Access Toll Connecting Trunk Group Architecture 9.2.1 If CSTC chooses to subtend a Verizon access Tandem, CSTC’s NPA/NXX must be assigned by CSTC to subtend the same Verizon access Tandem that a Verizon NPA/NXX serving the same Rate Center Area subtends as identified in the LERG.
9.2.2 CSTC shall establish Access Toll Connecting Trunks pursuant to applicable access Tariffs by which it will provide Switched Exchange Access Services to Interexchange Carriers to enable such Interexchange Carriers to originate and terminate traffic to and from CSTC’s Customers.
9.2.3 The Access Toll Connecting Trunks shall be two-way trunks. Such trunks shall connect the End Office CSTC utilizes to provide Telephone Exchange Service and Switched Exchange Access to its Customers in a given LATA to the access Tandem(s) Verizon utilizes to provide Exchange Access in such LATA.
9.2.4 Access Toll Connecting Trunks shall be used solely for the transmission and routing of Exchange Access to allow CSTC’s Customers to connect to or be connected to the interexchange trunks of any Interexchange Carrier which is connected to a Verizon access Tandem.
SEXUAL EXPLOITATION 18.1 The Contractor shall take all appropriate measures to prevent sexual exploitation or abuse of anyone by it or by any of its employees or any other persons who may be engaged by the Contractor to perform any services under the Contract. For these purposes, sexual activity with any person less than eighteen years of age, regardless of any laws relating to consent, shall constitute the sexual exploitation and abuse of such person. In addition, the Contractor shall refrain from, and shall take all appropriate measures to prohibit its employees or other persons engaged by it from, exchanging any money, goods, services, offers of employment or other things of value, for sexual favors or activities, or from engaging in any sexual activities that are exploitive or degrading to any person. The Contractor acknowledges and agrees that the provisions hereof constitute an essential term of the Contract and that any breach of this representation and warranty shall entitle UNDP to terminate the Contract immediately upon notice to the Contractor, without any liability for termination charges or any other liability of any kind.
18.2 UNDP shall not apply the foregoing standard relating to age in any case in which the Contractor’s personnel or any other person who may be engaged by the Contractor to perform any services under the Contract is married to the person less than the age of eighteen years with whom sexual activity has occurred and in which such marriage is recognized as valid under the laws of the country of citizenship of such Contractor’s personnel or such other person who may be engaged by the Contractor to perform any services under the Contract.
Licensed Product The term “Licensed Product” shall mean any product (a) the manufacture, use, importation, sale or offer for sale of which would, in the absence of the license granted by this Agreement, infringe a Valid Claim of any of the Licensed Patent Rights, or (b) that is comprised of, utilizes or incorporates Licensed Biological Materials, or (c) that is discovered, developed or made using a Licensed Process.
Abuse, Neglect, Exploitation Grantee will;
a. take all steps necessary, to protect the health, safety and welfare of its clients and participants.
b. develop and implement written policies and procedures for abuse, neglect and exploitation.
c. notify appropriate authorities of any allegations of abuse, neglect, or exploitation as required by 25 TAC § 448.703.
Trunk Group Connections and Ordering 5.2.1 For both One-Way and Two-Way Interconnection Trunks, if Onvoy wishes to use a technically feasible interface other than a DS1 or a DS3 facility at the POI, the Parties shall negotiate reasonable terms and conditions (including, without limitation, rates and implementation timeframes) for such arrangement; and, if the Parties cannot agree to such terms and conditions (including, without limitation, rates and implementation timeframes), either Party may utilize the Agreement’s dispute resolution procedures.
5.2.2 When One-Way or Two-Way Interconnection Trunks are provisioned using a DS3 interface facility, if Onvoy orders the multiplexed DS3 facilities to a Frontier Central Office that is not designated in the NECA 4 Tariff as the appropriate Intermediate Hub location (i.e., the Intermediate Hub location in the appropriate Tandem subtending area based on the LERG), and the provision of such facilities to the subject Central Office is technically feasible, the Parties shall negotiate in good faith reasonable terms and conditions (including, without limitation, rates and implementation timeframes) for such arrangement; and, if the Parties cannot agree to such terms and conditions (including, without limitation, rates and implementation timeframes), either Party may utilize the Agreement’s dispute resolution procedures.
5.2.3 Each Party will identify its Carrier Identification Code, a three or four digit numeric code obtained from Telcordia, to the other Party when ordering a trunk group.
5.2.4 For multi-frequency (MF) signaling each Party will out pulse ten (10) digits to the other Party, unless the Parties mutually agree otherwise.
5.2.5 Each Party will use commercially reasonable efforts to monitor trunk groups under its control and to augment those groups using generally accepted trunk- engineering standards so as to not exceed blocking objectives. Each Party agrees to use modular trunk-engineering techniques for trunks subject to this Attachment.
