MFT means Marriage and Family Therapist and refers to an individual who meets the 15 minimum professional and licensure requirements set forth in CCR, Title 9, Section 625.
MFT means Marriage and Family Therapist and refers to an individual who Sample Clauses
Related to MFT means Marriage and Family Therapist and refers to an individual who
Geographic Area and Sector Specific Allowances, Conditions and Exceptions The following allowances and conditions shall apply where relevant. Where the Employer does work which falls under the following headings, the Employer agrees to pay and observe the relevant respective conditions and/or exceptions set out below in each case.
File Management and Record Retention relating to CRF Eligible Persons or Households Grantee must maintain a separate file for every applicant, Eligible Person, or Household, regardless of whether the request was approved or denied. a. Contents of File: Each file must contain sufficient and legible documentation. Documents must be secured within the file and must be organized systematically.
CERTIFICATION PROHIBITING DISCRIMINATION AGAINST FIREARM AND AMMUNITION INDUSTRIES (Texas law as of September 1, 2021) By submitting a proposal to this Solicitation, you certify that you agree, when it is applicable, to the following required by Texas law as of September 1, 2021: If (a) company is not a sole proprietorship; (b) company has at least ten (10) full-time employees; (c) this contract has a value of at least $100,000 that is paid wholly or partly from public funds; (d) the contract is not excepted under Tex. Gov’t Code § 2274.003 of SB 19 (87th leg.); and (e) governmental entity has determined that company is not a sole-source provider or governmental entity has not received any bids from a company that is able to provide this written verification, the following certification shall apply; otherwise, this certification is not required. Pursuant to Tex. Gov’t Code Ch. 2274 of SB 19 (87th session), the company hereby certifies and verifies that the company, or association, corporation, partnership, joint venture, limited partnership, limited liability partnership, or limited liability company, including a wholly owned subsidiary, majority-owned subsidiary parent company, or affiliate of these entities or associations, that exists to make a profit, does not have a practice, policy, guidance, or directive that discriminates against a firearm entity or firearm trade association and will not discriminate during the term of this contract against a firearm entity or firearm trade association. For purposes of this contract, “discriminate against a firearm entity or firearm trade association” shall mean, with respect to the entity or association, to: “ (1) refuse to engage in the trade of any goods or services with the entity or association based solely on its status as a firearm entity or firearm trade association; (2) refrain from continuing an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association; or (3) terminate an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association. See Tex. Gov’t Code § 2274.001(3) of SB 19. “Discrimination against a firearm entity or firearm trade association” does not include: “ (1) the established policies of a merchant, retail seller, or platform that restrict or prohibit the listing or selling of ammunition, firearms, or firearm accessories; and (2) a company’s refusal to engage in the trade of any goods or services, decision to refrain from continuing an existing business relationship, or decision to terminate an existing business relationship to comply with federal, state, or local law, policy, or regulations or a directive by a regulatory agency, or for any traditional business reason that is specific to the customer or potential customer and not based solely on an entity’s or association’s status as a firearm entity or firearm trade association.” See Tex. Gov’t Code § 2274.001(3) of SB 19.
Domestic Partners; Spouses; Gender Discrimination If the Contract Amount is $100,000 or more, Contractor certifies that it is in compliance with PCC 10295.3, which places limitations on contracts with contractors who discriminate in the provision of benefits regarding marital or domestic partner status.
Please see the current Washtenaw Community College catalog for up-to-date program requirements Conditions & Requirements
Transfer and Seniority Outside the Bargaining Unit (a) It is understood that an employee shall not be transferred by the Hospital to a position outside the bargaining unit without his consent except in the case of temporary assignments not exceeding six (6) months. Such employees on temporary assignments shall remain members of the bargaining unit. (b) An employee who is transferred to a position outside the bargaining unit shall not, subject to (c) below, accumulate seniority. In the event the employee is returned by the Hospital to a position in the bargaining unit within twenty-four (24) months of the transfer he or she shall be credited with the seniority held at the time of transfer and resume accumulation from the date of his or her return to the bargaining unit. An employee not returned to the bargaining unit within 24 months shall forfeit bargaining unit seniority. (c) In the event an employee transferred out of the bargaining unit under (b) above is returned to the bargaining unit within a period of six (6) calendar months, he shall accumulate seniority during the period of time outside the bargaining unit."
