXX reassigned in the LERG (and associated industry databases, routing tables, etc.) to an End Office operated by the second Party. Such transfer will be accomplished with appropriate coordination between the Parties and subject to appropriate industry lead times for movements of NXXs from one switch to another. Neither Party shall charge the other in connection with this coordinated transfer.

• Procedures for Providing LNP ( “Long-term Number Portability”). The Parties will follow the LNP provisioning process recommended by the North American Numbering Council (NANC) and adopted by the FCC. In addition, the Parties agree to follow the LNP ordering procedures established at the OBF. The Parties shall provide LNP on a reciprocal basis.