Forecasts and Orders Capacity
Forecasts and Orders Capacity Sample Clauses
Related to Forecasts and Orders Capacity
Forecasts and Orders 2.2.1 On the Effective Date of this Agreement, PURCHASER shall give SELLER written notice of the quantity of Martek Product which PURCHASER estimates in good faith that it will order or direct the Designee(s) to order from SELLER during the remainder of the current calendar year (the “Initial Annual Forecast”). Not later than November 30 of each calendar year during the Term of this Agreement, PURCHASER shall give SELLER written notice of the quantity of Martek Product which PURCHASER estimates in good faith that it will order or direct the Designee(s) to order from SELLER during the next subsequent calendar year (each, an “Annual Forecast”). The Annual Forecast shall be used to establish the per unit and per kilogram pricing for the Martek Products purchased during the relevant calendar year in accordance with Section 2.3.1 and Exhibit A attached hereto; provided that, for the remainder of calendar year 2006, the per kilogram pricing to be used, subject to the year-end adjustment pursuant to Section 2.3.1, shall be * per kilogram, notwithstanding the Initial Annual Forecast. In addition to the foregoing, one (1) month before the commencement of each calendar quarter during the Term of this Agreement, PURCHASER shall provide SELLER with a forecast (a “Rolling Forecast”) of PURCHASER’s requirements for the Martek Product for each of the succeeding four (4) quarters, specifying quantities and requested delivery dates. These forecasts will be PURCHASER’s good-faith, best estimate of requirements and should not be considered a firm commitment. 2.2.2 PURCHASER expressly acknowledges that available supplies of the Martek Product have been in the past, and, may from time to time in the future, be insufficient to meet current demand. Nevertheless, SELLER shall use commercially reasonable efforts to have available for shipment to PURCHASER or to a Designee for PURCHASER’s account such quantities of the Martek Product as PURCHASER forecasts in good faith pursuant to Section 2.2.1 above and any additional quantities which PURCHASER may reasonably request. In case for any reason SELLER cannot or does not supply such quantities of the Martek Products as are forecasted in good faith by PURCHASER pursuant to Section 2.2.1 to PURCHASER, PURCHASER shall be allowed to use an alternative supplier for quantities of Omega-3 and Omega-6 long-chain polyunsaturated fatty acids equal to those quantities of Martek Products that were ordered by PURCHASER pursuant to a Purchase Order and not delivered by SELLER. 2.2.3 PURCHASER shall issue and/or shall direct the Designee(s) to issue formal purchase orders (“Purchase Orders”) at least sixty (60) but no more than ninety (90) days in advance of the date on which PURCHASER or the Designee requests that SELLER ship the Martek Product. SELLER shall accept or reject any such Purchase Order within five (5) business days of receipt, provided that SELLER shall not reject any Purchase Order for any quantities within the most recent forecast. 2.2.4 Purchase Orders which have been accepted by SELLER shall be considered as firm and binding orders (subject to the provisions of Section 2.2.2 above) and shall only be canceled or amended by mutual written agreement of the parties. * CONFIDENTIAL TREATMENT REQUESTED. CONFIDENTIAL PORTION HAS BEEN FILED SEPARATELY WITH THE SECURITIES AND EXCHANGE COMMISSION.
Trunk Group Connections and Ordering 5.2.1 For both One-Way and Two-Way Interconnection Trunks, if Onvoy wishes to use a technically feasible interface other than a DS1 or a DS3 facility at the POI, the Parties shall negotiate reasonable terms and conditions (including, without limitation, rates and implementation timeframes) for such arrangement; and, if the Parties cannot agree to such terms and conditions (including, without limitation, rates and implementation timeframes), either Party may utilize the Agreement’s dispute resolution procedures. 5.2.2 When One-Way or Two-Way Interconnection Trunks are provisioned using a DS3 interface facility, if Onvoy orders the multiplexed DS3 facilities to a Frontier Central Office that is not designated in the NECA 4 Tariff as the appropriate Intermediate Hub location (i.e., the Intermediate Hub location in the appropriate Tandem subtending area based on the LERG), and the provision of such facilities to the subject Central Office is technically feasible, the Parties shall negotiate in good faith reasonable terms and conditions (including, without limitation, rates and implementation timeframes) for such arrangement; and, if the Parties cannot agree to such terms and conditions (including, without limitation, rates and implementation timeframes), either Party may utilize the Agreement’s dispute resolution procedures. 5.2.3 Each Party will identify its Carrier Identification Code, a three or four digit numeric code obtained from Telcordia, to the other Party when ordering a trunk group. 5.2.4 For multi-frequency (MF) signaling each Party will out pulse ten (10) digits to the other Party, unless the Parties mutually agree otherwise. 5.2.5 Each Party will use commercially reasonable efforts to monitor trunk groups under its control and to augment those groups using generally accepted trunk- engineering standards so as to not exceed blocking objectives. Each Party agrees to use modular trunk-engineering techniques for trunks subject to this Attachment.
Contract Capacity The electric power producing capability of the Generating Facility which is committed to Edison.
FREQUENCY AND CAPACITY LEVELS No restriction on frequency, capacity or aircraft type.
