DIMENSIONAL STANDARDS. Non-residential Min. Lot size n/a Min. Lot width n/a Maximum FAR 0.25 Max Building Height 45’ Setbacks (Building and Truck Loading Areas) Interior Lot lines 0’ Internal Roads 20’ Palm Coast Parkway 35’ Arbor Trace 25’ Property Line Old Kings Road 35’ Florida Park Drive 35’
DIMENSIONAL STANDARDS. Consistent with BDMC 18.66.020(A) (Exhibit “E”) and RCW 36.70B.170, Condition of Approval No. 144 of the MPD Permit Approval provides that: “Front yard setbacks and other specific lot standards shall be determined as part of the Development Agreement.” This subsection outlines the dimensional standards applicable within the Project Site consistent with the MPD Permit Approval to impose restrictions beyond the City’s applicable code provisions.
DIMENSIONAL STANDARDS. Residential Non-residential Min. Lot size n/a n/a Min. Lot width n/a n/a Impervious Surface Ratio 0.70 n/a Maximum FAR n/a 0.4’ n/a Max Building Height 60’* 45’* Building Setbacks Lot lines Roads Colbert Xxxx Xxxxx Dr. Upland Buffer **** 0’ 20’ 35’*** 25’*** See footnote 0’ 20’ 35’*** 25’*** See footnote * The residential building(s) immediately abutting Blare Drive shall be limited to a maximum building height of 45’. ** Tract 505a: The building height and uses on this tract shall be consistent with the uses previously governed by the Grand Haven PUD, ORB 1010, Page 1293. *** See Landscape buffer requirements, LDC **** Upland Buffer - To ensure minimal impacts to off-site conservation lands, a minimum 25-foot averaged 50-foot upland buffer shall be provided on the western property boundary
DIMENSIONAL STANDARDS. All dimensional standards for each zoning classification as provided in Chapter 3, LDC shall apply, or in the case of a variance, the PLDRB shall resolve. unless otherwise specified in this document.
DIMENSIONAL STANDARDS. TABLE -1 below delineates the minimum residential lot dimensional standards established under the provisions of this Development Agreement: TABLE -1 – Dimensional Standards Minimum Lot Size 8,250 6,600 square feet Minimum Lot Width 75 60 feet (front setback line) Minimum Living Area 1,200 square feet Minimum Front Setback 20 feet Minimum Rear Setback 10 feet Minimum Side Interior Setback 7.5 5 feet Minimum Side Street Setback 15 feet Maximum impervious surface ratio (per lot) 0.75 Maximum Building Height*** 35 feet *** Residences bordering westerly property perimeter shall be limited to one (1) story.
DIMENSIONAL STANDARDS a. LOT SIZE/SET BACKS/HEIGHT:
DIMENSIONAL STANDARDS. The following dimensional standards shall apply in the Xxxxxxx Center Contract Zone:
