Supplemental Provisions All of the terms, conditions, representations, warranties, covenants and other provisions, if any, set forth in the supplemental provisions attached hereto as Schedule 2 (the “Supplemental Provisions”) are hereby incorporated into this Contract and shall be considered a part hereof. In the event of any conflict or inconsistency between the Supplemental Provisions and the other provisions of this Contract, the Supplemental Provisions shall control.
Environmental Provisions 1. In performance of this contract the Contractor undertakes to comply with the environmental aspects hereof and with any other comparable conditions laid down in the specifications and detailed, where appropriate, in the Contractor’s tender. 2. The European Parliament reserves the right to carry out itself any inspections and checks on the Contractor which are necessary to ensure compliance with the environmental requirements laid down. Such inspections and checks may be carried out in part or in full by an external body duly authorised by the European Parliament. 3. Any failure on the Contractor’s part to comply with the environmental obligations laid down or any refusal to allow inspection by the European Parliament or a duly authorised body shall entitle the European Parliament to terminate this contract.
CFR Part 200 or Federal Provision Xxxx Anti-Lobbying Amendment - Continued If you answered "No, Vendor does not certify - Lobbying to Report" to the above attribute question, you must download, read, execute, and upload the attachment entitled "Disclosure of Lobbying Activities - Standard Form - LLL", as instructed, to report the lobbying activities you performed or paid others to perform. Compliance with all applicable standards, orders, or requirements issued under section 306 of the Clean Air Act (42 U.S.C. 1857(h)), section 508 of the Clean Water Act (33 U.S.C. 1368), Executive Order 11738, and Environmental Protection Agency regulations (40 CFR part 15). (Contracts, subcontracts, and subgrants of amounts in excess of $100,000) Pursuant to the above, when federal funds are expended by ESC Region 8 and TIPS Members, ESC Region 8 and TIPS Members requires the proposer certify that in performance of the contracts, subcontracts, and subgrants of amounts in excess of $250,000, the vendor will be in compliance with all applicable standards, orders, or requirements issued under section 306 of the Clean Air Act (42 U.S.C. 1857(h)), section 508 of the Clean Water Act (33 U.S.C. 1368), Executive Order 11738, and Environmental Protection Agency regulations (40 CFR part 15). Does vendor certify compliance? Yes A non-Federal entity that is a state agency or agency of a political subdivision of a state and its contractors must comply with section 6002 of the Solid Waste Disposal Act, as amended by the Resource Conservation and Recovery Act. The requirements of Section 6002 include: (1) procuring only items designated in guidelines of the Environmental Protection Agency (EPA) at 40 CFR part 247 that contain the highest percentage of recovered materials practicable, consistent with maintaining a satisfactory level of competition, where the purchase price of the item exceeds $10,000 or the value of the quantity acquired during the preceding fiscal year exceeded $10,000; (2) procuring solid waste management services in a manner that maximizes energy and resource recovery; and establishing an affirmative procurement program for procurement of recovered materials identified in the EPA guidelines. Does vendor certify that it is in compliance with these provisions? Yes If the Federal award meets the definition of “funding agreement” under 37 CFR §401.2 (a) and the recipient or subrecipient wishes to enter into a contract with a small business firm or nonprofit organization regarding the substitution of parties, assignment or performance of experimental, developmental, or research work under that “funding agreement,” the recipient or subrecipient must comply with the requirements of 37 CFR Part 401, “Rights to Inventions Made by Nonprofit Organizations and Small Business Firms Under Government Grants, Contracts and Cooperative Agreements,” and any implementing regulations issued by the awarding agency. Pursuant to the above, when the foregoing applies to ESC Region 8 and TIPS Members, Vendor certifies that during the term of an award resulting from this procurement process, Vendor agrees to comply with all applicable requirements as referenced in the Federal rule above. Does vendor certify? Yes
CERTIFICATION PROHIBITING DISCRIMINATION AGAINST FIREARM AND AMMUNITION INDUSTRIES (Texas law as of September 1, 2021) By submitting a proposal to this Solicitation, you certify that you agree, when it is applicable, to the following required by Texas law as of September 1, 2021: If (a) company is not a sole proprietorship; (b) company has at least ten (10) full-time employees; (c) this contract has a value of at least $100,000 that is paid wholly or partly from public funds; (d) the contract is not excepted under Tex. Gov’t Code § 2274.003 of SB 19 (87th leg.); and (e) governmental entity has determined that company is not a sole-source provider or governmental entity has not received any bids from a company that is able to provide this written verification, the following certification shall apply; otherwise, this certification is not required. Pursuant to Tex. Gov’t Code Ch. 2274 of SB 19 (87th session), the company hereby certifies and verifies that the company, or association, corporation, partnership, joint venture, limited partnership, limited liability partnership, or limited liability company, including a wholly owned subsidiary, majority-owned