Installation and Testing of Beta Units Sample Clauses

Installation and Testing of Beta Units. JMAR agrees to a) supply and install three BioSentry(TM) Beta units at the District's treatment facility and b) operate and test the Beta units in accordance with Exhibit A at no cost to the District. JMAR agrees to bear the cost of the three Beta units and its own costs for installing, operating and testing the units. The District agrees to make available its facility to JMAR at no additional cost to JMAR for the purpose of the installation and testing of the three BioSentry(TM) Beta units. The District also agrees to make its personnel available to JMAR at the District's cost to support the installation and testing of the Beta units in accordance with Exhibit A.
AutoNDA by SimpleDocs
Installation and Testing of Beta Units. JMAR agrees to a) supply and install one BioSentry(TM) Beta unit(s) at the Company's laboratory facility and b) operate and test the Beta units in accordance with Exhibit A. The Company agrees to make available its facility to JMAR at no additional cost to JMAR for the purpose of the installation and testing of one BioSentry(TM) Beta unit(s). The Company also agrees to make its personnel available to JMAR at the Company's cost to support the installation and testing of the Beta units in accordance with Exhibit A.

Related to Installation and Testing of Beta Units

  • Installation and Conversion State Street and the Fund shall be responsible for the technical installation and conversion (“Installation and Conversion”) of the Designated Configuration. The Fund shall have the following responsibilities in connection with Installation and Conversion of the System:

  • Installation and Maintenance of Meters The Servicer shall cause to be installed, replaced and maintained meters in accordance with the Servicer Policies and Practices.

  • Election and Removal of Directors Upon election by the Member, each Director shall hold office until his or her death, disability, resignation or removal at any time at the pleasure of the Member. If a vacancy occurs on the Board, the Member shall, as soon as practicable after the occurrence of such vacancy, elect a successor so that the Board remains fully constituted at all times.

  • Heating, Ventilation and Air Conditioning Landlord shall furnish to the Premises heating, ventilation and air-conditioning (“HVAC”) in accordance with the Design Standards set forth in Exhibit D during Ordinary Business Hours. Landlord shall have access to all air-cooling, fan, ventilating and machine rooms and electrical closets and all other mechanical installations of Landlord (collectively, “Mechanical Installations”), and Tenant shall not construct partitions or other obstructions which may interfere with Landlord’s access thereto or the moving of Landlord’s equipment to and from the Mechanical Installations. No Tenant Party shall at any time enter the Mechanical Installations or tamper with, adjust, or otherwise affect such Mechanical Installations. Landlord shall not be responsible if the HVAC System fails to provide cooled or heated air, as the case may be, to the Premises in accordance with the Design Standards by reason of (i) any equipment installed by, for or on behalf of Tenant, which has an electrical load in excess of the average electrical load and human occupancy factors for the HVAC System as designed, or (ii) any rearrangement of partitioning or other Alterations made or performed by, for or on behalf of Tenant. Tenant shall install, if missing, blinds or shades on all windows, which blinds and shades shall be subject to Landlord’s approval, and shall keep operable windows in the Premises closed, and lower the blinds when necessary because of the sun’s position, whenever the HVAC System is in operation or as and when required by any Requirement. Tenant shall cooperate with Landlord and shall abide by the rules and regulations which Landlord may reasonably prescribe for the proper functioning and protection of the HVAC System. Tenant acknowledges that the server room in the Premises currently has three heat pumps installed, being two 4-ton units, and one 2.5-ton unit (the “Existing Heat Pumps”). The 2.5-ton unit is currently connected and operational. Tenant shall determine whether it is satisfied with the condition of the Existing Heat Pumps and Landlord shall not have any responsibility or liability for the condition, operation, maintenance, repair or replacement of the Existing Heat Pumps. Tenant may operate the Existing Heat Pumps. Tenant shall be responsible for, and pay directly for, all necessary maintenance and repairs to the Existing Heat Pumps. Tenant shall reimburse Landlord monthly for the cost of all utility services used to operate the Existing Heat Pumps within 10 Business Days after receipt of Landlord’s invoice for such amount. Landlord may measure Tenant’s usage of such utility services by either a sub-meter or by other reasonable methods such as by temporary check meters or by survey. Tenant, at its cost, may replace the Existing Heat Pumps with one or more new heat pumps, provided, however, that the capacity of such replacement heat pump(s) shall not exceed the 10.5-ton capacity cooling capacity of the Existing Heat Pumps.

