High temperature operation Sample Clauses

High temperature operation. The equipment has been heat soaked at +50 degrees C on Magtec’s test rigs and all control and I/O functions have been maintained. The equipment has been started at full command after soaking at +50 degrees C on Magtec’s test rigs and operated as designed with the output power and torque being de-rated as expected. The equipment has been operated on Smiths vehicles at high ambient temperatures until the equipment has reached its thermal limits and has de-rated its power and torque in a controlled manner.
Sample 1Sample 2
AutoNDA by SimpleDocs
High temperature operation. The Wildcat tablet BIOS shall monitor the critical components identified in section 2.6.1.1 and shall implement a thermal protection scheme to prevent damage to any of the critical components in the tablet due to operation outside their operating limits. As a minimum, the thermal protection software shall implement the thermal protection protocols identified in Table 2-24 — Thermal State Definitions. Table 2-24 — Thermal State Definitions
Sample 1
High temperature operation. For battery temperatures above 30°C, the battery charger shall adjust the discharge cutoff voltage to a higher value based on measured battery temperature. The cutoff voltage shall be linearly scaled from 3.0 volts at 30°C to 3.6 volts at 60°C. For battery temperatures above 45°C, the maximum charge current allowed shall be reduced to prevent excessive battery internal temperatures. The maximum allowable charge current shall be scaled linearly from a C/2 rate at 45°C to a C/10 rate at 60°C. Actual charge current shall be adjusted as required to maintain battery temperature at or below 60°C. Battery charging shall be inhibited for battery temperatures above 60°C. Critical shutdown temperature for the battery shall be 70°C. The high temperature limit for battery charging and critical system shutdown shall be programmable through the tablet BIOS.
Sample 1

Related to High temperature operation

  • ELECTRICAL SERVICES A. Landlord shall provide electric power for a combined load of 3.0 xxxxx per square foot of useable area for lighting and for office machines through standard receptacles for the typical office space.

  • Co-operation The Custodian shall cooperate with and supply necessary information to the entity or entities appointed by the Trust to keep the books of account of the Fund and/or compute the value of the assets of the Fund. The Custodian shall take all such reasonable actions as the Trust may from time to time request to enable the Trust to obtain, from year to year, favorable opinions from the Trust's independent accountants with respect to the Custodian's activities hereunder in connection with (a) the preparation of the Trust's reports on Form N-1A and Form N-SAR and any other reports required by the Securities and Exchange Commission, and (b) the fulfillment by the Trust of any other requirements of the Securities and Exchange Commission.

  • Profitable Operations Borrower will not permit Consolidated Net Income (a) for any fiscal year, commencing with the fiscal year ending December 31, 2002, to be less than $1.00 and (b) for any two consecutive fiscal quarters (treated as a single accounting period) to be less than $1.00.

  • Plant An electrical generating alternative energy resource facility developed by Producer for which IID shall provide transmission service, as specified in Exhibit(s) II, Transmission Service, and in any subsequent Plant Amendments.

  • Engineering Services The Borrower’s Engineer will provide engineering services covering planning and design, operation of the System, and the supervision and inspection of the construction of the Project. The Borrower’s Engineer will provide to the Department the certificate required by Section 3.4.

  • Operator The Optionee shall be the operator for purposes of developing and executing exploration programs.

  • Information Systems Acquisition Development and Maintenance a. Client Data – Client Data will only be used by State Street for the purposes specified in this Agreement.

  • Building Services To install, use and maintain through the Premises, pipes, conduits, wires and ducts serving the Building, provided that such installation, use and maintenance does not unreasonably interfere with Tenant's use of the Premises.

  • Fuel Upon redelivery of the Aircraft to Lessor, an adjustment will be made in respect of fuel on board on the Previous Delivery Date and the Expiry Date at the price then prevailing at the Redelivery Location.

  • Rent Rolls; Operating Histories The Seller has obtained a rent roll (the “Certified Rent Roll(s)”) other than with respect to hospitality properties certified by the related Mortgagor or the related guarantor(s) as accurate and complete in all material respects as of a date within 180 days of the date of origination of the related Mortgage Loan. The Seller has obtained operating histories (the “Certified Operating Histories”) with respect to each Mortgaged Property certified by the related Mortgagor or the related guarantor(s) as accurate and complete in all material respects as of a date within 180 days of the date of origination of the related Mortgage Loan. The Certified Operating Histories collectively report on operations for a period equal to (a) at least a continuous three-year period or (b) in the event the Mortgaged Property was owned, operated or constructed by the Mortgagor or an affiliate for less than three years then for such shorter period of time, it being understood that for mortgaged properties acquired with the proceeds of a Mortgage Loan, Certified Operating Histories may not have been available.

Time is Money Join Law Insider Premium to draft better contracts faster.