Insulation In exterior walls? Yes No Unknown In ceiling/attic? Yes No Unknown In any other areas? Yes No Where? Comments:
Excess Public Liability Insurance over and above the Employers’ Liability Commercial General Liability and Comprehensive Automobile Liability Insurance coverage, with a minimum combined single limit of Twenty Million Dollars ($20,000,000) per occurrence/Twenty Million Dollars ($20,000,000) aggregate.
Boiler and Machinery Insurance The Owner shall have the option of purchasing and maintaining boiler and machinery insurance required by the Contract Documents or by law, which shall specifically cover such insured objects during installation and until final acceptance by the Owner. If purchased this insurance shall include interests of the Owner, Contractor, Subcontractors and Sub-subcontrators in the Work.
Rubric The rubrics are a scoring tool used for the Educator’s self-assessment, the formative assessment, the formative evaluation and the summative evaluation. The districts may use either the rubrics provided by ESE or comparably rigorous and comprehensive rubrics developed or adopted by the district and reviewed by ESE.
Public Liability Insurance (a) The public liability insurance referred to in paragraph 12.1(b) shall (i) provide that in as much as such policies cover more than one insured, all terms, conditions, insuring agreements and endorsements, with the exception of limits of liability, deductibles or retentions and liability for premiums, commissions, assessments or calls (which shall be solely a liability of Lessee), shall operate in the same manner as if there were a separate policy or policies covering each insured, (ii) waive any rights of subrogation of the insurers against Owner Participant, Lessor, the Trust Company, the Indenture Trustee, the Policy Provider and Loan Participant (iii) provide that neither Owner Participant, Lessor, the Trust Company, the Policy Provider, the Indenture Trustee nor Loan Participant shall have any responsibility for any insurance premiums, whether for coverage before or after cancellation or termination of any such policies as to Lessee and (iv) be primary without contribution from any similar insurance maintained by Owner Participant, Lessor, the Trust Company, the Indenture Trustee, the Policy Provider or Loan Participant.
(b) Lessee shall use its reasonable efforts to obtain public liability insurance policies which stipulate that coverage thereunder will not be invalidated (as to Owner Participant, Loan Participant, Lessor, as Lessor of the Units and in its individual capacity, and the Indenture Trustee) by any act or neglect of Lessee, or any breach or violation by Lessee of any warranties, declarations or conditions contained in such policies, but shall be under no obligation to obtain such policies containing such stipulations if they are not available to Lessee at commercially reasonable rates in the markets in which Lessee has then placed its insurance program.
(c) In the event any public liability insurance policy or coverage thereunder which are required to be maintained under Section 12.1(b) shall not be available to Lessee in the commercial insurance market on commercially reasonable terms, Lessor shall not unreasonably withhold its agreement to waive such requirement. Lessee shall make written request for any such waiver in writing, accompanied by written reports prepared, at Lessee's option, either by (i) one independent insurance advisor chosen by Lessee and Lessor or (ii) three independent insurance advisors, one chosen by Lessor, one chosen by Lessee and one chosen by the other two advisors (one of which may be the regular insurance broker or brokers of Lessee). The fees and expenses of all such advisors shall be paid by Lessee. The written reports required hereunder shall unanimously (x) state that such insurance (or the required coverage thereunder) is not reasonably available to Lessee at commercially reasonable premiums in the commercial insurance markets within which Lessee or the Manager normally purchases its insurance from insurers, acceptable to Lessee, with "A.M. Best's" rating of A- or better for railcars of similar type and capacity and (y) explain in detail the basis for such conclusions. At any time after the granting of such waiver, but not more often than once a year, Lessor may make a written request for a supplemental report (in form reasonably acceptable to Lessor) from such insurance advisor(s) updating the prior report and reaffirming the conclusions set forth therein. Lessee shall provide any such required supplemental report within 60 days after receipt of the written request therefor. Any such waiver shall be effective for only as long as such insurance is not reasonably available to Lessee in the commercial markets in which Lessee normally purchases its insurance at commercially reasonable rates, it being understood that the failure of Lessee to furnish timely any such supplemental report shall be conclusive evidence that such condition no longer exists. If such supplemental report shows that such coverage is available, Lessee shall within 90 days of such report obtain such insurance coverage. During any period with respect to which such waiver has been granted and remains in effect under this Section 12.3(c), Lessee shall obtain public liability insurance as set forth in Section 12.1(b) from such carriers, in such amounts and with coverage limits and deductibles as may be reasonable in its judgment under the circumstances, but in any event (i) no less than prudent industry standards and (ii) in an amount that may be purchased for a premium equal to 200% of Lessee's cost (on a fleet-wide basis) of public liability insurance premiums for the coverage on a fleet-wide basis required by Section 12.1(b) for the final year immediately preceding the fiscal year in which such waiver first was granted.
Lighting A system of fixtures providing or controlling the light sources used on or near the airport or within the airport buildings. The field lighting includes all luminous signals, markers, floodlights, and illuminating devices used on or near the airport or to aid in the operation of aircraft landing at, taking off from, or taxiing on the airport surface.
Heating, Ventilation and Air Conditioning Landlord shall furnish to the Premises heating, ventilation and air-conditioning (“HVAC”) in accordance with the Design Standards set forth in Exhibit D during Ordinary Business Hours. Landlord shall have access to all air-cooling, fan, ventilating and machine rooms and electrical closets and all other mechanical installations of Landlord (collectively, “Mechanical Installations”), and Tenant shall not construct partitions or other obstructions which may interfere with Landlord’s access thereto or the moving of Landlord’s equipment to and from the Mechanical Installations. No Tenant Party shall at any time enter the Mechanical Installations or tamper with, adjust, or otherwise affect such Mechanical Installations. Landlord shall not be responsible if the HVAC System fails to provide cooled or heated air, as the case may be, to the Premises in accordance with the Design Standards by reason of (i) any equipment installed by, for or on behalf of Tenant, which has an electrical load in excess of the average electrical load and human occupancy factors for the HVAC System as designed, or (ii) any rearrangement of partitioning or other Alterations made or performed by, for or on behalf of Tenant. Tenant shall install, if missing, blinds or shades on all windows, which blinds and shades shall be subject to Landlord’s approval, and shall keep operable windows in the Premises closed, and lower the blinds when necessary because of the sun’s position, whenever the HVAC System is in operation or as and when required by any Requirement. Tenant shall cooperate with Landlord and shall abide by the rules and regulations which Landlord may reasonably prescribe for the proper functioning and protection of the HVAC System. Tenant acknowledges that the server room in the Premises currently has three heat pumps installed, being two 4-ton units, and one 2.5-ton unit (the “Existing Heat Pumps”). The 2.5-ton unit is currently connected and operational. Tenant shall determine whether it is satisfied with the condition of the Existing Heat Pumps and Landlord shall not have any responsibility or liability for the condition, operation, maintenance, repair or replacement of the Existing Heat Pumps. Tenant may operate the Existing Heat Pumps. Tenant shall be responsible for, and pay directly for, all necessary maintenance and repairs to the Existing Heat Pumps. Tenant shall reimburse Landlord monthly for the cost of all utility services used to operate the Existing Heat Pumps within 10 Business Days after receipt of Landlord’s invoice for such amount. Landlord may measure Tenant’s usage of such utility services by either a sub-meter or by other reasonable methods such as by temporary check meters or by survey. Tenant, at its cost, may replace the Existing Heat Pumps with one or more new heat pumps, provided, however, that the capacity of such replacement heat pump(s) shall not exceed the 10.5-ton capacity cooling capacity of the Existing Heat Pumps.
Commercial Umbrella Liability Insurance The Contractor shall provide a Commercial Umbrella Liability Insurance to provide excess coverage above the Commercial General Liability, Commercial Business Automobile Liability and the Workers' Compensation and Employers' Liability to satisfy the minimum limits set forth herein. The umbrella coverage shall follow form with the Umbrella limits required as follows: $ 2,000,000 per Occurrence $2,000,000 per Occurrence $ 4,000,000 Aggregate $10,000,000 Aggregate Additional Requirements for Commercial Umbrella Liability Insurance are shown below at Paragraph 1.5.3.3.6.
Window Coverings No curtains, draperies, blinds, shutters, shades, awnings, screens or other coverings, window ventilators, hangings, decorations or similar equipment shall be attached to, hung or placed in, or used in or with any window of the Building without the prior written consent of Landlord, and Landlord shall have the right to control all lighting within the Premises that may be visible from the exterior of the Building.
Local Circuit Switching Capability, including Tandem Switching Capability 4.1.3.1 Definition
4.1.3.2 Notwithstanding BellSouth’s general duty to unbundle local circuit switching, BellSouth shall not be required to unbundle local circuit switching for <<customer_name>> when <<customer_name>> serves end-users with four (4) or more voice-grade (DS-0) equivalents or lines in locations served by BellSouth’s local circuit switches, which are in the following MSAs: Atlanta, GA; Miami, FL; Orlando, FL; Ft. Lauderdale, FL; Charlotte-Gastonia-Rock Hill, NC; Greensboro-Winston Salem-High Point, NC; Nashville, TN; and New Orleans, LA, and BellSouth has provided non-discriminatory cost based access to the Enhanced Extended Link (EEL) throughout Density Zone 1 as determined by NECA Tariff No. 4 as in effect on January 1, 1999.
4.1.3.3 In the event that <<customer_name>> orders local circuit switching for a single end user account name at a single physical end user location with four (4) or more 2-wire voice-grade loops from a BellSouth central office in an MSA listed above, BellSouth shall charge <<customer_name>> the market based rate in Exhibit C for use of the local circuit switching functionality for the affected facilities.
4.1.3.4 A featureless port is one that has a line port, switching facilities, and an interoffice port. A featured port is a port that includes all features then capable or a number of then capable features specifically requested by <<customer_name>>. Any features that are not currently then capable but are technically feasible through the switch can be requested through the NBR/BFR process.
4.1.3.5 BellSouth will provide to <<customer_name>> customized routing of calls: (i) to a requested directory assistance services platform; (ii) to an operator services platform pursuant to Section 10 of Attachment 2; (iii) for <<customer_name>>’s PIC’ed toll traffic in a two (2) PIC environment to an alternative OS/DA platform designated by <<customer_name>>. <<customer_name>> customers may use the same dialing arrangements as BellSouth customers.
4.1.3.6 Remote Switching Module functionality is included in Switching Capability. The switching capabilities used will be based on the line side features they support.
4.1.3.7 Switching Capability will also be capable of routing local, intraLATA, interLATA, and calls to international customer’s preferred carrier; call features (e.g. call forwarding) and Centrex capabilities.
4.1.3.8 Where required to do so in order to comply with an effective Commission order, BellSouth will provide to <<customer_name>> purchasing local BellSouth switching and reselling BellSouth local exchange service under Attachment 1, selective routing of calls to a requested directory assistance services platform or operator services platform. <<customer_name>> customers may use the same dialing arrangements as BellSouth customers, but obtain a <<customer_name>> branded service.
