Shift Trades 6.16.01 Employees may arrange for another employee to work their shift subject to the Manager's approval, consistent with the following: 6.16.01.01 Other than in exceptional circumstances, advice of the trade will be provided to the Manager in writing, in advance, and will be signed by the employees involved. 6.16.01.02 The employee who works a traded shift will be paid for the time worked at his/her rate of pay. 6.16.01.03 Overtime worked prior to or following a traded shift and premium credits on a holiday, in accordance with Article 7.03 and Article 13 respectively, will be credited to the employee who worked the shift as though the shift had been the employee's scheduled shift. 6.16.01.04 All recall credits will be credited to the employee who is recalled. 6.16.01.05 All time debits will be deducted from the employee who agreed to work the shift. 6.16.01.06 Company sick leave provisions will apply to the employee who agreed to work the shift and only to the amount provided for in such regulations. All time not worked in excess of one (1) full shift during a work day shall be debited in accordance with Article 6.16.01.05. 6.16.01.07 Shift trades may only be arranged between employees working in the same location except that, at locations with thirty (30) or less full-time employees, shift trades may be arranged by employees at these locations with employees at other locations within the same base and classification. Such shift trades may be granted subject to the employees concerned being qualified to perform the work function of the other party. 6.16.01.08 An employee's ability to trade shifts is not intended to allow employees to be absent from the work place for extended periods of time nor to take alternate employment. 6.16.01.09 Partial shift trades are permitted provided that no shift is split into more than two (2) parts. No more than two (2) employees may cover a single shift. Partial 6.16.01.10 It will be the sole responsibility of the employees to ensure that the introduction of partial shift trades has absolutely no adverse operational and customer service impact. 6.16.01.11 Under no circumstances shall an employee be allowed to leave his/her assigned duties or work area until their task is completed. His/her “shift trade partner” must be present and ready to take over their next assignment. This transition needs to be seamless to the customer. 6.16.01.12 There will not be additional meal or rest periods assigned to a shift subject to a partial shift trade. Meal and rest periods will be taken as scheduled. 6.16.01.13 A minimum of one (1) hour must be worked by one of the employees involved with a partial shift trade. 6.16.01.14 Any violation of the terms set out herein will result in the immediate suspension of the “partial shift trade privileges” for the employee. Such a measure will be deemed to be of an administrative nature and will not be grievable under any circumstances except as provided below. 6.16.01.15 Notwithstanding the above, the Union may file a grievance only to allege that the violation for which the partial shift trade privileges were revoked did not occur. The Union will bear the onus of the burden of proof in such circumstances. 6.16.01.16 Rules governing such other matters as deadlines for, and approval of, partial shift trade requests will be adopted locally.
Unbundled Sub-Loop Feeder 2.8.4.1 Unbundled Sub-Loop Feeder (USLF) provides connectivity between BellSouth's central office and cross-box (or other access point) that serves an end user location. 2.8.4.2 USLF utilized for voice traffic can be configured as 2-wire voice (USLF-2W/V) or 4-wire voice (USLF-4W/V). 2.8.4.3 USLF utilized for digital traffic can be configured as 2-wire ISDN (USLF-2W/I); 2-wire Copper (USLF-2W/C); 4-wire Copper (USLF-4W/C); 4-wire DS0 level loop (USLF-4W/D0); or 4-wire DS1 and ISDN (USLF-4W/DI). 2.8.4.4 USLF will provide access to both the equipment and the features in the BellSouth central office and BellSouth cross box necessary to provide a 2W or 4W communications pathway from the BellSouth central office to the BellSouth cross- box. This element will allow for the connection of Lightyear’s loop distribution elements onto BellSouth's feeder system.
Unbundled Network Element Combinations 5.1. Unbundled Network Element Combinations shall include: 1) Enhanced Extended Links (EELs); 2) UNE Loops/Special Access Combinations; 3) Loop/Port Combinations; and 4)
Provisional Interconnection Service Upon the request of Interconnection Customer, and prior to completion of requisite Interconnection Facilities, Network Upgrades, Local Upgrades, or system protection facilities Interconnection Customer may request limited Interconnection Service at the discretion of Transmission Provider based upon an evaluation that will consider the results of available studies, which terms shall be memorialized in the Interconnection Service Agreement. Consistent with Tariff, Part VI, Subpart B, section 212.4, Interconnection Customer may execute the Interconnection Service Agreement, request dispute resolution or request that the Interconnection Service Agreement be filed unexecuted with the Commission. Transmission Provider shall determine, through available studies or additional studies as necessary, whether stability, short circuit, thermal, and/or voltage issues would arise if Interconnection Customer interconnects without modifications to the Generating Facility or the Transmission System. Transmission Provider shall determine whether any Interconnection Facilities, Network Upgrades, Local Upgrades, or system protection facilities that are necessary to meet the requirements of NERC, or any applicable Regional Entity for the interconnection of a new, modified and/or expanded Generating Facility are in place prior to the commencement of Interconnection Service from the Generating Facility. Where available studies indicate that such Interconnection Facilities, Network Upgrades, Local Upgrades, and/or system protection facilities that are required for the interconnection of a new, modified and/or expanded Generating Facility are not currently in place, Transmission Provider will perform a study, at the Interconnection Customer’s expense, to confirm the facilities that are required for Provisional Interconnection Service. The maximum permissible output of the Generating Facility shall be studied and updated annually and at the Interconnection Customer’s expense. The results will be communicated to the Interconnection Customer in writing upon completion of the study. Interconnection Customer assumes all risk and liabilities with respect to the Provisional Interconnection Service, including changes in output limits and Interconnection Facilities, Network Upgrades, Local Upgrades, and/or system protection facilities cost responsibilities.
