Operation and Maintenance of the Equipment and Material. The receiving Party shall be responsible for all operation and maintenance required on the Equipment and Material while in its possession.
Operation and Maintenance of the Equipment and Material Sample Clauses
Related to Operation and Maintenance of the Equipment and Material
Supply and Maintenance of Equipment It is the responsibility of the Employer to furnish and maintain all equipment, machinery and supplies required by employees in the performance of their duties. Employees shall not suffer any loss in salary in the event that they cannot carry out their normal duties by reason of the Employer failing to properly maintain equipment, machinery or supplies or by reason of power failures or other circumstances not attributable to the employees.
Operation and Maintenance 17.1 O&M obligations of the Concessionaire
Construction and Maintenance There are on-going maintenance, renovation and construction projects taking place in and around the residences. The work typically takes place during regular business hours, but may begin earlier or extend into evenings or weekends. On-going construction or renovation projects will continue through midterm and final exam periods. The University will take measures to ensure that prudent construction practices are followed, but there may be noise, dust and temporary interruption of some services. Residents may be required to temporarily or permanently relocate to facilitate construction or renovation to their residence area. There will be no compensation or reduction to your residence fees due to disruption and/or relocation.
Installation and Maintenance Except for the bi‐directional and production metering equipment owned by the City, all equipment on Customer’s side of the delivery point, including the required disconnect device, shall be provided and maintained in satisfactory operating condition by Customer and shall remain the property and responsibility of the Customer. The City will bear no responsibility for the installation or maintenance of Customer’s equipment or for any damage to property as a result of any failure or malfunction thereof. The City shall not be liable, directly or indirectly for permitting or continuing to allow the interconnection of the Facility or for the acts or omissions of Customer or the failure or malfunction of any equipment of Customer that causes loss or injury, including death, to any party.
Control and Maintenance of the Property Unless required by Applicable Law, Lender, or a receiver appointed under Applicable Law, is not obligated to enter upon, take control of, or maintain the Property before or after giving notice of Default to Borrower. However, Xxxxxx, or a receiver appointed under Applicable Law, may do so at any time when Borrower is in Default, subject to Applicable Law.
Installation, Inspection, and Maintenance The Contractor is responsible for installation and maintenance of the BMPs as a part of its Bid. The Design Professional shall obtain the services of a qualified testing laboratory to inspect the BMPs in accordance with the permits, the costs of such inspections to be borne by the Owner. In the event of Abnormal Weather Conditions or force majeure, the Contractor shall be compensated for re-installation of BMPs at established Unit Prices.
Repairs and Maintenance The Tenant shall (a) take good care of the Apartment and all equipment and fixtures in it; (b) promptly make all necessary repairs and replacements whenever the need results from the Tenant's act of neglect or the neglect of Tenant’s family members, guests, visitors or contractors (if consented to by Landlord); (c) keep the Apartment and any other part of the building used by the Tenant as clean and safe as possible; and (d) promptly notify the Landlord when there are conditions which need repair. Landlord shall have a reasonable amount of time to make repairs. Tenant shall be responsible for reimbursing the Landlord for the cost of any repairs that are not "normal wear and tear" repairs, any such costs shall be considered additional rent; (e) shall not attach to, hang from or place anything on the railings of the patio or deck; and ( f ) Tenant agrees not to install any partition walls. No outside contractor is authorized to perform any services at the Apartment or apartment complex unless approved in writing by a representative of the Landlord. If Tenant contracts for any such services without written consent of the Landlord, Tenant shall be wholly responsible for the payment for any such service and shall hold the Landlord harmless against any claim made by a contractor who performs any such service at the request of the Tenant. Tenant shall also be responsible for returning the apartment back to its original condition, or else shall be liable to the Landlord for the costs incurred for the Landlord to do so after Tenant vacates.
Operations and Maintenance Pursuant to Section 10.5 of this Agreement, Developer shall pay the reasonable expenses (including overheads) for the operation, maintenance, repair and replacement of Transmission Owner’s Attachment Facilities and incremental operating and maintenance expenses incurred in association with System Upgrade Facilities, if and to the extent provided for under Attachment S. For Transmission Owner’s Attachment Facilities, such expenses are calculated as follows:
MAINTENANCE OF THE PROJECT (11-20-07) (Rev. 1-17-12) 104-10 SP1 G125 Revise the 2012 Standard Specifications as follows: Page 1-35, Article 104-10 Maintenance of the Project, line 25, add the following after the first sentence of the first paragraph: All guardrail/guiderail within the project limits shall be included in this maintenance. Page 1-35, Article 104-10 Maintenance of the Project, line 30, add the following as the last sentence of the first paragraph: The Contractor shall perform weekly inspections of guardrail and guiderail and shall report damages to the Engineer on the same day of the weekly inspection. Where damaged guardrail or guiderail is repaired or replaced as a result of maintaining the project in accordance with this article, such repair or replacement shall be performed within 7 consecutive calendar days of such inspection report. Page 1-35, Article 104-10 Maintenance of the Project, lines 42-44, replace the last sentence of the last paragraph with the following: The Contractor will not be directly compensated for any maintenance operations necessary, except for maintenance of guardrail/guiderail, as this work will be considered incidental to the work covered by the various contract items. The provisions of Article 104-7, Extra Work, and Article 104-8, Compensation and Record Keeping will apply to authorized maintenance of guardrail/guiderail. Performance of weekly inspections of guardrail/guiderail, and the damage reports required as described above, will be considered to be an incidental part of the work being paid for by the various contract items.
Support and Maintenance Where Licensee purchases support and/or maintenance services, Licensee’s initial support and/or maintenance term will begin upon delivery to Licensee of the Licensed Software and continue for one (1) year thereafter (or the length of the term if less than a year for any subscription/term license) unless otherwise specified in the applicable annual support and/or maintenance agreement, Product Order, or other written agreement executed between Licensor and Licensee. Where Licensee purchases support and/or maintenance for any Licensed Software, Licensee hereby agrees that it shall purchase such support and/or maintenance services for all of Licensee’s licensed units of such Licensed Software product. Support and/or maintenance services provided by Licensor will be subject to Licensor’s then current applicable standard annual support and/or maintenance agreement unless otherwise agreed by the parties in writing.
