Primary Frequency Response Developer shall ensure the primary frequency response capability of its Large Generating Facility by installing, maintaining, and operating a functioning governor or equivalent controls. The term “functioning governor or equivalent controls” as used herein shall mean the required hardware and/or software that provides frequency responsive real power control with the ability to sense changes in system frequency and autonomously adjust the Large Generating Facility’s real power output in accordance with the droop and deadband parameters and in the direction needed to correct frequency deviations. Developer is required to install a governor or equivalent controls with the capability of operating: (1) with a maximum 5 percent droop ± 0.036 Hz deadband; or (2) in accordance with the relevant droop, deadband, and timely and sustained response settings from an approved Applicable Reliability Standard providing for equivalent or more stringent parameters. The droop characteristic shall be: (1) based on the nameplate capacity of the Large Generating Facility, and shall be linear in the range of frequencies between 59 and 61 Hz that are outside of the deadband parameter; or (2) based on an approved Applicable Reliability Standard providing for an equivalent or more stringent parameter. The deadband parameter shall be: the range of frequencies above and below nominal (60 Hz) in which the governor or equivalent controls is not expected to adjust the Large Generating Facility’s real power output in response to frequency deviations. The deadband shall be implemented: (1) without a step to the droop curve, that is, once the frequency deviation exceeds the deadband parameter, the expected change in the Large Generating Facility’s real power output in response to frequency deviations shall start from zero and then increase (for under-frequency deviations) or decrease (for over-frequency deviations) linearly in proportion to the magnitude of the frequency deviation; or (2) in accordance with an approved Applicable Reliability Standard providing for an equivalent or more stringent parameter. Developer shall notify NYISO that the primary frequency response capability of the Large Generating Facility has been tested and confirmed during commissioning. Once Developer has synchronized the Large Generating Facility with the New York State Transmission System, Developer shall operate the Large Generating Facility consistent with the provisions specified in Articles 9.5.5.1 and 9.5.5.2 of this Agreement. The primary frequency response requirements contained herein shall apply to both synchronous and non-synchronous Large Generating Facilities.
Firm Response The Department should make an award within sixty (60) days after the date of the opening, during which period responses shall remain firm and shall not be withdrawn. If award is not made within sixty (60) days, the response shall remain firm until either the Department awards the Contract or the Department receives from the bidder written notice that the response is withdrawn. Any response that expresses a shorter duration should, in the Department's sole discretion, be accepted or rejected.
Timely and Sustained Response Interconnection Customer shall ensure that the Small Generating Facility’s real power response to sustained frequency deviations outside of the deadband setting is automatically provided and shall begin immediately after frequency deviates outside of the deadband, and to the extent the Small Generating Facility has operating capability in the direction needed to correct the frequency deviation. Interconnection Customer shall not block or otherwise inhibit the ability of the governor or equivalent controls to respond and shall ensure that the response is not inhibited, except under certain operational constraints including, but not limited to, ambient temperature limitations, physical energy limitations, outages of mechanical equipment, or regulatory requirements. The Small Generating Facility shall sustain the real power response at least until system frequency returns to a value within the deadband setting of the governor or equivalent controls. An Applicable Reliability Standard with equivalent or more stringent requirements shall supersede the above requirements.
Government’s Response Please refer to the Q&A from the first question.
Dental Services - Accidental Injury (Emergency Emergency room - When services are due to accidental injury to sound natural teeth. 0% - After deductible The level of coverage is the same as network provider. In a physician’s/dentist’s office - When services are due to accidental injury to sound natural teeth. 0% - After deductible 40% - After deductible Dental Services - Outpatient Services connected to dental care when performed in an outpatient facility * 0% - After deductible 40% - After deductible Covered Benefits - See Covered Healthcare Services for additional benefit limits and details. Network Providers Non-network Providers (*) Preauthorization may be required for this service. Please see Preauthorization in Section 5 for more information. You Pay You Pay Dental Care (Pediatric) - for members under age 19 See Dental Services in Section 3 for benefit limits and details. These services only apply to an enrolled member under the age of 19. Oral evaluations 0% - After deductible 0% - After deductible X-rays 0% - After deductible 0% - After deductible Cleanings (prophylaxis) 0% - After deductible 0% - After deductible Fluoride treatments 0% - After deductible 0% - After deductible Sealants 0% - After deductible 0% - After deductible Space Maintainers 0% - After deductible 0% - After deductible Palliative treatment 50% - After deductible 50% - After deductible Fillings 50% - After deductible 50% - After deductible Simple extractions 50% - After deductible 50% - After deductible Denture repairs and relines/rebasing 50% - After deductible 50% - After deductible Crowns & onlays 50% - After deductible 50% - After deductible Therapeutic Pulpotomies 50% - After deductible 50% - After deductible Root canal therapy 50% - After deductible 50% - After deductible Non-surgical periodontal services 50% - After deductible 50% - After deductible Surgical periodontal services 50% - After deductible 50% - After deductible Periodontal maintenance 50% - After deductible 50% - After deductible Fixed bridges and dentures 50% - After deductible 50% - After deductible Implants 50% - After deductible 50% - After deductible Oral surgery services 50% - After deductible 50% - After deductible General anesthesia or IV sedation - dental office 50% - After deductible 50% - After deductible Biopsies 50% - After deductible 50% - After deductible Occlusal (night) guards 50% - After deductible 50% - After deductible Orthodontic services (braces) - when medically necessary. 50% - After deductible 50% - After deductible Dialysis Services Inpatient/outpatient/in your home 0% - After deductible 40% - After deductible Durable Medical Equipment (DME), Medical Supplies, Diabetic Supplies, Prosthetic Devices, and Enteral Formula or Food, Hair Prosthetics Outpatient durable medical equipment* - Must be provided by a licensed medical supply provider. 20% - After deductible 40% - After deductible Outpatient medical supplies* - Must be provided by a licensed medical supply provider. 20% - After deductible 40% - After deductible Outpatient diabetic supplies/equipment purchased at licensed medical supply provider (other than a pharmacy). See the Summary of Pharmacy Benefits for supplies purchased at a pharmacy. 20% - After deductible 40% - After deductible Outpatient prosthesis* - Must be provided by a licensed medical supply provider. 20% - After deductible 40% - After deductible Enteral formula delivered through a feeding tube. Must be sole source of nutrition. 20% - After deductible 40% - After deductible Enteral formula or food taken orally * 20% - After deductible The level of coverage is the same as network provider. Hair prosthesis (wigs) - The benefit limit is $350 per hair prosthesis (wig) when worn for hair loss suffered as a result of cancer treatment. 20% - After deductible The level of coverage is the same as network provider.
