Finish Hardware. 8.2.1 Finish hardware is included for hollow metal and wood door hardware sets, using aluminum color, Schlage "D" series.
Finish Hardware finish hardware will comply with all applicable standards, including the quality standards of the DHI;
Finish Hardware. 8.2.1 Finish hardware is included for hollow metal and wood doors, "D" series.
Finish Hardware a. Finish - Brushed stainless steel.
b. Sets:
i. Door at Electrical/Telephone Rooms and Other Miscellaneous Doors: Butts Lock Set Strike Silencers
ii. Doors at Toilet Rooms: Butts Closer Push/Pulls Strike Silencers
Finish Hardware. If Tenant adds additional door(s) other than what is provided in Exhibit C then commercial grade finish hardware, labeled where required, shall be used throughout. All doors shall have wall or floor stops, kick plates, lock sets and push-pull plates as required. All exit doors shall have hardware as required by Code.
Finish Hardware. This Contractor shall furnish, set, install, adjust and protect all Finish Hardware for this Scope of Work. Additionally this Contractor shall also be responsible for the following:
a.) Complete coordination between all hardware, doors, and frames
Finish Hardware. Butt hinges, locksets, lanterns and knobsets shall be as specified by Landlord and shall be purchased by Tenant from Landlord.
Finish Hardware. All interior door hardware shall be Schlage “AL Saturn 605 Polished Brass” series and exterior door shall be Schlage “AL Saturn 626 Bxxx Chrome” series or equal. Locksets are included at suite access doors only.
Finish Hardware. 2.3.1. SUITE ENTRY
a. Manufactures: Ives 3CB Series; Xxxxx XX series, or XxXxxxxx XX series
b. Doors up to 36 inches wide: Standard weight, 4-1/2 inches high
c. Doors over 36 inches wide: Heavy weight, 5 inches high
d. Finish: ANSI A8112 steel with steel pin. Locksets & Security hardware:
a. Passenger Elevator Lobby doors: Electrified door hardware for card reader and electrified door hold open for receipt of TFTI security system.
b. Service Elevator Lobby doors: Electrified door hardware for card reader for receipt of TFTI security system. Closers: LCN 4040XP series or equivalent conforming with ANSI/BHMA A156.4 Grade 1 requirements. Floor stop: IVES FS439, Finish: US26D Satin chrome plated.
Finish Hardware. All door hardware shall be as manufactured by Schlage or an equal commercial grade hardware with its function appropriate for its intended usage.