Fusion safety characteristics Sample Clauses

Fusion safety characteristics. This section offers a brief overview of the safety and environmental characteristics of fusion power, for the reader’s general orientation, before the report goes into more detail. Fusion potentially offers the following three areas of safety and environmental advantage. • No climate-changing emissions The operation of a fusion power station does not involve the discharge of “greenhouse gases” to the atmosphere. There would also be no acidic emissions. The fabrication of the components of a fusion power station, as with most industrial processes, might involve some greenhouse gas production. • Low consequences of worst-case accidents This potential feature stems from some key favourable safety characteristics of fusion, which constitute qualitative differences from fission: - Power excursions of the plasma are self-limited by inherent processes. - Continuous operation of the power station is maintained by continual refuelling with the fuel mixture (deuterium and tritium), so the fuel inventory in the plasma chamber at any time is sufficient only for about one minute of operation. - Power densities are moderate in normal operation and very small after burn termination (“low decay heat”). • No waste management burden on future generations This potential feature arises because the activated material produced by the operation of fusion power stations is quite unlike the actinides or fission products present in the waste from fission power reactors: its radiotoxicity decays much more rapidly than in the fission case, and can be further minimised by appropriate choice of materials for the power plant components. The first of the above advantages is a generic feature of fusion. The SEAFP studies have shown that the full expression of the second and third safety and environmental advantages results from the conjunction of generic features of fusion with appropriate design choices, especially materials development and selection and confinement system concepts.
Sample 1
AutoNDA by SimpleDocs

Related to Fusion safety characteristics

  • ODUF Physical File Characteristics 6.2.1 ODUF will be distributed to TWTC via Secure File Transfer Protocol (FTP). The ODUF feed will be a variable block format. The data on the ODUF feed will be in a non-compacted EMI format (175 byte format plus modules). It will be created on a daily basis Monday through Friday except holidays. Details such as dataset name and delivery schedule will be addressed during negotiations of the distribution medium. There will be a maximum of one dataset per workday per OCN. If AT&T determines the Secure FTP Mailbox is nearing capacity levels, AT&T may move the customer to CONNECT: Direct file delivery. 6.2.2 If the customer is moved, CONNECT: Direct data circuits (private line or dial-up) will be required between AT&T and TWTC for the purpose of data transmission. Where a dedicated line is required, TWTC will be responsible for ordering the circuit, overseeing its installation and coordinating the installation with AT&T. TWTC will also be responsible for any charges associated with this line. Equipment required on the AT&T end to attach the line to the mainframe computer and to transmit messages successfully on an ongoing basis will be negotiated on an individual case basis. Any costs incurred for such equipment will be TWTC's responsibility. Where a dial-up facility is required, dial circuits will be installed in the AT&T data center by AT&T and the associated charges assessed to TWTC. Additionally, all message toll charges associated with the use of the dial circuit by TWTC will be the responsibility of TWTC. Associated equipment on the AT&T end, including a modem, will be negotiated on an individual case basis between the Parties. All equipment, including modems and software, that is required on TWTC end for the purpose of data transmission will be the responsibility of TWTC. 6.2.3 If TWTC utilizes FTP for data file transmission, purchase of the FTP software will be the responsibility of TWTC.

  • Characteristics The Contracts have the following characteristics: (i) all the Contracts are secured by Motorcycles; (ii) no Contract has a remaining maturity of more than 84 months; and (iii) the final scheduled payment on the Contract with the latest maturity is due no later than July 27, 2030. Approximately 63.90% of the Pool Balance as of the Cutoff Date is attributable to loans for purchases of new Motorcycles and approximately 36.10% is attributable to loans for purchases of used Motorcycles. No Contract was originated after the Cutoff Date. No Contract has a Contract Rate less than 0.010%.

  • Pool Characteristics The Mortgage Loans in the related Mortgage Loan Package have the characteristics as set forth on Exhibit 2 to the related Assignment and Conveyance.

