Luminance Test Patterns and Procedures Sample Clauses

Luminance Test Patterns and Procedures. For CRT monitors, the technician shall initiate the AT01P (Alignment Target 01 Positive Mode) pattern (VESA FPDM Standard 2.0, A112-2F, AT01P) for screen size and use it to set the computer monitor to the manufacturer’s recommended image size, which is typically slightly smaller than maximum viewable screen size. Then, test pattern (VESA FPDM Standard 2.0, A112-2F, SET01K) shall be displayed that provides eight shades of gray from full black (0 volts) to full white (0.7 volts).15 Input signal levels shall conform to VESA Video Signal Standard (VSIS), Version 1.0, Rev. 2.0, December 2002. The technician shall adjust (where feasible) the computer monitor brightness control downward from its maximum until the lowest black bar luminance level is just slightly visible (VESA FPDM Standard 2.0, Section 301-3K). The technician shall then display a test pattern (VESA FPDM Standard 2.0, A112-2H, L80) that provides a full white (0.7 volts) box that occupies 80% of the image. The technician shall then adjust the contrast control until the white area of the screen provides at least 100 xxxxxxxx per square meter of luminance, measured according to VESA FPDM Standard 2.0, Section 302-1. For all Fixed Pixel displays (e.g., LCDs and others), test pattern (VESA FPDM Standard 2.0, A112-2F, SET01K) shall be displayed that provides eight shades of gray from full black (0 volts) to full white (0.7 volts).2 Input signal levels shall conform to VESA Video Signal Standard (VSIS), Version 1.0, Rev. 2.0, December 2002. With the brightness and contrast controls at maximum, the 15 Corresponding voltage values for digital only interface monitors that correspond to the brightness of the image (0 to 0.7 volts) are: 0 volts (black) = a setting of 0 0.1 volts (darkest shade of gray analogue) = 36 digital gray 0.7 volts (full white analogue) = 255 digital gray Please note that future digital interface specifications may widen this range, but in all cases, 0 volts shall correspond to black and the maximum value shall correspond to white, with 0.1 white volts corresponding to one-seventh of the maximum value. technician shall check that, at a minimum, the white and near white gray levels can be distinguished. If white and near white gray levels cannot be distinguished, then contrast shall be adjusted until they can be distinguished. The technician shall next display a test pattern (VESA FPDM Standard 2.0, A112-2H, L80) that provides a full white (0.7 volts) box that occupies 80% of the image....
Sample 1
AutoNDA by SimpleDocs

Related to Luminance Test Patterns and Procedures

  • Confidentiality (a) Subject to Section 7.15(c), during the Term and for a period of three

  • Force Majeure If by reason of Force Majeure, either party hereto shall be rendered unable wholly or in part to carry out its obligations under this Agreement then such party shall give notice and full particulars of Force Majeure in writing to the other party within a reasonable time after occurrence of the event or cause relied upon, and the obligation of the party giving such notice, so far as it is affected by such Force Majeure, shall be suspended during the continuance of the inability then claimed, except as hereinafter provided, but for no longer period, and such party shall endeavor to remove or overcome such inability with all reasonable dispatch. Choice of Law The Agreement between the Vendor and TIPS/ESC Region 8 and any addenda or other additions resulting from this procurement process, however described, shall be governed by, construed and enforced in accordance with the laws of the State of Texas, regardless of any conflict of laws principles. Venue, Jurisdiction and Service of Process Any Proceeding arising out of or relating to this procurement process or any contract issued by TIPS resulting from or any contemplated transaction shall be brought in a court of competent jurisdiction in Camp County, Texas and each of the parties irrevocably submits to the exclusive jurisdiction of said court in any such proceeding, waives any objection it may now or hereafter have to venue or to convenience of forum, agrees that all claims in respect of the Proceeding shall be heard and determined only in any such court, and agrees not to bring any proceeding arising out of or relating to this procurement process or any contract resulting from or any contemplated transaction in any other court. The parties agree that either or both of them may file a copy of this paragraph with any court as written evidence of the knowing, voluntary and freely bargained for agreement between the parties irrevocably to waive any objections to venue or to convenience of forum. Process in any Proceeding referred to in the first sentence of this Section may be served on any party anywhere in the world. Venue for any dispute resolution process, other than litigation, between TIPS and the Vendor shall be located in Camp or Xxxxx County, Texas.

  • Miscellaneous The Vendor acknowledges and agrees that continued participation in TIPS is subject to TIPS sole discretion and that any Vendor may be removed from the participation in the Program at any time with or without cause. Nothing in the Agreement or in any other communication between TIPS and the Vendor may be construed as a guarantee that TIPS or TIPS Members will submit any orders at any time. TIPS reserves the right to request additional proposals for items or services already on Agreement at any time.

  • Definitions For purposes of this Agreement:

  • Amendments This Agreement may not be amended, modified or waived as to any particular provision, except by a written instrument executed by all parties hereto.

  • Expenses All costs and expenses incurred in connection with this Agreement shall be paid by the party incurring such cost or expense.

  • Waiver of Jury Trial IN ANY ACTION, SUIT, OR PROCEEDING IN ANY JURISDICTION BROUGHT BY ANY PARTY AGAINST ANY OTHER PARTY, THE PARTIES EACH KNOWINGLY AND INTENTIONALLY, TO THE GREATEST EXTENT PERMITTED BY APPLICABLE LAW, HEREBY ABSOLUTELY, UNCONDITIONALLY, IRREVOCABLY AND EXPRESSLY WAIVES FOREVER TRIAL BY JURY.

  • Governing Law This Agreement shall be governed by and construed in accordance with the laws of the State of New York.

  • Insurance The Company and the Subsidiaries are insured by insurers of recognized financial responsibility against such losses and risks and in such amounts as are prudent and customary in the businesses in which the Company and the Subsidiaries are engaged, including, but not limited to, directors and officers insurance coverage. Neither the Company nor any Subsidiary has any reason to believe that it will not be able to renew its existing insurance coverage as and when such coverage expires or to obtain similar coverage from similar insurers as may be necessary to continue its business without a significant increase in cost.

  • Indemnification In the event any Registrable Securities are included in a Registration Statement under this Agreement:

Time is Money Join Law Insider Premium to draft better contracts faster.