  • Installation Tenant may install and use Tenant's Lines and make connections and disconnections at the terminal blocks as described above, provided Tenant shall: (i) obtain Landlord's prior written approval of all aspects thereof, (ii) use an experienced and qualified contractor designated or approved in writing in advance by Landlord (whom Landlord may require to enter an access and indemnity agreement on Landlord's then standard form of agreement therefor), (iii) comply with such inside wire standards as Landlord may adopt from time to time, and all other provisions of this Lease, including Paragraph 8 respecting alterations, and the Building rules respecting access to the wire closets, (iv) not install Lines in the same sleeve, chaseway or other enclosure in close proximity with electrical wire, and not install PVC-coated Lines under any circumstances, (v) thoroughly test any riser Lines to which Tenant intends to connect any Lines to ensure that such riser Lines are available and are not then connected to or used for telephone, data transmission or any other purpose by any other party (whether or not Landlord has previously approved such connections), and not connect to any such unavailable or connected riser Lines, and (vi) not connect any equipment to the Lines which may create an electromagnetic field exceeding the normal insulation ratings of ordinary twisted pair riser cable or cause radiation higher than normal background radiation, unless the Lines therefor (including riser Lines) are appropriately insulated to prevent such excessive electromagnetic fields or radiation (and such insulation shall not be provided by the use of additional unused twisted pair Lines). As a condition to permitting installation of new Lines, Landlord may require that Tenant remove any existing Lines located in or serving the Premises.

  • for substitutions by Residential Funding It is understood and agreed that the obligation of the Company to cure such breach or to so purchase or substitute for any Mortgage Loan as to which such a breach has occurred and is continuing shall constitute the sole remedy respecting such breach available to the Certificateholders or the Trustee on behalf of the Certificateholders. Notwithstanding the foregoing, the Company shall not be required to cure breaches or purchase or substitute for Mortgage Loans as provided in this Section 2.03(b) if the substance of the breach of a representation set forth above also constitutes fraud in the origination of the Mortgage Loan.

  • Metering 1. If the Producer desires to sell electric power to the Company, the Company shall provide, own and maintain at the Producer's expense all necessary meters and associated equipment to be utilized for the measurement of energy and capacity for determining the Company's payment to the Producer pursuant to an applicable agreement.

  • Revocation Effect and Solicitation of Consents Special Record Dates Etc 60 Section 9.05. Notations and Exchanges. 61 Section 9.06. Trustee to Execute Supplemental Indentures. 61 Article 10. Satisfaction and Discharge 61 Section 10.01. Termination of Company’s Obligations. 61 Section 10.02. Repayment to Company. 62 Section 10.03. Reinstatement. 62 Article 11. Collateral Agency 63 Section 11.01. Collateral Agent. 63 Section 11.02. Application Proceeds of any Collateral. 63 Section 11.03. Limitation on the Duty of Collateral Agent in Respect of Collateral. 63 Article 12. Collateral And Security 65 Section 12.01. General. 65 Section 12.02. Security Documents. 65 Section 12.03. [Reserved]. 66 Section 12.04. Possession, Use and Release of Collateral. 66 Section 12.05. Suits to Protect Collateral. 67 Section 12.06. Powers Exercisable by Receiver, Trustee or Collateral Agent. 67 Section 12.07. Determinations Relating to Collateral. 67 Section 12.08. [Reserved]. 68 Section 12.09. [Reserved]. 68 Section 12.10. Purchaser Protected. 68 Article 13. Trustee 68 Section 13.01. Duties of Trustee. 68 Section 13.02. Rights of Trustee. 69 Section 13.03. Individual Rights of Trustee. 71 Section 13.04. Trustee’s Disclaimer. 71 Section 13.05. [Reserved]. 71 Section 13.06. [Reserved]. 71 Section 13.07. Compensation and Indemnity. 71 Section 13.08. Replacement of Trustee. 72 Section 13.09. Successor Trustee by Xxxxxx, Etc. 73 Section 13.10. [Reserved]. 73 Section 13.11. [Reserved]. 74 ||| Article 14. Miscellaneous 74 Section 14.01. Notices. 74 Section 14.02. Delivery of Officer’s Certificate and Opinion of Counsel as to Conditions Precedent. 75 Section 14.03. Statements Required in Officer’s Certificate and Opinion of Counsel. 76 Section 14.04. Rules by the Trustee, the Registrar and the Paying Agent. 76

  • Performance of Services in Accordance with Regulatory Requirements; Furnishing of Books and Records In performing the services set forth in this Agreement, the Manager:

Time is Money Join Law Insider Premium to draft better contracts faster.