Sublicensees Licensee shall have the right (but not the obligation) to sublicense those rights granted to it under Section 2.1 only as set forth in, and subject to the terms and conditions of, Section 2.5 and this Section 2.3.2, to (a) any Person (other than a Specified Person) with the prior written consent of Lxxxx, which consent will not be unreasonably withheld, conditioned or delayed; provided that Licensee may contract in the ordinary course of business with any Third Party contract research organization (“CRO”) or contract development and manufacturing organization (“CMO”) to handle certain clinical Development or Manufacturing activities, in Licensee’s reasonable discretion, without requiring Lilly’s consent; provided further that such CRO or CMO are working on Licensee’s behalf, (b) any of its Affiliates (only for so long as they remain Affiliates), provided that Licensee provides prior written notice (at least 20 Business Days in advance) to Lilly of any sublicenses to be granted to any Affiliate or its request for approval of any sublicense to be granted to any other Person, which shall include in each case a description of the rights to be granted and the purpose therefor, the identity of the proposed Sublicensee and the countries involved, or (c) a Specified Person. Each Affiliate or other Person to which any such sublicense is granted is referred to herein as a “Sublicensee.” Licensee shall remain responsible for the performance by each of its Sublicensees and shall cause each of its Sublicensees to comply with the applicable provisions of this Agreement, and Licensee shall be liable for the acts or omissions of its Sublicensees under or in connection with this Agreement (as if such acts or omission were those of Licensee). Without limiting the foregoing, Licensee shall: (x) ensure that each of its Sublicensees accepts in writing all applicable terms and conditions of this Agreement, including the non-compete, reporting, audit, inspection and confidentiality provisions hereunder; (y) under the agreements between Licensee and each of its Sublicensees, include a provision pursuant to which either (a) Lilly is named as a third-party beneficiary or (b) a mechanism (for example, a power of attorney) is implemented for Lxxxx to enforce all applicable terms and conditions of this Agreement against the Sublicensee in a manner reasonably satisfactory to Lilly, provided that, in each case, Lxxxx shall not proceed against any Sublicensee unless Lxxxx has first provided Licensee with written notice of the Sublicensee’s breach and Licensee has not, within 90 days after receipt of such notice, caused the Sublicensee to cease the breaching activity or otherwise cure the breach, in each case, to the reasonable satisfaction of Lxxxx; and (z) terminate all relevant agreements with any such Sublicensee in the case of any breach of such terms and conditions by such Sublicensee. A Sublicensee shall have the right to grant further sublicenses, subject to complying with the terms of this Section 2.3.2 with respect to further Sublicensees. For the avoidance of doubt, (i) Licensee will remain directly responsible for all amounts owed to Lilly under this Agreement, and (ii) each Sublicensee is subject to the negative and restrictive covenants set forth in Sections 2.2.1 and 2.4, respectively. Licensee hereby expressly waives any requirement that Lxxxx exhaust any right, power or remedy, or proceed against a subcontractor, for any obligation or performance hereunder prior to proceeding directly against Licensee. Notwithstanding anything to the contrary, (A) all sublicenses granted hereunder shall automatically terminate upon expiration or termination of this Agreement for any reason and (B) if the Parties enter into an agreement pursuant to Section 2.5 with respect to the Product, then as of the effective date of such agreement all sublicenses granted with respect to the Product shall automatically terminate, except as otherwise mutually agreed by the Parties in writing (and in no event shall any negotiations for any such agreement pursuant to Section 2.5 be conditioned on or otherwise affected by whether Lxxxx agrees to allow any such sublicenses to continue).
Product ACCEPTANCE Unless otherwise provided by mutual agreement of the Authorized User and the Contractor, Authorized User(s) shall have thirty (30) days from the date of delivery to accept hardware products and sixty (60) days from the date of delivery to accept all other Product. Where the Contractor is responsible for installation, acceptance shall be from completion of installation. Failure to provide notice of acceptance or rejection or a deficiency statement to the Contractor by the end of the period provided for under this clause constitutes acceptance by the Authorized User(s) as of the expiration of that period. The License Term shall be extended by the time periods allowed for trial use, testing and acceptance unless the Commissioner or Authorized User agrees to accept the Product at completion of trial use. Unless otherwise provided by mutual agreement of the Authorized User and the Contractor, Authorized User shall have the option to run testing on the Product prior to acceptance, such tests and data sets to be specified by User. Where using its own data or tests, Authorized User must have the tests or representative set of data available upon delivery. This demonstration will take the form of a documented installation test, capable of observation by the Authorized User, and shall be made part of the Contractor’s standard documentation. The test data shall remain accessible to the Authorized User after completion of the test. In the event that the documented installation test cannot be completed successfully within the specified acceptance period, and the Contractor or Product is responsible for the delay, Authorized User shall have the option to cancel the order in whole or in part, or to extend the testing period for an additional thirty (30) day increment. Authorized User shall notify Contractor of acceptance upon successful completion of the documented installation test. Such cancellation shall not give rise to any cause of action against the Authorized User for damages, loss of profits, expenses, or other remuneration of any kind. If the Authorized User elects to provide a deficiency statement specifying how the Product fails to meet the specifications within the testing period, Contractor shall have thirty (30) days to correct the deficiency, and the Authorized User shall have an additional sixty (60) days to evaluate the Product as provided herein. If the Product does not meet the specifications at the end of the extended testing period, Authorized User, upon prior written notice to Contractor, may then reject the Product and return all defective Product to Contractor, and Contractor shall refund any monies paid by the Authorized User to Contractor therefor. Costs and liabilities associated with a failure of the Product to perform in accordance with the functionality tests or product specifications during the acceptance period shall be borne fully by Contractor to the extent that said costs or liabilities shall not have been caused by negligent or willful acts or omissions of the Authorized User’s agents or employees. Said costs shall be limited to the amounts set forth in the Limitation of Liability Clause for any liability for costs incurred at the direction or recommendation of Contractor.
Other Methods of Procurement of Goods and Works The following table specifies the methods of procurement, other than International Competitive Bidding, which may be used for goods and works. The Procurement Plan shall specify the circumstances under which such methods may be used:
(a) National Competitive Bidding (b) Shopping (c) Direct Contracting
Licensed Products Lessee will obtain no title to Licensed Products which will at all times remain the property of the owner of the Licensed Products. A license from the owner may be required and it is Lessee's responsibility to obtain any required license before the use of the Licensed Products. Lessee agrees to treat the Licensed Products as confidential information of the owner, to observe all copyright restrictions, and not to reproduce or sell the Licensed Products.
Programming Phase Schematic Design Phase: 2.2.1.3. Design Development Phase:
