Metering Responsibility Clause Samples
The Metering Responsibility clause defines which party is accountable for the installation, maintenance, and accuracy of metering equipment used to measure quantities such as energy, water, or other utilities under the agreement. Typically, this clause specifies whether the supplier, customer, or a third party must ensure meters are properly calibrated, accessible for inspection, and compliant with relevant standards. By clearly assigning responsibility, the clause helps prevent disputes over usage data, billing, and liability for faulty measurements, ensuring transparency and accuracy in resource tracking.
POPULAR SAMPLE Copied 1 times
Metering Responsibility. All meters shall be furnished, installed, maintained and read by the Cooperative.
Metering Responsibility. All revenue metering shall be furnished, installed, maintained and read by the Cooperative.
Metering Responsibility. The responsibility for the presence of a Metering Device at the Transfer Point of the Connection which system complies with the requirements set out in the Metering Code(s) and for correctly and promptly establishing and transferring, or causing the establishment or transfer of, metering data. One or more connections for the transmission of electricity and/or gas and the associated transformer, switching, distribution stations and substations and other resources, except insofar as these connections and resources form part of a direct line or are located within a Customer’s Electrical System and/or Gas System as referred to in the Electricity Act 1998 and/or the Gas Act. A company designated for the operation of one or more (gas transmission) grids as referred to in Article 1(1)(k) of the Electricity Act 1998 or Article 1(1)(e) of the Gas Act. The recording and processing of data from a Metering installation to which no Metering Code applies. Independent Service Provider, a party certified by Energie Data Service Nederland (EDSN) which has the option of requesting consumption data and meter readings for small consumption gas and electricity connections from the regional network operators.
Metering Responsibility. (a) Installation of Metering Equipment - Muskrat shall supply, install, maintain, and pay for the Metering Equipment which shall be utilized to measure and record the Energy produced by the MF Plant or the CFLCo Plant and delivered to the LTA, including power quality parameters specified by NLH. Muskrat shall comply with all Applicable Law regarding the supply, installation and maintenance of the Metering Equipment and such Metering Equipment shall meet the applicable requirements established by Measurement Canada. Applicable requirements include, but are not limited to, ensuring the meters are sealed by Measurement Canada and that the re- seal/re-test of the meters is completed when the seal period expires. The Metering Equipment shall be Measurement Canada approved and Muskrat shall deliver to NLH the notice of approval number issued by Measurement Canada. Muskrat shall install and maintain at its cost a back up meter with the capability to record at least 45 days of data. Muskrat shall advise NLH of any changes to the Metering Equipment in advance or, if advance notice cannot be provided, within 48 hours of the change being made.
Metering Responsibility