Limit States Design
Limit States Design Sample Clauses
Related to Limit States Design
Project Administration Designation Pursuant to Paragraph (B) of Rule 164-1-21 of the Administrative Code, the Recipient shall designate its Chief Executive Officer, Chief Fiscal Officer and Project Manager in Appendix B of this Agreement. Changes in these designations must be made in writing.
WASHINGTON’S STATEWIDE PAYEE DESK Contractor represents and warrants that Contractor is registered with Washington’s Statewide Payee Desk, which registration is a condition to payment.
Owner’s Designated Representative Prior to the start of construction, Owner will identify the Owner’s Designated Representative (ODR), who has the express authority to act and bind the Owner to the extent and for the purposes described in the Contract, including responsibilities for general administration of the Contract. 3.1.2.1 Unless otherwise specifically defined elsewhere in the Contract Documents, the ODR is the single point of contact between the Owner and Contractor. Notice to the ODR, unless otherwise noted, constitutes notice to the Owner under the Contract. 3.1.2.2 All directives on behalf of the Owner will be conveyed to the Contractor by the ODR in writing.
Country Specific Terms Appendix A contains additional terms and conditions of the Agreement applicable to Participants residing in those countries. In addition, Appendix A also contains information and notices of exchange control and certain other issues of which the Participant should be aware.
Payments for Distribution Assistance and Administrative Support Services (a) Payments to the Distributor. In consideration of the payments made by the Fund to the Distributor under this Plan, the Distributor shall provide administrative support services and distribution services to the Fund. Such services include distribution assistance and administrative support services rendered in connection with Shares (1) sold in purchase transactions, (2) issued in exchange for shares of another investment company for which the Distributor serves as distributor or sub-distributor, or (3) issued pursuant to a plan of reorganization to which the Fund is a party. If the Board believes that the Distributor may not be rendering appropriate distribution assistance or administrative support services in connection with the sale of Shares, then the Distributor, at the request of the Board, shall provide the Board with a written report or other information to verify that the Distributor is providing appropriate services in this regard. For such services, the Fund will make the following payments to the Distributor:
Series Designation The Series Designation establishing a Series may: (i) specify a name or names under which the business and affairs of such Series may be conducted; (ii) designate, fix and determine the relative rights, powers, authority, privileges, preferences, duties, responsibilities, liabilities and obligations in respect of Interests of such Series and the Members associated therewith (to the extent such terms differ from those set forth in this Agreement) and (iii) designate or authorize the designation of specific Officers to be associated with such Series. A Series Designation (or any resolution of the Managing Member amending any Series Designation) shall be effective when a duly executed original of the same is included by the Managing Member among the permanent records of the Company, and shall be annexed to, and constitute part of, this Agreement (it being understood and agreed that, upon such effective date, the Series described in such Series Designation shall be deemed to have been established and the Interests of such Series shall be deemed to have been authorized in accordance with the provisions thereof). The Series Designation establishing a Series may set forth specific provisions governing the rights of such Series against a Member associated with such Series who fails to comply with the applicable provisions of this Agreement (including, for the avoidance of doubt, the applicable provisions of such Series Designation). In the event of a conflict between the terms and conditions of this Agreement and a Series Designation, the terms and conditions of the Series Designation shall prevail.
Method of Electing Interest Rates (a) The Loans included in each Committed Borrowing shall bear interest initially at the type of rate specified by the Borrower in the applicable Notice of Committed Borrowing. Thereafter, the Borrower may from time to time elect to change or continue the type of interest rate borne by each Group of Loans (subject to Section 2.08(d) and the provisions of Article 8), as follows: (i) if such Loans are Base Rate Loans, the Borrower may elect to convert such Loans to Euro-Dollar Loans as of any Euro-Dollar Business Day; (ii) if such Loans are Euro-Dollar Loans, the Borrower may elect to convert such Loans to Base Rate Loans as of any Domestic Business Day, subject to Section 2.14 if any such conversion is effective on any day other than the last day of an Interest Period applicable to such Loans, or may elect to continue such Loans as Euro-Dollar Loans, as of the end of any Interest Period applicable thereto, for an additional Interest Period. Each such election shall be made by delivering a notice (a “Notice of Interest Rate Election”) to the Administrative Agent not later than 10:30 A.M. (New York City time) on the third Euro-Dollar Business Day before the conversion or continuation selected in such notice is to be effective. A Notice of Interest Rate Election may, if it so specifies, apply to only a portion of the aggregate principal amount of the relevant Group of Loans; provided that (i) such portion is allocated ratably among the Loans comprising such Group and (ii) such portion, and the remaining portion to which such Notice does not apply, are each at least $10,000,000 (unless such portion is comprised of Base Rate Loans). If no such notice is timely received before the end of an Interest Period for any Group of Euro-Dollar Loans, the Borrower shall be deemed to have elected that such Group of Loans be converted to Base Rate Loans at the end of such Interest Period. (b) Each Notice of Interest Rate Election shall specify: (i) the Group of Loans (or portion thereof) to which such notice applies; (ii) the date on which the conversion or continuation selected in such notice is to be effective, which shall comply with the applicable clause of Section 2.08(a); (iii) if the Loans comprising such Group are to be converted to Euro-Dollar Loans, the duration of the next succeeding Interest Period applicable thereto; and (iv) if such Loans are to be continued as Euro-Dollar Loans for an additional Interest Period, the duration of such additional Interest Period. Each Interest Period specified in a Notice of Interest Rate Election shall comply with the provisions of the definition of Interest Period. (c) Promptly after receiving a Notice of Interest Rate Election from the Borrower pursuant to Section 2.08(a), the Administrative Agent shall notify each Bank of the contents thereof and such notice shall not thereafter be revocable by the Borrower. (d) The Borrower shall not be entitled to elect to convert any Committed Loans to, or continue any Committed Loans for an additional Interest Period as, Euro-Dollar Loans if (i) the aggregate principal amount of any Group of Euro-Dollar Loans created or continued as a result of such election would be less than $10,000,000 or (ii) a Default shall have occurred and be continuing when the Borrower delivers notice of such election to the Administrative Agent. (e) If any Committed Loan is converted to a different Type of Loan, the Borrower shall pay, on the date of such conversion, the interest accrued to such date on the principal amount being converted.
Initial Decision Maker The Architect will serve as the Initial Decision Maker pursuant to Article 15 of AIA Document A201–2017, unless the parties appoint below another individual, not a party to this Agreement, to serve as the Initial Decision Maker.
CONTRACT DATA The Consultant is advised to read the NEC3 Professional Service Contract (Third edition with amendments of June 2006 and April 2013) and the relevant Guidance Notes and Flow Charts, published by the Institution of Civil Engineers, in order to understand the implications of this Data which is required. Copies of these documents may be obtained from the Engineering Contract Strategies (telephone (00) 000 000 0000). Each item of data given below is cross-referenced to the clause in the NEC3 Professional Service Contract to which it mainly applies.
Country-Specific Provisions Argentina