  • Physical File Characteristics 7.2.1 The EODUF feed will be distributed to Comcast Phone over their existing Optional Daily Usage File (ODUF) feed. The EODUF messages will be intermingled among Comcast Phone’s Optional Daily Usage File (ODUF) messages. The EODUF will be a variable block format (2476) with an LRECL of 2472. The data on the EODUF will be in a non-compacted EMI format (175 byte format plus modules). It will be created on a daily basis (Monday through Friday except holidays). 7.2.2 Data circuits (private line or dial-up) may be required between BellSouth and Comcast Phone for the purpose of data transmission. Where a dedicated line is required, Comcast Phone will be responsible for ordering the circuit, overseeing its installation and coordinating the installation with BellSouth. Comcast Phone will also be responsible for any charges associated with this line. Equipment required on the BellSouth end to attach the line to the mainframe computer and to transmit successfully ongoing will be negotiated on an individual case basis. Where a dial-up facility is required, dial circuits will be installed in the BellSouth data center by BellSouth and the associated charges assessed to Comcast Phone. Additionally, all message toll charges associated with the use of the dial circuit by Comcast Phone will be the responsibility of Comcast Phone. Associated equipment on the BellSouth end, including a modem, will be negotiated on an individual case basis between the Parties. Version 4Q01 12/01/01 All equipment, including modems and software, that is required on Comcast Phone’s end for the purpose of data transmission will be the responsibility of Comcast Phone.

  • Mortgage Loan Characteristics The characteristics of the related Mortgage Loan Package are as set forth on the description of the pool characteristics for the applicable Mortgage Loan Package delivered pursuant to Section 11 on the related Closing Date in the form attached as Exhibit B to each related Assignment and Conveyance Agreement;

  • Substance Abuse Treatment Information Substance abuse treatment information shall be maintained in compliance with 42 C.F.R. Part 2 if the Party or subcontractor(s) are Part 2 covered programs, or if substance abuse treatment information is received from a Part 2 covered program by the Party or subcontractor(s).

  • Reactive Power and Primary Frequency Response 9.6.1 Power Factor Design Criteria

  • Individual Characteristics Each Receivable has the following individual characteristics as of the Cut-Off Date: (i) each Receivable is secured by a new or used automobile, minivan or sport utility vehicle; (ii) each Receivable has an APR of no less than 0.00% and not more than 13.94; (iii) each Receivable had an original term to maturity of not more than 72 months and not less than 18 months and each Receivable has a remaining term to maturity, as of the Cut-Off Date, of 12 months or more; (iv) each Receivable has an Outstanding Principal Balance as of the Cut-Off Date of greater than or equal to $2,394.67; (v) no Receivable has a scheduled maturity date later than October 7, 2020; (vi) no Receivable was more than 30 days past due as of the Cut-Off Date; (vii) as of the Cut-off Date, no Receivable was noted in the records of VCI or the Servicer as being the subject of any pending bankruptcy or insolvency proceeding; (viii) no Receivable is subject to a force-placed Insurance Policy on the related Financed Vehicle; (ix) each Receivable is a Simple Interest Receivable; (x) each of the Receivables were selected using selection procedures that were not known or intended by VCI or the Servicer to be adverse to the Purchaser; and (xi) the Dealer of the Financed Vehicle has no participation in, or other right to receive, any proceeds of such Receivable.

  • Substance Abuse Testing The Parties agree that it is in the best interest of all concerned to promote a safe working environment. The Union has no objection to pre-employment substance abuse testing when required by the Employer and further, the Union has no objection to voluntary substance abuse testing to qualify for employment on projects when required by a project owner. The cost and scheduling of such testing shall be paid for and arranged by the Employer. The Union agrees to reimburse the Employer for any failed pre-access Alcohol and Drug test costs.

  • Statistical Sampling Documentation a. A copy of the printout of the random numbers generated by the “Random Numbers” function of the statistical sampling software used by the IRO.‌ b. A description or identification of the statistical sampling software package used by the IRO.‌

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!