Inspection and Correction for Bound Volumes Sample Clauses

Inspection and Correction for Bound Volumes. 3.10.1 Within five (5) work days after the publication of each Advance Sheet, the Publisher shall send to the Reporter one (1) set of Advance Sheet page proof. Such page proof shall mirror the Advance Sheets and shall be provided on paper measuring 8 1/2 by 11 inches with printing on one side only. 3.10.2 The Reporter of Decisions will inspect, revise, correct, and supplement the Advance Sheet page proof before publication of the Bound Volume. The Advance Sheet page proof, as changed by the Reporter of Decisions, shall be returned to the Publisher as opinion page manuscript, which commences the time period for publication of Bound Volumes as specified in subsection 2.3.1, supra, and subsection 6.2.1, infra. 3.10.3 The Publisher shall make all changes directed by the Reporter of Decisions and then shall forward the changed page proof of the Bound Volume pages to the Reporter of Decisions for final approval. The Reporter of Decisions shall have 10 work days to review, revise, and approve the page proof of the Bound Volume pages. The Reporter of Decisions will return all revised pages to the Publisher, which shall make the revisions for publication in the Bound Volume. 3.10.4 The Publisher shall provide the Reporter of Decisions with a proof copy of the front cover and spine of each Bound Volume. Revisions and corrections made by the Reporter of Decisions shall be incorporated into the cover and/or spine of the published Bound Volume. 3.10.5 If an error or errors of significance are detected after publication of a Bound Volume of the Washington Reports or the Washington Appellate Reports, whether the error is caused by the Publisher or otherwise, the Publisher upon discovery or notification of the error shall promptly, at the sole discretion of the Reporter of Decisions and at the Publisher's own expense, (i) issue a "crack, peel, and affix" correcting printout to all Bound Volume subscribers or (ii) reprint and reissue the Bound Volume in its entirety.
Sample 1Sample 2
AutoNDA by SimpleDocs

Related to Inspection and Correction for Bound Volumes

  • Minimum Site Requirements for TIPS Sales (when applicable to TIPS Sale). Cleanup: When performing work on site at a TIPS Member’s property, Vendor shall clean up and remove all debris and rubbish resulting from their work as required or directed by the TIPS Member or as agreed by the parties. Upon completion of work, the premises shall be left in good repair and an orderly, neat, clean and unobstructed condition. Preparation: Vendor shall not begin a project for which a TIPS Member has not prepared the site, unless Vendor does the preparation work at no cost, or until TIPS Member includes the cost of site preparation in the TIPS Sale Site preparation includes, but is not limited to: moving furniture, installing wiring for networks or power, and similar pre‐installation requirements. Registered Sex Offender Restrictions: For work to be performed at schools, Vendor agrees that no employee of Vendor or a subcontractor who has been adjudicated to be a registered sex offender will perform work at any time when students are, or reasonably expected to be, present unless otherwise agreed by the TIPS Member. Vendor agrees that a violation of this condition shall be considered a material breach and may result in the cancellation of the TIPS Sale at the TIPS Member’s discretion. Vendor must identify any additional costs associated with compliance of this term. If no costs are specified, compliance with this term will be provided at no additional charge. Safety Measures: Vendor shall take all reasonable precautions for the safety of employees on the worksite, and shall erect and properly maintain all necessary safeguards for protection of workers and the public. Vendor shall post warning signs against all hazards created by the operation and work in progress. Proper precautions shall be taken pursuant to state law and standard practices to protect workers, general public and existing structures from injury or damage. Smoking: Persons working under Agreement shall adhere to the TIPS Member’s or local smoking statutes, codes, ordinances, and policies.

  • Inspection Reports A "full inspection report" comprises a Site Master File (compiled by the manufacturer or by the inspectorate) and a narrative report by the inspectorate. A "detailed report" responds to specific queries about a firm by the other Party.

  • Inspection Testing Authorization and Right of Access 2.1 Equipment Testing and Inspection 2.2 Authorization Required Prior to Parallel Operation

  • INSPECTION AND REJECTION 8.1 Purchaser shall have the right to inspect and test Products at any time prior to shipment, and within a reasonable time after delivery to the Purchaser’s Destination. Products not inspected within a reasonable time after delivery shall be deemed accepted by Purchaser. The payment for Products shall in no way impair the right of Purchaser to reject nonconforming Products, or to avail itself of any other remedies to which it may be entitled. 8.2 If any of the Products are found at any time to be defective in material or workmanship, damaged, or otherwise not in conformity with the requirements of this Agreement or any applicable Purchase Order, as its exclusive remedy, Purchaser may at its option and at Vendor’s sole cost and expense, elect either to (i) return any damaged, non-conforming or defective Products to Vendor for correction or replacement, or (ii) require Vendor to inspect the Products and remove or replace damaged, non-conforming or defective Products with conforming Products. If Purchaser elects option (ii) in the preceding sentence and Vendor fails promptly to make the necessary inspection, removal and replacement, Purchaser, at its option, may inspect the Products and Vendor shall bear the cost thereof. Payment by Purchaser of any invoice shall not constitute acceptance of the Products covered by such invoice, and acceptance by Purchaser shall not relieve Vendor of its warranties or other obligations under this Agreement. 8.3 The provisions of this Article shall survive the expiration or termination of this Agreement.

