Operating Standards (A) Distributor and its Dealer(s) shall conduct the operation of their respective businesses related to the resale of the Product(s) in a clean and safe manner and shall otherwise conduct no business which could interfere with the sale of Product(s) or damage the goodwill of the Valero brand or the Marks. Without limiting the foregoing, Distributor and its Dealer(s) shall, at all times during the term of this Agreement, fully comply with VMSC’s then current “Basic Operational Requirements” which Distributor acknowledges have been received and reviewed by Distributor. Furthermore, without limiting any provision to the contrary herein, Distributor and its Dealer(s) shall fully comply with VMSC’s “Commitment to Excellence Requirements”, which Distributor acknowledges have been received and reviewed by Distributor. As of the Commencement Date, Distributor and its Dealer(s) agree to participate in the Commitment to Excellence Program (“CTE Program”). The CTE Program provides that each Station meets the established Commitment to Excellence Requirements which consists of requirements from each of the following VMSC documents: VMSC’s Basic Image Requirements, Wholesale Branding Manual, and Basic Operational Requirements. VMSC reserves the right to amend, change, or otherwise modify the “Basic Operational Requirements”, “Commitment to Excellence Requirements” and the “CTE Program” from time to time, in VMSC’s sole and absolute discretion.
(B) Distributor and its Dealer(s) shall comply with all Laws of any governing authority or agency having jurisdiction or purporting to have jurisdiction relating to the handling, storage, testing, sale, distribution, transportation, and/or use of the Product(s) and shall further comply with all rules, guidelines, and procedures of VMSC in connection with the loading, transportation, handling, storing, testing, selling, dispensing, and/or use of the Product(s).
(C) Subject to Paragraph 12 of this Agreement, Distributor and its Dealer(s) shall continuously offer at least three grades of “Valero” branded gasoline at each Station.
(D) Distributor and its Dealer(s) will utilize and maintain updated point of sale systems as required by VMSC. VMSC also reserves the right to install, and Distributor and its Dealer(s) agree to utilize, update and maintain, other automated systems, at Distributor’s cost, as required by VMSC, including but not limited, such systems necessary to poll, at frequencies determined by VMSC, each Station’s Product sales.
(E) VMSC may inspect or review compliance by Distributor and its Dealer(s) with the requirements of this Paragraph 8 in any reasonable manner that VMSC determines, including, but not limited to, announced and unannounced visits.
(F) Distributor expressly understands and agrees that a confidential relationship is established between VMSC and Distributor under this Agreement and that, as a result thereof, VMSC will be disclosing and transmitting to Distributor certain confidential and proprietary information in connection with the Distributor’s operation of the Station. Distributor hereby agrees that Distributor shall not, during the term of this Agreement or thereafter, communicate, divulge or use for the benefit of any other person, persons, partnership, association or corporation and, following the expiration or termination of this Agreement, shall not use for the benefit of Distributor, or any of its principals, any confidential information, knowledge or know-how concerning the methods of operation (including pricing) of the Station which may be communicated to Distributor or its principals or of which they may be apprised in connection with the operation of the Station(s) under the terms of this Agreement. Distributor shall divulge such confidential information only to such of Distributor’s employees as must have access to it in order to operate the Station(s). Any and all information, knowledge, know-how, techniques and any materials used in or related to the Station which VMSC provides to Distributor in connection with this Agreement shall be deemed confidential for purposes of this Agreement. Such confidential information does not include information that, at the time it was disclosed to or learned by Distributor, was part of the public domain, nor information that, after the time it was disclosed to or learned by Distributor, became part of the public domain through disclosure, publication or communication by persons other than Distributor or its employees. Distributor shall not at any time, without VMSC’s prior written consent, copy, duplicate, record or otherwise reproduce such materials or information, in whole or in part, nor otherwise make the same available to any unauthorized person.
(G) Distributor acknowledges that strict compliance with the terms and conditions of this Paragraph 8 is a material and important part of the consideration for this Agreement.
Licensing Standards The Contractor, its employees and subcontractors shall comply with all applicable licensing standards, certification standards, accrediting standards and any other laws, rules, or regulations governing services to be provided by the Contractor pursuant to this Contract. The State will not pay the Contractor for any services performed when the Contractor, its employees or subcontractors are not in compliance with such applicable standards, laws, rules, or regulations. If any license, certification or accreditation expires or is revoked, or any disciplinary action is taken against an applicable license, certification, or accreditation, the Contractor shall notify the State immediately and the State, at its option, may immediately terminate this Contract.
Accounting Standards The Subrecipient agrees to comply with 2 CFR 200 and agrees to adhere to the accounting principles and procedures required therein, utilize adequate internal controls, and maintain necessary source documentation for all costs incurred.
