Ordering Procedures for Task Orders
Ordering Procedures for Task Orders Sample Clauses
Related to Ordering Procedures for Task Orders
ORDERING PROCEDURES All task orders under OASIS SB must: 1. Be awarded by an OCO with a Delegation of Procurement Authority (DPA) or by a Contractor authorized to use the OASIS SB Contracts as a Government Source of Supply 2. Be within the scope of Section C and all other terms and conditions of the OASIS SBcontract 3. Be solicited and awarded under the proper NAICS Code and corresponding OASIS SB MA-IDIQ Contract Number (See Section H.4.) 4. Identify the proper Product Service Code (See Section H.5.) and, 5. Comply with the OASIS SB Contract, OASIS SB DPA Training, OASIS SB Ordering Guide, the Ordering Procedures in FAR Subpart 16.505, Ordering, and other applicable agency specific regulatorysupplements
ORDERING PROCEDURE Orders placed against this contract may be in the form of an agency issued purchase order on an as-required basis. Or an agency may also use the Arkansas State Purchasing Card (P- Card) to purchase furniture.
Procedures for LNP Request The Parties shall provide for the requesting of End Office LNP capability on a reciprocal basis through a written request. The Parties acknowledge that Verizon has deployed LNP throughout its network in compliance with FCC 96-286 and other applicable FCC Regulations. 15.4.1 If Party B desires to have LNP capability deployed in an End Office of Party A, which is not currently capable, Party B shall issue a LNP request to Party A. Party A will respond to the Party B, within ten (10) days of receipt of the request, with a date for which LNP will be available in the requested End Office. Party A shall proceed to provide for LNP in compliance with the procedures and timelines set forth in FCC 00-000, Xxxxxxxxx 80, and FCC 97-74, Paragraphs 65 through 67. 15.4.2 The Parties acknowledge that each can determine the LNP-capable End Offices of the other through the Local Exchange Routing Guide (LERG). In addition, the Parties shall make information available upon request showing their respective LNP-capable End Offices, as set forth in this Section 15.4.
Hiring Procedures Nothing contained in this Article 4 shall impair any of the rights of the Employer to hire new or additional employees to meet the employment needs of the Employer, in accordance with the terms and provisions of this collective bargaining Agreement or to meet the obligations of the Employer under Article 2, Section H of this Agreement or to take affirmative steps to comply with any requirements under any applicable Federal or State law prohibiting discrimination in employment.
Ordering Process 6.4.1 CLEC, or CLEC's agent, shall act as the single point of contact for its End User Customers' service needs, including without limitation, sales, service design, order taking, Provisioning, change orders, training, maintenance, trouble reports, repair, post-sale servicing, Billing, collection and inquiry. CLEC's End User Customers contacting Qwest in error will be instructed to contact CLEC; and Qwest's End User Customers contacting CLEC in error will be instructed to contact Qwest. In responding to calls, neither Party shall make disparaging remarks about each other. To the extent the correct provider can be determined, misdirected calls received by either Party will be referred to the proper provider of local Exchange Service; however, nothing in this Agreement shall be deemed to prohibit Qwest or CLEC from discussing its products and services with CLEC's or Qwest's End User Customers who call the other Party seeking such information. 6.4.2 CLEC shall transmit to Qwest all information necessary for the ordering (Billing, Directory Listing and other information), installation, repair, maintenance and post-installation servicing according to Qwest's standard procedures, as described in the Qwest Product Catalog (PCAT) available on Qwest's public web site located at xxxx://xxx.xxxxx.xxx/wholesale/pcat. Information shall be provided using Qwest's designated Local Service Request (LSR) format which may include the LSR, End User Customer and resale forms. 6.4.3 Qwest will use the same performance standards and criteria for installation, Provisioning, maintenance, and repair of services provided to CLEC for resale under this Agreement as Qwest provides to itself, its Affiliates, its subsidiaries, other Resellers, and Qwest retail End User Customers. The installation, Provisioning, maintenance, and repair processes for CLEC's resale service requests are detailed in the Access to OSS Section of this Agreement, and are applicable whether CLEC's resale service requests are submitted via Operational Support System or by facsimile. 6.4.4 CLEC is responsible for providing to Qwest complete and accurate End User Customer Directory Listing information including initial and updated information for Directory Assistance Service, white pages directories, and E911/911 Emergency Services. The Ancillary Services Section of this Agreement contains complete terms and conditions for Directory Listings for Directory Assistance Services, white pages directories, and E911/911 Emergency Services. 