subsidiary parent company, or affiliate of these entities or associations, that exists to make a profit, does not have a practice, policy, guidance, or directive that discriminates against a firearm entity or firearm trade association and will not discriminate during the term of this contract against a firearm entity or firearm trade association. For purposes of this contract, “discriminate against a firearm entity or firearm trade association” shall mean, with respect to the entity or association, to: “ (1) refuse to engage in the trade of any goods or services with the entity or association based solely on its status as a firearm entity or firearm trade association; (2) refrain from continuing an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association; or (3) terminate an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association. See Tex. Gov’t Code § 2274.001(3) of SB 19. “Discrimination against a firearm entity or firearm trade association” does not include: “ (1) the established policies of a merchant, retail seller, or platform that restrict or prohibit the listing or selling of ammunition, firearms, or firearm accessories; and (2) a company’s refusal to engage in the trade of any goods or services, decision to refrain from continuing an existing business relationship, or decision to terminate an existing business relationship to comply with federal, state, or local law, policy, or regulations or a directive by a regulatory agency, or for any traditional business reason that is specific to the customer or potential customer and not based solely on an entity’s or association’s status as a firearm entity or firearm trade association.” See Tex. Gov’t Code § 2274.001(3) of SB 19.
Transitional Provisions 24.1. As from the official date of entry into force of the 01 series of amendments to this Regulation, no Contracting Party applying this Regulation shall refuse to grant or refuse to accept type approval under this Regulation as amended by the 01 series of amendments. 24.2. As from 12 months after the date of entry into force of the 01 series of amendments to this Regulation, Contracting Parties applying this Regulation shall grant approvals only if the type of components to be approved meets the requirements of Part I of this Regulation as amended by the 01 series of amendments to this Regulation. 24.3. Type approvals of components other than fuel rail, as defined in paragraph 4.72., granted according to the original version of this Regulation or of components granted according to the 01 series of amendments, shall remain valid and shall be accepted for the purpose of their installation on vehicles as long as the requirements for the specific component have not changed by any series of amendments. 24.4. As from 18 months after the date of entry into force of the 01 series of amendments to this Regulation, Contracting Parties applying this Regulation shall grant approvals only if the vehicle type to be approved meets the requirements of Part II of this Regulation as amended by the 01 series of amendments to this Regulation. 24.5. Until 12 months after the date of entry into force of the 01 series of amendments to this Regulation, Contracting Parties applying this Regulation can continue to grant type approvals for the type of components to the original version of this Regulation without taking into account the provisions of the 01 series of amendments. 24.6. Until 18 months after the date of entry into force of the 01 series of amendments to this Regulation, Contracting Parties applying this Regulation can continue to grant type approvals for the vehicle type to the original version of this Regulation without taking into account the provisions of the 01 series of amendments. 24.7. Notwithstanding the provisions of paragraphs 24.5. and 24.6., Contracting Parties applying this Regulation shall not refuse to grant extensions of type approvals for existing types of component or vehicle types which have been issued according to this Regulation without taking into account the provisions of the 01 series of amendments to this Regulation. 24.8. As from the official date of entry into force of the 02 series of amendments to this Regulation, no Contracting Party applying this Regulation shall refuse to grant or refuse to accept type approval under this Regulation as amended by the 02 series of amendments. 24.9. As from 1 September 2017 Contracting Parties applying this Regulation shall grant approvals only if the type of components to be approved meets the requirements of Part I of this Regulation as amended by the 02 series of amendments to this Regulation. 24.10. As from 1 September 2018 Contracting Parties applying this Regulation shall grant approvals only if the vehicle type to be approved meets the requirements of Part II of this Regulation as amended by the 02 series of amendments to this Regulation. 24.11. As from 1 September 2019 Contracting Parties applying this Regulation may refuse to recognize approvals of a type of vehicle which have not been granted in accordance with Part II of this Regulation as amended by the 02 series of amendments to this Regulation. 24.12. Contracting Parties applying this Regulation shall not refuse to grant extensions of type approvals for existing types of component or vehicle types which have been issued according to this Regulation without taking into account the provisions of the 02 series of amendments to this Regulation. 24.13. Notwithstanding paragraphs 24.11. and 24.12., Contracting Parties applying this Regulation shall continue to accept type approvals granted to the preceding series of amendments, which are not affected by the 02 series of amendments.
