Common use of Manually Resetting the Factory Default IP Address Clause in Contracts

Manually Resetting the Factory Default IP Address. The Transceiver can manually be reset to the default IP Address by moving the jumper (J6) from “Norm” to “Init”. Turn off the power to the Transceiver, and move the jumper from “Norm” to “Init”. Turn on power, and the Transceiver can be communicated with using the Factory Default IP Address 192.168.0.1 Subnet Mask 255.255.255.0. The Config File is no longer active while the jumper is in the “Init” position. A new Config File can be downloaded to the Transceiver if desired. To reactivate the Config File - turn off the power to the Transceiver and move the jumper back to “Norm”. Turn the power back on and the Config File will become active. The Transceiver will have the IP Address that was set in the Config File.

Manually Resetting the Factory Default IP Address. The Transceiver can manually be reset to the default IP Address by moving the jumper (J6) from “Norm” to “Init”. • Turn off the power to the Transceiver, Transceiver and move the jumper from “Norm” to “Init”. Turn on power, power and the Transceiver can be communicated with using the Factory Default IP Address 192.168.0.1 Subnet Mask 255.255.255.0. The Config File is no longer active while the jumper is in the “Init” position. A new Config File can be downloaded to the Transceiver if desired. • To reactivate the Config File - turn off the power to the Transceiver and move the jumper back to “Norm”. Turn the power back on and the Config File will become active. The Transceiver will have the IP Address that was set in the Config File.

Manually Resetting the Factory Default IP Address. ‌ • The Transceiver can manually be reset to the default IP Address by moving the jumper (J6) from “Norm” to “Init”. • Turn off the power to the Transceiver, Transceiver and move the jumper from “Norm” to “Init”. Turn on power, power and the Transceiver can be communicated with using the Factory Default IP Address 192.168.0.1 Subnet Mask 255.255.255.0. The Config File is no longer active while the jumper is in the “Init” positionposition . A new Config File can be downloaded to the Transceiver if desired. • To reactivate the Config File - turn off the power to the Transceiver and move the jumper back to “Norm”. Turn the power back on and the Config File will become active. The Transceiver will have the IP Address that was set in the Config File.

Manually Resetting the Factory Default IP Address. The Transceiver can manually be reset to the default IP Address by moving the jumper (J6) from “Norm” to “Init”. • Turn off the power to the Transceiver, Transceiver and move the jumper from “Norm” to “Init”. Turn on power, power and the Transceiver can be communicated with using the Factory Default IP Address 192.168.0.1 Subnet Mask 255.255.255.0. The Config File is no longer active while the jumper is in the “Init” positionposition . A new Config File can be downloaded to the Transceiver if desired. • To reactivate the Config File - turn off the power to the Transceiver and move the jumper back to “Norm”. Turn the power back on and the Config File will become active. The Transceiver will have the IP Address that was set in the Config File.