Family Medical Leave or Critical Illness Leave a) Family Medical Leave or Critical Illness leaves granted to a permanent teacher, long-term occasional teacher or teacher hired into a term position under this Article shall be in accordance with the provisions of the Employment Standards Act, as amended. b) The teacher will provide to the employer such evidence as necessary to prove entitlement under the Employment Standards Act. c) A teacher contemplating taking such leave(s) shall notify the employer of the intended date the leave is to begin and the anticipated date of return to active employment. d) Seniority and experience continue to accrue during such leave(s). e) Where a teacher is on such leave(s), the Employer shall continue to pay its share of the benefit premiums, where applicable. To maintain participation and coverage under the Collective Agreement, the teacher must agree to provide for payment for the teacher’s share of the benefit premiums, where applicable. f) In order to receive pay for such leaves, a teacher must access Employment Insurance and the Supplemental Employment Benefit (SEB) in accordance with g) to j), if allowable by legislation. An employee who is eligible for E.I. is not entitled to benefits under a school board’s sick leave and short term disability plan. g) The Employer shall provide for permanent teachers, long-term occasional teachers and teachers hired into a term position who access such Leaves, a SEB plan to top up their E.I.
CFR PART 200 Domestic Preferences for Procurements As appropriate and to the extent consistent with law, the non-Federal entity should, to the greatest extent practicable under a Federal award, provide a preference for the purchase, acquisition, or use of goods, products, or materials produced in the United States (including but not limited to iron, aluminum, steel, cement, and other manufactured products). The requirements of this section must be included in all subawards including all contracts and purchase orders for work or products under this award. For purposes of 2 CFR Part 200.322, “Produced in the United States” means, for iron and steel products, that all manufacturing processes, from the initial melting stag through the application of coatings, occurred in the United States. Moreover, for purposes of 2 CFR Part 200.322, “Manufactured products” means items and construction materials composed in whole or in part of non-ferrous metals such as aluminum, plastics and polymer-based products such as polyvinyl chloride pipe, aggregates such as concrete, class, including optical fiber, and lumber. Pursuant to the above, when federal funds are expended by ESC Region 8 and TIPS Members, Vendor certifies that to the greatest extent practicable Vendor will provide a preference for the purchase, acquisition, or use of goods, products, or materials produced in the United States (including but not limited to iron, aluminum, steel, cement, and other manufactured products). Does vendor agree? Yes
Certification of Meeting or Exceeding Tobacco-Free Workplace Policy Minimum Standards A. Grantee certifies that it has adopted and enforces a Tobacco-Free Workplace Policy that meets or exceeds all of the following minimum standards of: i. Prohibiting the use of all forms of tobacco products, including but not limited to cigarettes, cigars, pipes, water pipes (hookah), bidis, kreteks, electronic cigarettes, smokeless tobacco, snuff and chewing tobacco; ii. Designating the property to which this Policy applies as a "designated area,” which must at least comprise all buildings and structures where activities funded under this Grant Agreement are taking place, as well as Grantee owned, leased, or controlled sidewalks, parking lots, walkways, and attached parking structures immediately adjacent to this designated area; iii. Applying to all employees and visitors in this designated area; and iv. Providing for or referring its employees to tobacco use cessation services. B. If Grantee cannot meet these minimum standards, it must obtain a waiver from the System Agency.
Family Educational Rights and Privacy Act The Charter School is subject to all provisions of the Federal Family Educational Rights and Privacy Act, 20 U.S.C. § 1232g. In the event the Charter School closes, it shall transmit all official student records in the manner prescribed by the State Board.