Other General Provisions 14.2.1 This Agreement shall inure to benefit and bind the parties hereto, their successors and assigns, but neither party may assign this Agreement without written consent of the other, except that Oracle may assign without consent to a related entity or the successor of all or substantially all of the assignor’s business or assets to which this Agreement relates. There are no third-party beneficiaries to this Agreement. 14.2.2 This Agreement does not create any joint venture, partnership, agency, or employment relationship between the parties. 14.2.3 Oracle’s business partners and other third parties, including any third parties with which the Services have integrations or that are retained by Customer to provide consulting services, implementation services or applications that interact with the Services, are independent of Oracle and are not Oracle’s agents. Oracle is not liable for, bound by, or responsible for any problems with the Services or Customer Data arising due to any acts of any such business partner or third party, unless the business partner or third party is providing Services as Oracle’s subcontractor on an engagement ordered under this Agreement and, if so, then only to the same extent as Oracle would be responsible for our resources under this Agreement.
Local Provisions (Local provisions related to these scheduling arrangements are to be set out in this Article and numbered in sequence.)
SAFETY PROVISIONS It is the essence of this Order that all Services to be performed by Seller shall be done in a safe and good workmanlike manner, free of any accidents. Accordingly, Seller shall promulgate, maintain, and enforce appropriate safety and health rules and procedures (including training) with respect to its personnel and the Work to be performed hereunder, which rules and procedures at a minimum shall be the equivalent of or exceed applicable Buyer safety and health rules. All Services performed hereunder shall fully comply with all lawful governmental safety and health requirements, including the rules and standards established by the Occupational Safety and Health Act of 1970 ("OSHA"), as amended, and any other applicable federal, state and/or local safety or health laws, rules or regulations. Any equipment provided by Buyer to Seller for the benefit of Seller's employees or those of its subcontractors shall be at the sole risk and liability of Seller to make sure that such equipment is fit for the use intended and is in proper working order. XXXXXX AGREES TO INDEMNIFY (INCLUDING ATTORNEYS' FEES) DEFEND, AND TO SAVE HARMLESS BUYER FROM ANY AND ALL CLAIMS OF SELLER, SELLER’S SUBCONTRACTORS, AND THEIR EMPLOYEES ARISING OUT OF THE USE OF ANY EQUIPMENT FURNISHED BY BUYER OR ADVICE GIVEN BY BUYER RELATING TO SUCH EQUIPMENT, TO THE FULLEST EXTENT ALLOWED BY LAW, IT BEING UNDERSTOOD THAT BUYER SHALL NOT BE LIABLE UNDER LAW, CONTRACT, NEGLIGENCE, STRICT LIABILITY, OR OTHERWISE. Seller shall maintain a drug and alcohol-free workforce at all times while on Xxxxx's premises/location. Upon Xxxxx's request, Seller shall provide Buyer with a copy of all accident reports prepared by or submitted to Seller, including all OSHA illness and injury reports.
General Provision (a) MML Advisers hereby appoints the Subadviser, and the Subadviser hereby undertakes to act, as investment subadviser to the Portfolio to provide investment advice and to perform for the Fund such other duties and functions as are hereinafter set forth. The Subadviser shall, in all matters, give to the Fund and the Trust’s Board of Trustees, directly or through MML Advisers, the benefit of the Subadviser’s best judgment, effort, advice and recommendations and shall at all times perform its obligations in compliance with: (i) the provisions of the Act and any rules or regulations thereunder and the Internal Revenue Code of 1986, as amended, as applicable to the Fund; (ii) any other provisions of state or federal law applicable to the operation of registered investment companies; (iii) the provisions of the Agreement and Declaration of Trust and Bylaws of the Trust, as amended from time to time and provided to the Subadviser by MML Advisers (collectively referred to as the “Trust Documents”); (iv) policies and determinations of the Board of Trustees of the Trust and MML Advisers, of which the Subadviser has been notified; (v) the fundamental and non-fundamental policies and investment restrictions of the Fund as reflected in the Trust’s registration statement under the Act from time to time; and (vi) the Prospectus and Statement of Additional Information of the Fund in effect from time to time (collectively referred to as the “Disclosure Documents”). (b) The officers and employees of the Subadviser responsible for providing the services of the Subadviser hereunder shall be available upon reasonable notice for consultation with respect to the provision of such services. (c) Subadviser will comply with the applicable provisions of the Fund’s pricing procedures which it has received and, upon request, will provide reasonable assistance to the Fund’s pricing agent in valuing securities held by the Fund.
Transitional Provision Schedule 3.2 contains a schedule of certain letters of credit issued for the account of the Borrower prior to the Closing Date. Subject to the satisfaction of the conditions contained in Sections 5.1 and 5.2, from and after the Closing Date such letters of credit shall be deemed to be Letters of Credit issued pursuant to this Article III.