Local Circuit Switching Capability, including Tandem Switching Capability 4.1.3.1 Definition 4.1.3.2 Notwithstanding BellSouth’s general duty to unbundle local circuit switching, BellSouth shall not be required to unbundle local circuit switching for <<customer_name>> when <<customer_name>> serves end-users with four (4) or more voice-grade (DS-0) equivalents or lines in locations served by BellSouth’s local circuit switches, which are in the following MSAs: Atlanta, GA; Miami, FL; Orlando, FL; Ft. Lauderdale, FL; Charlotte-Gastonia-Rock Hill, NC; Greensboro-Winston Salem-High Point, NC; Nashville, TN; and New Orleans, LA, and BellSouth has provided non-discriminatory cost based access to the Enhanced Extended Link (EEL) throughout Density Zone 1 as determined by NECA Tariff No. 4 as in effect on January 1, 1999. 4.1.3.3 In the event that <<customer_name>> orders local circuit switching for a single end user account name at a single physical end user location with four (4) or more 2-wire voice-grade loops from a BellSouth central office in an MSA listed above, BellSouth shall charge <<customer_name>> the market based rate in Exhibit C for use of the local circuit switching functionality for the affected facilities. 4.1.3.4 A featureless port is one that has a line port, switching facilities, and an interoffice port. A featured port is a port that includes all features then capable or a number of then capable features specifically requested by <<customer_name>>. Any features that are not currently then capable but are technically feasible through the switch can be requested through the NBR/BFR process. 4.1.3.5 BellSouth will provide to <<customer_name>> customized routing of calls: (i) to a requested directory assistance services platform; (ii) to an operator services platform pursuant to Section 10 of Attachment 2; (iii) for <<customer_name>>’s PIC’ed toll traffic in a two (2) PIC environment to an alternative OS/DA platform designated by <<customer_name>>. <<customer_name>> customers may use the same dialing arrangements as BellSouth customers. 4.1.3.6 Remote Switching Module functionality is included in Switching Capability. The switching capabilities used will be based on the line side features they support. 4.1.3.7 Switching Capability will also be capable of routing local, intraLATA, interLATA, and calls to international customer’s preferred carrier; call features (e.g. call forwarding) and Centrex capabilities. 4.1.3.8 Where required to do so in order to comply with an effective Commission order, BellSouth will provide to <<customer_name>> purchasing local BellSouth switching and reselling BellSouth local exchange service under Attachment 1, selective routing of calls to a requested directory assistance services platform or operator services platform. <<customer_name>> customers may use the same dialing arrangements as BellSouth customers, but obtain a <<customer_name>> branded service.
Quality Specifications SANMINA-SCI shall comply with the quality specifications set forth in its Quality Manual, incorporated by reference herein, a copy of which is available from SANMINA-SCI upon request.
Scope and Order Placement These terms may be used by Customer either for a single Order or as a framework for multiple Orders. In addition, these terms may be used on a global basis by the parties’ “Affiliates”, meaning any entity controlled by, controlling, or under common control with a party. The parties can confirm their agreement to these terms either by signature where indicated at the end or by referencing these terms on Orders. Affiliates participate under these terms by placing orders which specify product or service delivery in the same country as the HP Affiliate accepting the Order, referencing these terms, and specifying any additional terms or amendments to reflect local law or business practices.
Independent Capacity of Contractor The Contractor and Contractor Parties shall act in an independent capacity and not as officers or employees of the state of Connecticut or of the Agency.
SLEEPING CAPACITY/DISTURBANCES Tenant and all other occupants will be required to vacate the premises and forfeit the rental fee and security deposit for any of the following: Occupancy exceeding the sleeping capacity, using the premises for any illegal activity, causing damage to the premises rented or to any of the neighboring properties and any other acts which interfere with neighbors' right to quiet enjoyment of their premises. iTrip or the Owner, does not assume any liability for loss, damage or injury to persons or their personal property. Neither does the owner accept any liability for any inconveniences, damage, loss or injury arising from any temporary defects or stoppage in supply of water, gas, cable service, electricity or plumbing, as well as due to weather conditions, natural disasters, acts of God, or other reasons beyond its control. Tenant hereby acknowledges that the premises they have reserved may include a pool and the undersigned agrees and acknowledges that the pool and patio/deck can be dangerous areas, that the deck/patio can be slippery when wet, and that injury may occur to anyone who is not careful. With full knowledge of the above facts and warnings, the undersigned Tenant accepts and assumes all risks involved to Tenant and all of Tenant's guests in or related to the use of the community pool and patio areas.
INDEPENDENT CAPACITY OF THE CONTRACTOR The parties intend that an independent contractor relationship will be created by this contract. The CONTRACTOR and his or her employees or agents performing under this contract are not employees or agents of the AGENCY. The CONTRACTOR will not hold himself/herself out as or claim to be an officer or employee of the AGENCY or of the State of Washington by reason hereof, nor will the CONTRACTOR make any claim of right, privilege or benefit that would accrue to such employee under law. Conduct and control of the work will be solely with the CONTRACTOR.