Manufacturing Standards All forest products except poles, produced and sold under this contract will be manufactured to maximize the amount of logs meeting preferred log lengths and to achieve the average log length listed. 97318 3 WS "WS" indicates that west side scaling rules apply. Minimum trim is 8 inches per scaling segment for west side scaling rules. "ES" indicates that east side scaling rules apply. Minimum trim is 4 inches per scaling segment for east side scaling rules. Poles produced under this contract will be manufactured to ANSI specifications (American National Standard Specifications and Dimensions for Wood Poles), in force at the time of signing this contract.
a. Sweep will be limited to within the bole of the log as measured using a tape stretched between the centers of each end of the log.
b. Logs approved by the state for peelers shall be chuckable with no more than a 2 inch diameter area of rot within a 5 inch diameter circle located at the center of either end of the log.
c. Limbs and knots shall be cut flush, with no more than 15 percent of a log having limbs or knots over 2 inches in diameter extending more than 2 inches above the surface of the log.
Codification Section was enacted as part of the Water Resources Development Act of 1986, and not as part of the Water Resources Planning Act which comprises this chapter.
OMB Standards Unless specified otherwise within this agreement, the Subrecipient shall procure all materials, property, or services in accordance with the requirements of 24 CFR 84.40−48.
Technical Standards The Generation System shall be installed and operated by the Interconnection Customer consistent with the requirements of this Agreement; the Technical Requirements; the applicable requirements located in the National Electrical Code (NEC); the applicable standards published by the American National Standards Institute (ANSI) and the Institute of Electrical and Electronic Engineers (IEEE); and local building and other applicable ordinances in effect at the time of the installation of the Generation System.
General Standards An Assistant Professor will be competent to teach in a particular field, will be current in the literature of that field, and will seek to meet student needs in both the classroom and in non-classroom environments. However, an Assistant may be a junior member of the academic community, with little professional and/or teaching experience. Furthermore, an Assistant may have little experience in curriculum development, committee work, governance, professional and/or community service, etc. In short, an Assistant Professor generally will be new to tenure-track college teaching. For eligibility for promotion from Assistant to Associate Professor, the candidate must have served a minimum of four (4) years at the rank of Assistant Professor, and must show evidence that he/she has grown professionally and consistently has sought to meet student needs, in both the classroom and in non-classroom environments. A successful candidate for the rank of Associate Professor will have remained current in the field, and will have improved his/her teaching in some demonstrable way. He/she also will have demonstrated professional growth in one or more of the following ways: completion of additional appropriate course work (if applicable), attendance at professional conferences, service on campus and/or District committees, professional and/or community service, or, the production of some creative work. Evidence of professional growth will be drawn from a careful analysis of student evaluations and peer evaluations over a period of time, and from a critical reading of materials submitted by the candidate. For promotion from Associate to Professor, the candidate must have served a minimum of four (4) years at the rank of Associate Professor, and must show evidence that he/she has grown professionally to a point where he/she has mastered both a particular field of knowledge and the teaching of that knowledge. A successful candidate must show evidence that he/she consistently has sought to meet student needs, in both the classroom and non-classroom environments. A Professor should be a senior member of the faculty, one who has such substantial experience, knowledge, and skill that he/she could mentor junior faculty in his/her area of expertise. A Professor will have demonstrated all the same kinds of achievements and attributes necessary for promotion to the Associate Professor rank, but in addition will demonstrate that he/she is a leader in some appropriate sense. Evidence of professional growth and leadership will be drawn from a careful analysis of student evaluations and peer evaluations over a period of time, and from a critical reading of materials submitted by the candidate.
Professional Standards The Contractor agrees to maintain the professional standards applicable to its profession and to Contractors doing business in the United States Virgin Islands.
Content Standards You agree that you will not upload or provide content or otherwise post, transmit, distribute, or disseminate through the Zelle® Payment Service any material that: (1) is false, misleading, unlawful, obscene, indecent, lewd, pornographic, defamatory, libelous, threatening, harassing, hateful, abusive, or inflammatory; (2) encourages conduct that would be considered a criminal offense or gives rise to civil liability; (3) breaches or infringes any duty toward or rights of any person or entity, including rights of publicity, privacy or intellectual property; (4) contains corrupted data or any other harmful, disruptive, or destructive files; (5) advertises products or services competitive with Zelle®, as determined by Zelle® in its sole discretion; or (6) in Zelle®’s or our sole judgment, is objectionable, restricts or inhibits any person or entity from using or enjoying any portion of the Zelle® Payment Service, or which may expose us, Zelle® or our respective affiliates or customers to harm or liability of any nature.
