Limitation on Out of-State Litigation - Texas Business and Commerce Code § 272 This is a requirement of the TIPS Contract and is non-negotiable. Texas Business and Commerce Code § 272 prohibits a construction contract, or an agreement collateral to or affecting the construction contract, from containing a provision making the contract or agreement, or any conflict arising under the contract or agreement, subject to another state’s law, litigation in the courts of another state, or arbitration in another state. If included in Texas construction contracts, such provisions are voidable by a party obligated by the contract or agreement to perform the work. By submission of this proposal, Vendor acknowledges this law and if Vendor enters into a construction contract with a Texas TIPS Member under this procurement, Vendor certifies compliance.
Limitation on Services Except in cases of Emergency Services or Urgent Care, or as otherwise provided under this Certificate, services are available only from Participating Providers and HMO shall have no liability or obligation whatsoever on account of any service or benefit sought or received by a Member from any Physician, Hospital, Skilled Nursing Facility, home health care agency, or other person, entity, institution or organization unless prior arrangements are made by HMO.
Limitation on Use Tenant shall use the Premises solely for the Permitted Use specified in Section N of the Summary. There shall not be any change in use without the prior written consent of Landlord which will not be unreasonably withheld. Tenant shall not do anything in or about the Premises which will (i) cause structural injury to the Building, or (ii) cause damage to any part of the Building except to the extent reasonably necessary for the installation of Tenant’s Trade Fixtures and Tenant’s Alterations, and then only in a manner which has been first approved by Landlord in writing. Tenant shall not operate any equipment within the Premises which will (i) materially damage the Building or the Common Area, (ii) overload existing electrical systems or other mechanical equipment servicing the Building, (iii) impair the efficient operation of the sprinkler system or the heating, ventilating or air conditioning (“HVAC”) equipment within or servicing the Building, or (iv) damage, overload or corrode the sanitary sewer system. Tenant shall not attach, hang or suspend anything from the ceiling, roof, walls or columns of the Building or set any load on the floor in excess of the load limits for which such items are designed nor operate hard wheel forklifts within the Premises. Any dust, fumes, or waste products generated by Tenant’s use of the Premises shall be contained and disposed so that they do not (i) create an unreasonable fire or health hazard, (ii) damage the Premises, or (iii) result in the violation of any Law. Except as approved by Landlord, Tenant shall not change the exterior of the Building or install any equipment or antennas on or make any penetrations of the exterior or roof of the Building. Tenant shall not commit any waste in or about the Premises, and Tenant shall keep the Premises in a neat, clean, attractive and orderly condition, free of any nuisances. If Landlord designates a standard window covering for use throughout the Building, Tenant shall use this standard window covering to cover all windows in the Premises. Tenant shall not conduct on any portion of the Premises or the Project any sale of any kind, including any public or private auction, fire sale, going-out-of-business sale, distress sale or other liquidation sale.
Limitation on Benefits (a) It is the intention of the Executive and of the Employers that no payments by the Employers to or for the benefit of the Executive under this Agreement and/or any other agreement or plan pursuant to which the Executive is entitled to receive payments or benefits shall be non-deductible to the Employers by reason of the operation of Section 280G of the Code relating to parachute payments. Accordingly, and notwithstanding any other provision of this Agreement or any such agreement or plan, if by reason of the operation of said Section 280G, any such payments exceed the amount which can be deducted by the Employers in the aggregate, such payments shall be reduced to the maximum amount which can be deducted by the Employers. To the extent that payments exceeding such maximum deductible amount have been made to or for the benefit of the Executive, such excess payments shall be refunded to the Employers with interest thereon at the applicable Federal Rate determined under Section 1274(d) of the Code, compounded annually, or at such other rate as may be required in order that no such payments shall be non-deductible to the Employers by reason of the operation of said Section 280G. To the extent that there is more than one method of reducing the payments to bring them within the limitations of said Section 280G, the Executive shall determine which method shall be followed, provided that if the Executive fails to make such determination within forty-five days after the Employers have sent him written notice of the need for such reduction, the Employers may determine the method of such reduction in their sole discretion.
Limitation on Damage In the event of a breach of any provision of this contract by the State, the liability of the State shall be limited to return of the unused initial deposit and unapplied payments to the Purchaser. The State shall not be liable for any damages, whether direct, incidental, or consequential.
Limitation on Publication The Contractor shall not publish or submit for publication any article, press release, or other writing relating to the Contractor's services for the Judicial Council without prior review and written permission by the Judicial Council.
Limitation on Warranties Client and Spirent agree that the services are provided “as is” and “as available” and that Spirent makes no warranty as to the services. Spirent disclaims all other warranties, either express or implied, including, without limitation, warranties of merchantability and fitness for a particular purpose. Spirent does not warrant the work performed by client or third-party contractors or that any systems or operation of systems will be defect or error-free.
Limitation on Damages IN NO EVENT SHALL ANY PARTY BE LIABLE TO ANY OTHER PARTY FOR ANY LOST PROFITS OR SPECIAL, CONSEQUENTIAL OR PUNITIVE DAMAGES, EVEN IF INFORMED OF THE POSSIBILITY OF SUCH DAMAGES. THE FOREGOING SHALL BE INTERPRETED AND HAVE EFFECT TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, RULE OR REGULATION.
Limitation of Use The parties agree that this Agreement shall not be proffered by either party in another jurisdiction as evidence of any concession or as a waiver of any position taken by the other party in that jurisdiction or for any other purpose.
Limitation on Payments In the event that the severance and other benefits provided for in this Agreement or otherwise payable to Executive (i) constitute “parachute payments” within the meaning of Section 280G of the Code, and (ii) but for this Section 5, would be subject to the excise tax imposed by Section 4999 of the Code, then Executive’s benefits under Section 3 will be either: