Molding Compound Sample Clauses

Molding Compound. Enhancement New resin formulations and additives will be developed to provide properties for enhanced reliability. The metric improvements listed use the current low-stress molding compounds as benchmark. * Reduce water uptake by 50% for improved leadframe adhesion and better anti-popcorning * Increase the hot strength at 240 deg C by a factor of 2. * Lower the stress index by at least 25% * Increase the Tg of the anti-popcorning compound from 000 xxx X xx 000 xxx * Decrease the cure time by 25% * Lower compound viscosity by 25%
AutoNDA by SimpleDocs
Molding Compound. Enhancement The molding compound must satisfy two functional requirements, high thermal dissipation and high thermal performance. The goals are to: * Increase thermal conductivity from the current 0.4-0.5 W/m K * Evaluate new resin materials and fillers for enhanced thermal dissipation and thermal performance. * Promote good interfacial adhesion to all components, including heat spreaders and heat slugs

Related to Molding Compound

  • Research Collaboration (a) GSK hereby grants to Anacor a non-exclusive, non-royalty bearing license under the GSK IP, solely as and to the extent necessary or important to conduct activities for which Anacor is responsible under the Research Plans during the Research Collaboration Term.

  • Formation; Composition Each Party will initially appoint [***] representatives to the JCC, with each representative having knowledge and expertise in the commercialization of products similar to the Regional Licensed Products and having sufficient seniority within the applicable Party to make decisions arising within the scope of the JCC’s responsibilities. The JCC may change its size from time to time by mutual consent of its members, provided that the JCC will consist at all times of an equal number of representatives of each of Surface and Novartis. Each Party may replace its JCC representatives at any time upon written notice to the other Party. The JCC may invite non-members to participate in the discussions and meetings of the JCC, provided that such participants have no voting authority at the JCC and are bound under written obligation of confidentiality no less protective of the Parties’ Confidential Information than those set forth in this Agreement. The JCC will be co-chaired, with one chairperson designated by Surface and [***] designated by Novartis, whose responsibilities will include conducting meetings, including, when feasible, ensuring that objectives for each meeting are set and achieved. Responsibility for running each meeting of the JCC will alternate between the chairpersons from meeting-to-meeting, with Novartis’s chairperson running the first meeting. CERTAIN CONFIDENTIAL PORTIONS OF THIS EXHIBIT WERE OMITTED AND REPLACED WITH “[***]”. A COMPLETE VERSION OF THIS EXHIBIT HAS BEEN FILED SEPARATELY WITH THE SECRETARY OF THE SECURITIES AND EXCHANGE COMMISSION PURSUANT TO AN APPLICATION REQUESTING CONFIDENTIAL TREATMENT PURSUANT TO RULE 406 PROMULGATED UNDER THE SECURITIES ACT OF 1933, AS AMENDED.

  • Licensed Product “Licensed Product” shall mean any article, composition, apparatus, substance, chemical material, method, process or service whose manufacture, use, or sale is covered or claimed by a Valid Claim within the Patent Rights. For clarity, a “Licensed Product” shall not include other product or material that (a) is used in combination with Licensed Product, and (b) does not constitute an article, composition, apparatus, substance, chemical material, method, process or service whose manufacture, use, or sale is covered or claimed by a Valid Claim within the Patent Rights.

  • Combination Product The term “

  • Clinical Studies The animal and other preclinical studies and clinical trials conducted by the Company or on behalf of the Company were, and, if still pending are, to the Company’s knowledge, being conducted in all material respects in compliance with all Applicable Laws and in accordance with experimental protocols, procedures and controls generally used by qualified experts in the preclinical study and clinical trials of new drugs and biologics as applied to comparable products to those being developed by the Company; the descriptions of the results of such preclinical studies and clinical trials contained in the Registration Statement and the Prospectus are accurate and complete in all material respects, and, except as set forth in the Registration Statement and the Prospectus, the Company has no knowledge of any other clinical trials or preclinical studies, the results of which reasonably call into question the clinical trial or preclinical study results described or referred to in the Registration Statement and the Prospectus when viewed in the context in which such results are described; and the Company has not received any written notices or correspondence from the FDA, the EMA, or any other domestic or foreign governmental agency requiring the termination, suspension or modification of any preclinical studies or clinical trials conducted by or on behalf of the Company that are described in the Registration Statement and the Prospectus or the results of which are referred to in the Registration Statement and the Prospectus.

  • Product The term “

  • Committee Composition The Plan shall be administered by a Committee appointed by the Board, or by the Board acting as the Committee. The Committee shall consist of two or more directors of the Company. In addition, to the extent required by the Board, the composition of the Committee shall satisfy (i) such requirements as the Securities and Exchange Commission may establish for administrators acting under plans intended to qualify for exemption under Rule 16b-3 (or its successor) under the Exchange Act; and (ii) such requirements as the Internal Revenue Service may establish for outside directors acting under plans intended to qualify for exemption under Section 162(m)(4)(C) of the Code.

  • Combination Products If a LICENSED PRODUCT is sold to any third party in combination with other products, devices, components or materials that are capable of being sold separately and are not subject to royalties hereunder (“OTHER PRODUCTS,” with the combination of products being referred to as “COMBINATION PRODUCTS” and the Other Product and Licensed Product in such Combination Product being referred to as the “COMPONENTS”), the NET SALES of such LICENSED PRODUCT included in such COMBINATION PRODUCT shall be calculated by multiplying the NET SALES of the COMBINATION PRODUCT by the fraction A/(A+B), where A is the average NET SALES price of such LICENSED PRODUCT in the relevant country, as sold separately, and B is the total average NET SALES price of all OTHER PRODUCTS in the COMBINATION PRODUCT in the relevant country, as sold separately. If, in any country, any COMPONENT is not sold separately, NET SALES for royalty determination shall be determined by the formula [C / (C+D)], where C is the aggregate average fully absorbed cost of the Licensed Product components during the prior Royalty Period and D is the aggregate average fully absorbed cost of the other essential functional components during the prior Royalty Period, with such costs being determined in accordance with generally accepted accounting principles. To the extent that any SUBLICENSE INCOME relates to a COMBINATION PRODUCT or is otherwise calculated based on the value of one or more licenses or intellectual property rights held by the COMPANY, an AFFILIATE or SUBLICENSEE, COMPANY shall determine in good faith and report to THE PARTIES the share of such payments reasonably attributable to COMPANY’s or such AFFILIATE’s sublicense of the rights granted hereunder, based upon their relative importance and proprietary protection, which portion shall be the SUBLICENSE INCOME. THE PARTIES shall have the right to dispute such sharing determination in accordance with the dispute provisions of the AGREEMENT.

  • Product Testing Upon request, Customer shall provide Operator a laboratory report for each Product delivery by Customer or Customer’s supplier. Operator will not be obligated to receive Contaminated Product for throughput through the Pipelines, nor will Operator be obligated to accept Product that fails to meet the applicable quality specifications for the Berths under the BAUTA and any Terminal Service Orders issued thereunder.

  • Board Composition Each Stockholder agrees to vote, or cause to be voted, all Shares owned by such Stockholder, or over which such Stockholder has voting control, from time to time and at all times, in whatever manner as shall be necessary to ensure that at each annual or special meeting of stockholders at which an election of directors is held or pursuant to any written consent of the stockholders, the following persons shall be elected to the Board:

Time is Money Join Law Insider Premium to draft better contracts faster.