Erosion and Sedimentation Sample Clauses

Erosion and Sedimentation. (a) No work shall occur during rain or within 24 hours following any rainfall event of ¼ inch or more of rain in a 24-hour period.
AutoNDA by SimpleDocs
Erosion and Sedimentation. Agreements to study erosion and sedimentation effects from fluctuations in flows as related to hydropower production are addressed in Articles FL3 and FL4 of this agreement.
Erosion and Sedimentation. Excluding Grading activities for agricultural purposes, development disturbing 1 acre or more is subject to the CDPHE National Pollutant Discharge Elimination System Permit, unless otherwise exempted by CDPHE. Noted
Erosion and Sedimentation. The Holder must:
Erosion and Sedimentation control practices will include installation of silt fences, straw wattle, soil stabilization, re-vegetation, and runoff control to limit increases in sediment in storm water runoff, including but not limited to, detention basins, straw xxxxx, silt fences, check-dams, geo-fabrics, drainage xxxxxx, and sand bag dikes.

Related to Erosion and Sedimentation

  • Erosion and Sediment Control The Contractor shall install and maintain erosion and sediment control devices to prevent adjacent streets, storm drains and property from accumulations of soil, sediment, or dust which result from his work. Devices installed to control sediment and prevent erosion shall comply with the requirements of the Georgia Tech Project Superintendent. The Contractor is responsible for monitoring downstream conditions throughout the construction period and clearing any debris, sediment, and dust caused by the progress of the Work. The Contractor shall inspect, maintain, and clear erosion and sediment control devices at least weekly unless otherwise directed by the Georgia Institute of Technology Construction Manager. At the conclusion of the Work, the Contractor shall remove all installed devices and restoring the site to the satisfaction of the Georgia Tech Construction Manager.

  • GEOGRAPHIC AREA AND SECTOR SPECIFIC ALLOWANCES, CONDITIONS AND EXCEPTIONS The following allowances and conditions shall apply where relevant: Where the company does work which falls under the following headings, the company agrees to pay and observe the relevant respective conditions and/or exceptions set out below in each case.

  • Cutting and Patching The Contractor shall be responsible for cutting, fitting or patching required to complete the Work or to make its parts fit together properly.

  • Background Screening and Security 13 These General Contract Conditions supersede and replace in their entirety all General Contract Conditions, Form PUR 1000, which is incorporated by reference in Rule 60A-1.002, Florida Administrative Code (F.A.C.)

  • Indoor Air Quality The Employer shall ensure a healthful air quality and attempt to ensure comfortable air temperature in buildings it owns and in space that it leases.

  • Electronic and Information Resources Accessibility and Security Standards a. Applicability: The following Electronic and Information Resources (“EIR”) requirements apply to the Contract because the Grantee performs services that include EIR that the System Agency's employees are required or permitted to access or members of the public are required or permitted to access. This Section does not apply to incidental uses of EIR in the performance of the Agreement, unless the Parties agree that the EIR will become property of the State of Texas or will be used by HHSC’s clients or recipients after completion of the Agreement. Nothing in this section is intended to prescribe the use of particular designs or technologies or to prevent the use of alternative technologies, provided they result in substantially equivalent or greater access to and use of a Product.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!