Open Market Transactions We agree to abide by Regulation M under the Exchange Act and we agree not to bid for, purchase, attempt to purchase, or sell, directly or indirectly, any Securities, any other Reference Securities (as defined in Regulation M) of the issuer, or any other securities of such issuer as you may designate, except as brokers pursuant to unsolicited orders and as otherwise provided in this Agreement. If the Securities are common stock or securities convertible into common stock, we agree not to effect, or attempt to induce others to effect, directly or indirectly, any transactions in or relating to any stock of such issuer, except to the extent permitted by Rule 101 of Regulation M under the Exchange Act.
Unbundled Sub Loop shall be equal to or better than each of the applicable requirements set forth in the applicable industry standard technical references.
Transit Traffic 7.2.2.3.1 CenturyLink will accept traffic originated by CLEC’s network and/or its end user(s) for termination to other Telecommunications Carrier’s network and/or its end users that is connected to CenturyLink's Switch. CenturyLink will also terminate traffic from these other Telecommunications Carriers’ network and/or its end users to CLEC’s network and/or its end users. For purposes of the Agreement, transit traffic does not include traffic carried by Interexchange Carriers. That traffic is defined as Jointly Provided Switched Access. 7.2.2.3.2 The Parties involved in transporting transit traffic will deliver calls to each involved network with CCS/SS7 protocol and the appropriate ISUP/TCAP messages to facilitate full Interoperability and Billing functions. 7.2.2.3.3 The originating company is responsible for payment of appropriate rates to the transit company and to the terminating company. The Parties agree to enter into traffic exchange agreements with third party Telecommunications Carriers prior to delivering traffic to be transited to third party Telecommunications Carriers. In the event one Party originates traffic that transits the second Party’s network to reach a third party Telecommunications Carrier with whom the originating Party does not have a traffic exchange agreement, then the originating Party will indemnify, defend and hold harmless the second Party against any and all charges levied by such third party Telecommunications Carrier, including any termination charges related to such traffic and any attorneys fees and expenses. In the case of IntraLATA LEC Toll traffic where CenturyLink is the designated IntraLATA Toll provider for existing LECs, CenturyLink will be responsible for payment of appropriate usage rates. 7.2.2.3.4 When CenturyLink receives an unqueried call from CLEC to a telephone number that has been ported to another local services provider, the transit rate will apply in addition to any query rates. 7.2.2.3.5 In the case of a transit call that terminates in the Local Calling Area but in a different state than the call originated, and the CLEC does not have an agreement with CenturyLink in the state where the transit call terminated, CLEC must execute an agreement for that state if it is a state served by CenturyLink. In the absence of a second agreement, the transit rate in Exhibit A of this Agreement will be billed to the CLEC.
Third Party Products and Services Any third-party hardware, software and/or services that is delivered by ResMed for use either standalone or in conjunction with ResMed products and/or services, shall be subject to the third-party terms and conditions and/or license agreements between Customer and the third party. Such third-party hardware, software and/or services is provided by ResMed "AS IS," without any warranty of any kind. Any representations or warranties as to such hardware, software and/or services shall only be as granted by the applicable third parties, if any, that accompany such products and/or software and/or services. Any representations, warranties, or other similar obligations with respect to such third-party hardware, software and/or services flow directly from the third party to Customer and ResMed shall have no responsibility at all for any such representations, warranties, obligations or lack thereof.
Open Market Purchases Failure of the Contractor to Perform within the time specified in the Contract, or failure to replace rejected or substandard Goods or fulfill unperformed Services when so requested and as the Contract provides or allows, constitutes a breach of the Contract and as a remedy for such breach, such failure shall constitute authority for DAS, if it deems it to be necessary or appropriate in its sole discretion, to Terminate the Contract and/or to purchase on the open market, Goods or Services to replace those which have been rejected, not delivered, or not Performed. The Client Agency shall invoice the Contractor for all such purchases to the extent that they exceed the costs and expenses in Exhibit B and the Contractor shall pay the Client Agency’s invoice immediately after receiving the invoice. If DAS does not Terminate the Contract, the Client Agency will deduct such open market purchases from the Contract quantities. However, if the Client Agency deems it to be in the best interest of the State, the Client Agency may accept and use the Goods or Services delivered which are substandard in quality, subject to an adjustment in price to be determined by the Client Agency.
Unbundled Digital Loops 2.3.1 BellSouth will offer Unbundled Digital Loops (UDL). UDLs are service specific, will be designed, will be provisioned with test points (where appropriate), and will come standard with OC and a DLR. The various UDLs are intended to support a specific digital transmission scheme or service. 2.3.2 BellSouth shall make available the following UDLs, subject to restrictions set forth herein:
