Front End Loader Sample Clauses

Front End Loader. The cost of permits or licences required to drive a front end loader will be paid by the Company.
Sample 1Sample 2Sample 3
AutoNDA by SimpleDocs
Front End Loader. Supply a high performance 250 HP front end loader with bucket capacity of at least 2 CUM.
Sample 1Sample 2
Front End Loader. When a Heavy Equipment Operator (HEO) is not available, due to operational need to load trucks in Streets Operations yards and a Street Maintenance Worker, Grounds Maintenance Worker, or Equipment Operator, who is qualified, is assigned to load their truck with a front end loader, with approval of management, they will be set-up to HEO pay. The upgrade will be paid for a minimum of one (1) hour; thereafter, actual pay will be in one- tenth (1/10) hour increments. If a qualified Street Maintenance Worker, Grounds Maintenance Worker, or Equipment Operator, is assigned to load their truck with a front end loader at the Asphalt Plant, with approval of management, they will be set-up to Asphalt Plant Operator (APO) pay. The upgrade will be paid for a minimum of one (1) hour; thereafter, actual pay will be in one-tenth (1/10) hour increments.
Sample 1Sample 2
Front End Loader. (FEL) Run Of Mine (ROM) Operation
Sample 1
Front End Loader. The candidate will demonstrate their ability to properly load a dump truck. They will be judged on how they place the truck, how they enter the stockpile, the angle of their bucket, whether they spin the loader tires, how full the bucket is, and how the load looks when they are finished loading.
Sample 1
Front End Loader. Employees holding a license or recognised Verification of Competence (VOC) and is directed by Xxxxxx to operate a Front End Loader (FEL) to load tippers or to batch concrete via the weigh xxxxxx, will be paid an allowance of $40.74 per week for any week or part thereof they have used the Front End Loader. The allowance rate in this clause is effective from 1 January 2024 and shall increase in accordance with the percentage wage increases in clause 14.1.
Sample 1
Front End Loader. All work associated with the operation of front end loading within a worksite and including general duties.
Sample 1
AutoNDA by SimpleDocs
Front End Loader. Supply a high performance 250 HP front end loader with bucket capacity of at least 2 CUM. Hour 19 Batch Machin (Concrate Mixer) 200 liters: Supply a high performance one bag tilting drum concrete mixer with driver (operator) to the construction site, according to the specification and complete satisfaction of the office engineer. Day 20 Excavator Works for Excavation and Back filling Hour Pamir Handpump SN Unit Item Name Specs Photo 1 pcs (Pamir Handpump) T-bar handle Stronger Heavy-Duty Handle, Includes Ball Bearing with different pints and hosting to be used in this handpump part instead of plating bearings. With Adjustable nut to allow the adjustment with desirable handle length. With minimum stroke length 225mm. 2 pcs (Pamir handpump) Long pedestal Pedestal, long, 16kg 3 pcs (Pamir handpump) pump rod , 2.9m long 2.9m Long- SS Connecting Rod Diameter 10mm, Double Hook 4 pcs (Pamir handpump) Pump head with cover Pump Head (Cover),19- 21kg, handpump 5 pcs (Pamir handpump) uPVC pressure pipe, Rising main. uPVC pressure pipe, 63mm diameter (OD), 4.7mm thick wall, to glue, 2.9m long 6 pcs (Pamir handpump) Cone plate, steel cone Thickness 3 mm 7 pcs Pamir handpump) Hex nut, Hex bolt, Flat washer Pamir handpump) Hex nut M16, Hex bolt M16 x 40mm long, Flat washer M16 8 pcs (Pamir handpump) Cylinder assembly containing cylinder, foot valve, rod and plunger. Complete ss, length,970 mm thickness,6mm 9 pcs (Pamir handpump) Pipe Centralizer Internal Dia 62 mm thickness 22 mm 10 pcs (Pamir handpump) Rod centralizer Slot length 29.5-30.5 mm O.D47.8-48.5 mm 11 pcs (Pamir handpump) Rubber cone Dia 62 mm 12 Roll Rope Rope, polypropylene, 10mm thickness, roll of 200m 13 pcs PVC Glue Weld-On PVC Glue, 470ml, for PVC pipe, “Weld-on 717 PVC” minimum 2 year expiry 14 pcs (Pamir handpump) Rubber flapper Thickness 6mm dia,97 mm hole dia 10 mm
Sample 1

Related to Front End Loader

  • Terminal Receipt You can get a receipt at the time you make any transaction (except inquiries) involving your account using an ATM and/or point-of-sale (POS) terminal.

  • Unbundled Sub-Loop Feeder 2.8.4.1 Unbundled Sub-Loop Feeder (USLF) provides connectivity between BellSouth's central office and cross-box (or other access point) that serves an end user location. 2.8.4.2 USLF utilized for voice traffic can be configured as 2-wire voice (USLF-2W/V) or 4-wire voice (USLF-4W/V). 2.8.4.3 USLF utilized for digital traffic can be configured as 2-wire ISDN (USLF-2W/I); 2-wire Copper (USLF-2W/C); 4-wire Copper (USLF-4W/C); 4-wire DS0 level loop (USLF-4W/D0); or 4-wire DS1 and ISDN (USLF-4W/DI). 2.8.4.4 USLF will provide access to both the equipment and the features in the BellSouth central office and BellSouth cross box necessary to provide a 2W or 4W communications pathway from the BellSouth central office to the BellSouth cross- box. This element will allow for the connection of Lightyear’s loop distribution elements onto BellSouth's feeder system.

  • Interconnection Customer Obligations The Interconnection Customer shall maintain the Large Generating Facility and the Interconnection Customer’s Interconnection Facilities in a safe and reliable manner and in accordance with this LGIA.

  • Dark Fiber Loop 2.8.4.1 Dark Fiber Loop is an unused optical transmission facility, without attached signal regeneration, multiplexing, aggregation or other electronics, from the demarcation point at an End User’s premises to the End User’s serving wire center. Dark Fiber Loops may be strands of optical fiber existing in aerial or underground structure. BellSouth will not provide line terminating elements, regeneration or other electronics necessary for AFN to utilize Dark Fiber Loops.

  • Traffic Measurement and Billing over Interconnection Trunks 6.1 For billing purposes, each Party shall pass Calling Party Number (CPN) information on at least ninety-five percent (95%) of calls carried over the Interconnection Trunks. 6.1.1 As used in this Section 6, “Traffic Rate” means the applicable Reciprocal Compensation Traffic rate, Measured Internet Traffic rate, intrastate Switched Exchange Access Service rate, interstate Switched Exchange Access Service rate, or intrastate/interstate Tandem Transit Traffic rate, as provided in the Pricing Attachment, an applicable Tariff, or, for Measured Internet Traffic, the FCC Internet Order. 6.1.2 If the originating Party passes CPN on ninety-five percent (95%) or more of its calls, the receiving Party shall xxxx the originating Party the Traffic Rate applicable to each relevant minute of traffic for which CPN is passed. For any remaining (up to 5%) calls without CPN information, the receiving Party shall xxxx the originating Party for such traffic at the Traffic Rate applicable to each relevant minute of traffic, in direct proportion to the minutes of use of calls passed with CPN information. 6.1.3 If the originating Party passes CPN on less than ninety-five percent (95%) of its calls and the originating Party chooses to combine Reciprocal Compensation Traffic and Toll Traffic on the same trunk group, the receiving Party shall xxxx the higher of its interstate Switched Exchange Access Service rates or its intrastate Switched Exchange Access Services rates for all traffic that is passed without CPN, unless the Parties agree that other rates should apply to such traffic. 6.2 At such time as a receiving Party has the capability, on an automated basis, to use such CPN to classify traffic delivered over Interconnection Trunks by the other Party by Traffic Rate type (e.g., Reciprocal Compensation Traffic/Measured Internet Traffic, intrastate Switched Exchange Access Service, interstate Switched Exchange Access Service, or intrastate/interstate Tandem Transit Traffic), such receiving Party shall xxxx the originating Party the Traffic Rate applicable to each relevant minute of traffic for which CPN is passed. If the receiving Party lacks the capability, on an automated basis, to use CPN information on an automated basis to classify traffic delivered by the other Party by Traffic Rate type, the originating Party will supply Traffic Factor 1 and Traffic Factor

  • Dark Fiber Transport Dark Fiber Transport is defined as Dedicated Transport that consists of unactivated optical interoffice transmission facilities without attached signal regeneration, multiplexing, aggregation or other electronics. Except as set forth in Section 6.9.1 below, BellSouth shall not be required to provide access to Dark Fiber Transport Entrance Facilities pursuant to this Agreement.

  • Cost Responsibility for Interconnection Facilities and Distribution Upgrades 4.1 Interconnection Facilities 4.2 Distribution Upgrades

  • Pipelines Developer shall have no interest in the pipeline gathering system, which gathering system shall remain the sole property of Operator or its Affiliates and shall be maintained at their sole cost and expense.

  • Interconnection Customer Provided Services The services provided by Interconnection Customer under this LGIA are set forth in Article 9.6 and Article 13.5. 1. Interconnection Customer shall be paid for such services in accordance with Article 11.6.

  • Agreement with Respect to Leased Data Processing Equipment (a) The Receiver hereby grants to the Assuming Bank an exclusive option for the period of ninety (90) days commencing the day after Bank Closing to accept an assignment from the Receiver of any or all Data Processing Leases to the extent that such Data Processing Leases can be assigned. (b) The Assuming Bank shall (i) give written notice to the Receiver within the option period specified in Section 4.7(a) of its intent to accept or decline an assignment or sublease of any or all Data Processing Leases and promptly accept an assignment or sublease of such Data Processing Leases, and (ii) give written notice to the appropriate lessor(s) that it has accepted an assignment or sublease of any such Data Processing Leases. (c) The Receiver agrees to facilitate the assignment or sublease of Data Processing Leases or the negotiation of new leases or license agreements by the Assuming Bank; provided, that neither the Receiver nor the Corporation shall be obligated to engage in litigation or make payments to the Assuming Bank or to any third party in connection with facilitating any such assumption, assignment, sublease or negotiation. (d) The Assuming Bank agrees, during its period of use of any property subject to a Data Processing Lease, to pay to the Receiver or to appropriate third parties at the direction of the Receiver all operating costs with respect thereto and to comply with all relevant terms of the applicable Data Processing Leases entered into by the Failed Bank, including without limitation the timely payment of all rent, taxes, fees, charges, utilities, insurance and assessments. (e) The Assuming Bank shall, not later than fifty (50) days after giving the notice provided in Section 4.7(b), (i) relinquish and release to the Receiver all property subject to the relevant Data Processing Lease, in the same condition as at Bank Closing, normal wear and tear excepted, or (ii) accept an assignment or a sublease thereof or negotiate a new lease or license agreement under this Section 4.7.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!