6.4.5 If Qwest's retail End User Customer, or the End User Customer's New Service Provider orders the discontinuance of the End User Customer's existing Qwest service in anticipation of the End User Customer moving to a New Service Provider, Qwest will render its closing xxxx to the End User Customer, discontinuing Billing as of the date of the discontinuance of Qwest's service to the End User Customer. If the Current Service Provider, or if the End User Customer's New Service Provider orders the discontinuance of existing resold service from the Current Service Provider, Qwest will xxxx the Current Service Provider for service through the date the End User Customer receives resold service from the Current Service Provider. Qwest will notify CLEC by Operational Support System interface, facsimile, or by other agreed-upon processes when an End User Customer moves from the Current Service Provider to a New Service Provider. Qwest will not provide the Current Service Provider with the name of the New Service Provider selected by the End User Customer. 6.4.6 CLEC shall provide Qwest and Qwest shall provide CLEC with points of contact for order entry, problem resolution and repair of the resold services. These points of contact will be identified for both CLEC and Qwest in the event special attention is required on a service request. 6.4.7 Prior to placing orders on behalf of the End User Customer, CLEC shall be responsible for obtaining and having in its possession Proof of Authorization (POA), as set forth in the POA Section of this Agreement. 6.4.8 Due Date intervals for CLEC's resale service requests are established when service requests are received by Qwest through Operational Support Systems or by facsimile. Intervals provided to CLEC shall be equivalent to intervals provided by Qwest to itself, its Affiliates, its subsidiaries, other Resellers, and to Qwest's retail End User Customers.
Testing Procedures Testing will be conducted by an outside certified Agency in such a way to ensure maximum accuracy and reliability by using the techniques, chain of custody procedures, equipment and laboratory facilities which have been approved by the U.S. Department of Health and Human Services. All employees notified of a positive controlled substance or alcohol test result may request an independent test of their split sample at the employee’s expense. If the test result is negative the Employer will reimburse the employee for the cost of the split sample test.
000 GRIEVANCE PROCEDURE 7. 100 It is agreed that it is the spirit and intent of this Agreement to adjust grievances promptly. All grievances, including discharge for just cause, but not those pertaining to jurisdictional disputes that may arise on any work covered by this Agreement, must be initiated within fifteen (15) working days of the incident by either the employee in Step I or the Local Union in Step II and shall be handled in the following manner:
Billing Procedures The Supporting Party will xxxx the Protecting Party for actual costs incurred for Assistance by Hire. Reimbursements will be limited to the provisions of the Agreement and the applicable OP, regardless of whether or not it is authorized on the Resource Order or other documentation produced by the incident. Reimbursable costs may include transportation, salary, overtime, per diem and other approved expenses of Supporting agency personnel. Rates and conditions of use for the equipment and personnel are documented in the OP. Parties shall submit a xxxx within 90 days of the incident. Parties must use their own invoice form for billing under this Agreement to avoid any confusion with other services that may have been ordered under other agreements. Invoices must identify Supporting Party’s name, address, and Taxpayer Identification Number (Department only), fire name, order and request number, and xxxx number and amount. Invoice supporting documentation must include description of services performed, period of services performed, and any applicable cost share agreements. Supporting documentation will itemize details of billing, listing personnel, equipment, travel and per diem, aircraft, supplies and purchases as approved in the attached AOP. It will also include itemized deductions for maintenance and repair of equipment. Department invoices will include “Record of Activities” (FSLA-5) and U.S. Forest Service invoices will include transaction register. Invoices for services under this agreement must be sent to: Name: Xxxx Xxxxxx-Xxxxx, ECC Manager Address: 0000 Xxxxxxxxx Xxxxx Xxxx, Xxxxx, Xxx: Xxxxxxxxxx, XX 00000 Telephone: (000) 000-0000 FAX: (000) 000-0000 Email: xxxxxxxxxxxx@xx.xxx.xx Name: Spalding Community Service District Address: 000-000 Xxxxxxxx Xxx Xxxx, Xxxxx, Xxx: Xxxxxxxxxx, XX 00000 Telephone: (000) 000-0000 FAX: (000) 000-0000 Email: xxxxxxxxxxxxx@xxxxxxx.xxx All bills will have a payment due date 30 days upon receipt. Contested Xxxxxxxx: Written notice that a xxxx is contested will be mailed to the Party within 30 days of receipt of the invoice and will fully explain the contested items. Contested items should be resolved no later than 60 days following receipt of the written notice. Parties are responsible for facilitating resolution of contested xxxxxxxx. Billing requirements and rates are documented in the attached OP.