  • Response/Compliance with Audit or Inspection Findings A. Grantee must act to ensure its and its Subcontractors’ compliance with all corrections necessary to address any finding of noncompliance with any law, regulation, audit requirement, or generally accepted accounting principle, or any other deficiency identified in any audit, review, inspection or investigation of the Grant Agreement and the services and Deliverables provided. Any such correction will be at Grantee’s or its Subcontractor's sole expense. Whether Xxxxxxx's action corrects the noncompliance shall be solely the decision of the System Agency. B. As part of the services, Grantee must provide to HHS upon request a copy of those portions of Grantee's and its Subcontractors' internal audit reports relating to the services and Deliverables provided to the State under the Grant Agreement. C. Grantee shall include the requirement to provide to System Agency (and any of its duly authorized federal, state, or local authorities) internal audit reports related to this Grant Agreement in any Subcontract it awards. Upon request by System Agency, Grantee shall enforce this requirement against its Subcontractor. Further, Grantee shall include in any Subcontract it awards a requirement that all Subcontractor Subcontracts must also include these provisions.

  • Inspection of Reports The Depositary shall make available for inspection by holders of Receipts at the Corporate Office and at such other places as it may from time to time deem advisable during normal business hours any reports and communications received from the Company that are both received by the Depositary as the holder of deposited Preferred Stock and made generally available to the holders of the Preferred Stock. In addition, the Depositary shall transmit certain notices and reports to the holders of Receipts as provided in Section 5.05.

  • Inspection; Compliance Lessor and Lessor's Lender(s) (as defined in Paragraph 8.3(a)) shall have the right to enter the Premises at any time, in the case of an emergency, and otherwise at reasonable times, for the purpose of inspecting the condition of the Premises and for verifying compliance by Lessee with this Lease and all Applicable Laws (as defined in Paragraph 6.3), and to employ experts and/or consultants in connection therewith and/or to advise Lessor with respect to Lessee's activities, including but not limited to the installation, operation, use, monitoring, maintenance, or removal of any Hazardous Substance or storage tank on or from the Premises. The costs and expenses of any such inspections shall be paid by the party requesting same, unless a Default or Breach of this Lease, violation of Applicable Law, or a contamination, caused or materially contributed to by Lessee is found to exist or be imminent, or unless the inspection is requested or ordered by a governmental authority as the result of any such existing or imminent violation or contamination. In any such case, Lessee shall upon request reimburse Lessor or Lessor's Lender, as the case may be, for the costs and expenses of such inspections.

  • Inspection and Tests 3.8.1 The Procuring entity or its representative shall have the right to inspect and/or to test the goods to confirm their conformity to the Contract specifications. The Procuring entity shall notify the tenderer in writing in a timely manner, of the identity of any representatives retained for these purposes. 3.8.2 The inspections and tests may be conducted in the premises of the tenderer or its subcontractor(s), at point of delivery, and/or at the Goods’ final destination If conducted on the premises of the tenderer or its subcontractor(s), all reasonable facilities and assistance, including access to drawings and production data, shall be furnished to the inspectors at no charge to the Procuring entity. 3.8.3 Should any inspected or tested goods fail to conform to the Specifications, the Procuring entity may reject the equipment, and the tenderer shall either replace the rejected equipment or make alterations necessary to make specification requirements free of costs to the Procuring entity. 3.8.4 The Procuring entity’s right to inspect, test and where necessary, reject the goods after the Goods’ arrival shall in no way be limited or waived by reason of the equipment having previously been inspected, tested and passed by the Procuring entity or its representative prior to the equipment delivery. 3.8.5 Nothing in paragraph 3.8 shall in any way release the tenderer from any warranty or other obligations under this Contract.

  • Inspection and Testing Each Constructing Entity shall cause inspection and testing of the Interconnection Facilities that it constructs in accordance with the provisions of this section. The Construction Parties acknowledge and agree that inspection and testing of facilities may be undertaken as facilities are completed and need not await completion of all of the facilities that a Constructing Entity is building.

  • Certification Regarding Termination of Contract for Non-Compliance (Tex Gov. Code 552.374)

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!