Method of Measurement The harmonics emission on AC power lines generated by the vehicle representative of its type shall be measured using the method described in Annex 11. The method of measurement shall be defined by the vehicle manufacturer in accordance with the Technical Service.
Method of Selection Bidder will be selected under Cost Based Selection-L1 (CBS) and procedures described in this Tender Document.
Criteria for Selection a. The Sabbatical Selection Committee shall use four (4) criteria for selection of academic employees to receive sabbaticals. These are: the merit of the sabbatical project, the applicant’s current and previous contributions to the College community, the proposal’s relevancy to the College’s Strategic Plan and whether or not the applicant has had a previous sabbatical. In instances where these criteria are equal, seniority shall be the determining factor.
Deadline for Submission of Bids 19.1 Bids must be received by the Purchaser at the address specified under ITB Clause 18.2 no later than the time and date specified in the Bid Data Sheet. 19.2 The Purchaser may, at its discretion, extend this deadline for the submission of bids by amending the bidding documents in accordance with ITB Clause 7, in which case all rights and obligations of the Purchaser and bidders previously subject to the deadline will thereafter be subject to the deadline as extended.
Sole Source as Grounds for Rejection of a Change Order If a Change Order is submitted to Contractor for the purposes of adding a Bulletin to this Contract and said Bulletin designates a Sole Source from which Contractor is required to procure goods or services necessary to perform the Work, which Sole Source has not been designated previously, Contractor shall be entitled to reject the proposed Change Order if the designated Sole Source refuses to provide to Contractor the warranties, bonds, terms or schedule required under the Contract Documents, including any warranty or terms or schedule required by Bulletins referenced in the proposed Change Order. In such event, Contractor shall give written notice to the Owner rejecting the proposed Change Order and, if possible, shall accompany said written notice with a proposal from Contractor for changes or modifications to the Bulletin so as to eliminate the Sole Source designation but to achieve goods or services equal in quality or function. The Owner may then require the Design Professional to revise the subject Bulletin so as to eliminate the designation of the Sole Source by incorporation of Contractor's proposal or otherwise. Upon revision of the Bulletin by the Design Professional and approval thereof by the Owner, the Owner shall again submit to the Contractor a proposed Change Order for the purpose of adding the revised Bulletin to this Contract. If the Owner decides to retain the Sole Source in the Change Order and Contractor cannot acquire the full contractually required warranties from the Sole Source, Contractor shall be held only to the warranty terms and schedule obtainable from the Sole Source.
Method of Notice All notices shall be given (i) by delivery in person (ii) by a nationally recognized next day courier service, (iii) by first class, registered or certified mail, postage prepaid, (iv) by facsimile, or (v) by electronic mail] to the address of the OETC Contract Administrator or Contractor's Contract Coordinator or such other address as either party may specify in writing.
Deliverables for an Authorized User Agreement (Transaction Deliverables must be identified, as a measure of progress in the Authorized User Agreement. A Deliverable as a bulk number of hours is not permissible under the OGS Centralized Contract. Retainage As part of the Mini-Bid, the Authorized User may elect to retain a percentage of each individual Deliverable payment of no more than 20% until the acceptance of the complete Deliverable or project. This retainage may be reduced as described in the Mini-Bid, when the Contractor substantially reduces the time required from the timeframes negotiated between the Authorized User and the Contractor for the completion and acceptance of a Deliverable.
Selection Criteria for Awarding Task Order The Government will award to the offeror whose proposal is deemed most advantageous to the Government based upon an integrated assessment using the evaluation criteria. The Government will evaluate proposals against established selection criteria specified in the task order RFP. Generally, the Government's award decision will be based on selection criteria which addresses past performance, technical acceptability, proposal risk and cost. Among other sources, evaluation of past performance may be based on past performance assessments provided by TO Program Managers on individual task orders performed throughout the life of the contract. The order of importance for the factors will be identified in the RFP for the specified task order.
Method of Calculation The Finance Charge on my account is calculated by multiplying the number of days in the billing period by the daily periodic rate and multiplying the result by the "average daily balance". The "daily periodic rate" is the corresponding Annual Percentage Rate divided by 365. The "average daily balance" is figured by taking the beginning balance each day, adding any new advances, purchases, fees, or adjustments, and subtracting any payments or credits. The result is the daily balance, then all daily balances for the billing period are added together and the result is divided by the number of days in the billing period. To avoid paying Finance Charges on Purchase Transactions, the entire outstanding balance of all Purchase, Cash Advance, and Balance Transfer transactions as of the statement date and any Cash Advance or Balance Transfer transactions posted after the statement date, plus any Finance Charges and fees must be paid in full by the due date or the Finance Charge will be assessed from the date each purchase transaction posted. I cannot avoid Interest Charges on Cash Advance and Balance Transfers. Cash Advance and Balance Transfer transactions accrue interest immediately beginning on the date the transaction posts to the account. When there are different rates for purchase, cash advances, or balance transfers, separate average daily balances for each will be calculated and the appropriate periodic rate is then applied to each balance. Purchases and Cash Advances. I may use my card to buy goods and services anywhere it is accepted. I may also use my card to borrow cash from you by making cash advances at any financial institution or ATM (Automated Teller Machine) that accepts it. Making Payment. I will be sent a combined statement each month that shows me the new card account balance. I may pay the entire balance owing at any time, or I may pay in monthly installments. My monthly statement will show the minimum payment I must make and the date when you must receive the payment. My payment of the minimum payment due may be applied to what I owe the Credit Union in any manner you choose. If I make a payment in excess of the required minimum payment due, you will allocate the excess amount first to the balance with the highest annual percentage rate "APR" and any remaining portion to the other balances in descending order based on the next highest APR, as of the date you receive my payment unless otherwise prescribed by law. Other Charges. If I request copies of charge slips or statements, you can charge me a per item fee to cover the cost of finding and duplicating them. If I dispute a charge on my account, and after investigation it is found to be my charge, you can charge a fee to cover the cost of the research. The costs for such services is available in the Fee Schedule posted at each branch and you will provide me information regarding the current costs for such services at the time I make my request. My Credit Limit. From time to time, you may adjust my maximum credit limit. I agree to keep the total of purchases and cash advances made on my account within this limit. Exceeding Credit Limit. I understand that any amount charged over my credit limit will be immediately due and payable in addition to my regularly scheduled payment. The amount over limit will be reflected under the "Past Due" field on my statement and will be added to the "Current Payment". The total amount I will be required to pay in that billing cycle will include the amount exceeding the credit limit and all other amounts that would otherwise be due for that billing cycle.
Procedure for Approving Settlement a. Unopposed Motion for Preliminary Approval of the Settlement by the Court.