Hearing Procedures The hearing shall be held at the earliest convenient date, taking into consideration the established schedule of the Board or hearing officer and the availability of the CSEA representative, counsel and witnesses. The parties shall be notified of the time and place of the hearing after ensuring availability of all necessary parties. The employee shall be entitled to appear personally, produce evidence, and have CSEA representation. The employee shall be entitled to a public hearing if he/she demands it when the Board is hearing the appeal. 18.12.1 The complainant may also be represented by counsel. The procedure entitled "Administrative Adjudication" commencing with Government Code 11500 shall not apply to any such hearing before the Board or a hearing officer. Neither the Board nor a hearing officer shall be bound by rules of evidence used in California courts. Informality in any such hearing shall not invalidate any order or decision made or approved by the hearing officer or the Board. 18.12.2 All hearings shall be heard by a hearing officer (who shall be an attorney licensed in the State of California) except in those cases where the Board determines to hear the appeal itself. In any case in which the Board hears the appeal, the Board may use the services of its counsel or a hearing officer in ruling upon procedural questions, objections to evidence, and issues of law. However, the Board must employ separate counsel from the one presenting the case for the complainant. 18.12.3 If the appeal is heard by the Board, the Board shall affirm, modify or revoke the recommended personnel action. 18.12.4 If the appeal is heard by a hearing officer, he/she shall prepare a proposed decision in a form that may be adopted by the Board as the decision in the case. A copy of the proposed decision shall be received and filed by the Board and furnished to each party within ten days after the proposed decision is filed by the Board. After furnishing the proposed decision to each party, the Board may: 18.1.4.1 Adopt the proposed decision in its entirety. 18.1.4.2 Reduce the personnel action set forth in the proposed decision and adopt the balance of the proposed decision. 18.1.4.3 Reject a proposed reduction in personnel action, approve the disciplinary action sought by the complainant or any lesser penalty, and adopt the balance of the proposed decision. 18.1.4.4 Reject the proposed decision in its entirety. 18.12.5 If the Board rejects the proposed decision in its entirety, each party shall be notified of such action and the Board may decide the case upon the record including the transcript, with or without the taking of additional evidence, or may refer the case to the same or another hearing officer to take additional evidence. If the case is so assigned to a hearing officer, he/she shall prepare a proposed decision, as provided in item Section 18.12.4 above, upon the additional evidence and the transcript and other papers which are part of the record of the prior hearing. A copy of this proposed decision shall be furnished to each party within 10 days after the proposed decision is filed by the Board. 18.12.6 In arriving at a decision or a proposed decision on the propriety of the proposed disciplinary action, the Board or the hearing officer may consider the records of any prior disciplinary action proceedings against the employee in which a disciplinary action was ultimately sustained and any records that were contained in the employee's personnel files and introduced into evidence at the hearing.
Procedures for Providing NP Through Full NXX Code Migration Where a Party has activated an entire NXX for a single Customer, or activated at least eighty percent (80%) of an NXX for a single Customer, with the remaining numbers in that NXX either reserved for future use by that Customer or otherwise unused, if such Customer chooses to receive Telephone Exchange Service from the other Party, the first Party shall cooperate with the second Party to have the entire NXX reassigned in the LERG (and associated industry databases, routing tables, etc.) to an End Office operated by the second Party. Such transfer will be accomplished with appropriate coordination between the Parties and subject to appropriate industry lead times for movements of NXXs from one switch to another. Neither Party shall charge the other in connection with this coordinated transfer.