Line Item Question Response 43 Do your warranties cover all products, parts, and labor? Axon warrants that its law enforcement hardware products which are manufactured by Axon are free from defects in workmanship and materials for a period of one (1) year from the date of receipt. Axon-manufactured accessories are covered under a limited ninety-day warranty from the date of receipt. Non-Axon manufactured accessories are covered under the manufacturer's warranty. There are extended warranties available as defined in the Axon Master Services and Purchasing Agreement (MSPA). NON-AXON MANUFACTURED PRODUCTS For some solutions we are authorized resellers of hardware (Cradlepoint routers for Axon Fleet, Axis cameras for Axon Interview, etc.). Products that we are authorized to resell abide by the manufacturer's warranty. Further details can be provided upon request. * 44 Do your warranties impose usage restrictions or other limitations that adversely affect coverage? Restrictions are outlined in our warranty, which has been included in the uploaded attachments. * 45 Do your warranties cover the expense of technicians' travel time and mileage to perform warranty repairs? Our warranties do not cover the expense of technicians' travel time and mileage to perform warranty repairs. * 46 Are there any geographic regions of the United States (and Canada, if applicable) for which you cannot provide a certified technician to perform warranty repairs? How will Sourcewell Members in these regions be provided service for warranty repair? Axon will be available 24 hours/7 days per week by phone for emergency technical support for any system outage, and if mutually agreed upon by both parties, we can provide onsite support for local issues. If a site visit is deemed necessary due to an issue (i.e. access point failures or accidental cut wires) and not an Axon or Axon Evidence issue there may be a charge assessed to the agency. * 47 Will you cover warranty service for items made by other manufacturers that are part of your proposal, or are these warranties issues typically passed on to the original equipment manufacturer? Axon will troubleshoot these devices to the best of our ability. If we are unable to resolve the issue and the devices require warranty service, this will be performed by the manufacturer. * 48 What are your proposed exchange and return programs and policies? Axon does not allow exchanges or returns. Please see our MSPA for full details. * 49 Describe any service contract options for the items included in your proposal. Please refer to the included MSPA. * Table 10: Payment Terms and Financing Options Line Item Question Response * 50 What are your payment terms (e.g., net 10, net 30)? Payment terms are Net 30. * 51 Do you provide leasing or financing options, especially those options that schools and governmental entities may need to use in order to make certain acquisitions? Axon does not offer leasing or financing options. Alternatively, Axon offers a provision in its MSPA which allows for cancellation by the agency if sufficient funds are not appropriated. * 52 Briefly describe your proposed order process. Include enough detail to support your ability to report quarterly sales to Sourcewell as described in the Contract template. For example, indicate whether your dealer network is included in your response and whether each dealer (or some other entity) will process the Sourcewell Members' purchase orders. Axon will process orders Axon will accept from Sourcewell members directly, as our distributor network in the United States and Canada does not sell our video products. Our Order Entry team enters orders into our CRM, Salesforce. Reports will be maintained and extracted from Salesforce for quarterly reporting to Sourcewell. *
Reactive Power and Primary Frequency Response 9.6.1 Power Factor Design Criteria
Benefit Level Two Health Care Network Determination Issues regarding the health care networks for the 2017 insurance year shall be negotiated in accordance with the following procedures:
Outpatient Dental Anesthesia Services This plan covers anesthesia services received in connection with a dental service when provided in a hospital or freestanding ambulatory surgical center and: • the use of this is medically necessary; and • the setting in which the service is received is determined to be appropriate. This plan also covers facility fees associated with these services.
Workplace Violence Prevention and Crisis Response (applicable to any Party and any subcontractors and sub-grantees whose employees or other service providers deliver social or mental health services directly to individual recipients of such services): Party shall establish a written workplace violence prevention and crisis response policy meeting the requirements of Act 109 (2016), 33 VSA §8201(b), for the benefit of employees delivering direct social or mental health services. Party shall, in preparing its policy, consult with the guidelines promulgated by the U.S. Occupational Safety and Health Administration for Preventing Workplace Violence for Healthcare and Social Services Workers, as those guidelines may from time to time be amended. Party, through its violence protection and crisis response committee, shall evaluate the efficacy of its policy, and update the policy as appropriate, at least annually. The policy and any written evaluations thereof shall be provided to employees delivering direct social or mental health services. Party will ensure that any subcontractor and sub-grantee who hires employees (or contracts with service providers) who deliver social or mental health services directly to individual recipients of such services, complies with all requirements of this Section.
