Payment Requests Review applications for payment with Contractor for compliance with the established procedure for their submission and forward with recommendations to Engineer, noting particularly the relationship of the payment requested to the schedule of values, Work completed, and materials and equipment delivered at the Site but not incorporated in the Work.
Disbursement Requests Except as expressly provided in the Credit Agreement, Administrative Agent must receive Disbursement Requests in writing. Disbursement Requests will only be accepted from the applicable Authorized Representatives designated in the Disbursement Instruction Agreement. Disbursement Requests will be processed subject to satisfactory completion of Administrative Agent’s customer verification procedures. Administrative Agent is only responsible for making a good faith effort to execute each Disbursement Request and may use agents of its choice to execute Disbursement Requests. Funds disbursed pursuant to a Disbursement Request may be transmitted directly to the Receiving Bank, or indirectly to the Receiving Bank through another bank, government agency, or other third party that Administrative Agent considers to be reasonable. Administrative Agent will, in its sole discretion, determine the funds transfer system and the means by which each Disbursement will be made. Administrative Agent may delay or refuse to accept a Disbursement Request if the Disbursement would: (i) violate the terms of this Agreement; (ii) require use of a bank unacceptable to Administrative Agent or Lenders or prohibited by government authority; (iii) cause Administrative Agent or Lenders to violate any Federal Reserve or other regulatory risk control program or guideline; or (iv) otherwise cause Administrative Agent or Lenders to violate any applicable law or regulation.
Payment Request The Contractor shall ensure a payment request includes documentation appropriate to the type of payment request in accordance with the payment clause, contract financing clause, or Federal Acquisition Regulation 52.216-7, Allowable Cost and Payment, as applicable.
Payment and Invoicing As full consideration for the performance of the Services, delivery of the Goods and the assignment of rights to Apple as provided in this Agreement, Apple shall pay Seller (i) the amount agreed upon and specified in the applicable PO, or (ii) Seller's quoted price on date of shipment (for Goods), or the date Services were started (for Services), whichever is lower; provided that if the designated destination for Goods is a Hub (as defined above) Apple shall pay Seller (a) the amount agreed upon and specified in the applicable PO, or (b) Seller's quoted price on the date such goods are physically delivered to Apple and withdrawn from the Hub, whichever is lower. Applicable taxes and other charges such as shipping costs, duties, customs, tariffs, imposts, and government imposed surcharges shall be stated separately on Seller's invoice. Payment by cheque is made when Apple's payment is mailed and payment by bank transfer is made when the funds leave Apple's bank account. Payment shall not constitute acceptance of the Goods or Services. All duties, taxes, copyright levies, environmental levies, or any other levies assessable upon the Goods prior to receipt by Apple of Goods conforming to the PO shall be borne by Seller. Seller shall invoice Apple for all Goods delivered and all Services actually performed. Each invoice submitted by Seller must be provided to Apple within ninety (90) days of completion of the Services or delivery of Goods or as otherwise agreed or specified in the PO and must reference the applicable PO, and Apple reserves the right to return all incorrect invoices. Apple will receive a 2% discount of the invoiced amount for all invoices that are submitted more than ninety (90) days after completion of the Services or delivery of the Goods. Unless otherwise specified on the face of a PO, Apple shall pay the invoiced amount within forty-five (45) days after receipt of an undisputed invoice. Seller shall send only one original invoice to Apple Accounts Payable Department. Seller will receive no royalty or other remuneration on the production or distribution of any products developed by Apple or Seller in connection with or based on the Goods or Services provided. To the extent that any intellectual property subsists in the Goods or Services that does not constitute Work Product as defined below, Seller hereby grants to Apple and warrants that it is entitled to grant to Apple a royalty free, perpetual, irrevocable licence (with the right to sub-licence) any such intellectual property.
Stop Payment Requests If you desire to stop any transfer that has already been processed, you must contact customer care for the Service pursuant to Section 22 of the General Terms. Although we will make a reasonable effort to accommodate your request, we will have no liability for failing to do so. We may also require you to present your request in writing within fourteen (14) days. The charge for each request will be the current charge for such service as set out in the applicable fee schedule.
Fees and Invoicing The Consultant’s fee for tasks performed during the design phase and for all technical and administrative tasks during the construction and close-out phases, such as the review of Contractor submittals, preparation and distribution of minutes, on-site observation during construction, etc., will be a lump sum amount unless stated otherwise. The Consultant’s lump sum fee shall be further broken down by phase depending on the contract. In the event that any of the project phases or services are extended for reasons other than the fault of the Consultant, then the Consultant may submit an amendment for additional costs associated with the extension or additional services. Such costs shall be based on direct costs. The Consultant will not be entitled to an automatic extension of the monthly rate for that phase or any subsequent phase. Invoices for materials and labor expenses shall be submitted on an Invoice Form provided by the Owner, accompanied by appropriate backup as required by the Owner. Copies of all bills for reimbursables allowed by contract must be attached to the invoice form. Invoices during the design phase may be submitted monthly to the Owner or when work is completed, reviewed and accepted by the Owner. Invoices during the construction phase may also be submitted monthly. Completed invoices must identify the Owners project number for the project and location of the project. Invoices for all work performed shall be processed only after Owner review and acceptance of the work. Invoices will not be processed if work is found to be incomplete or unsatisfactory upon review by the Owner. The invoice, or portion of the invoice, will be held unprocessed until the Consultant makes the necessary corrections and the work is acceptable to Owner.
Payments and Invoicing Within fifteen (15) days after the date the NMDOT receives written notice from the Vendor that payment is requested for services, construction or items of tangible personal property delivered on site and received, the NMDOT shall issue a written certification of complete or partial acceptance or rejection of the services, construction or items of tangible personal property. If the NMDOT finds that the services, construction or items of tangible personal property are not acceptable, it shall, within thirty (30) days after the date of receipt of written notice from the Vendor that payment is requested, provide to the Vendor a letter of exception explaining the defect or objection to the services, construction or delivered tangible personal property along with details of how the Vendor may proceed to provide remedial action. Upon certification by the NMDOT that the services, construction or items of tangible personal property have been received and accepted, payment shall be tendered to the Vendor within thirty (30) days after the date of certification. If payment is made by mail, the payment shall be deemed tendered on the date it is postmarked. After the thirtieth day from the date that written certification of acceptance is issued, late payment charges shall be paid on the unpaid balance due on the purchase order to the Vendor at the rate of one and a half (1½) percent per month. For purchases funded by state or federal grants to local public bodies, if the public body has not received the funds from the federal or state funding agency, but has already certified that the services or items of tangible personal property have been received and accepted, payments shall be tendered to the Vendor within five (5) working days of receipt of funds from that funding agency. Final payment shall be made within thirty (30) days after the work has been approved and accepted by the New Mexico Department of Transportation’s Secretary of his/her duly authorized representative. The Vendor agrees to comply with state laws and rules pertaining to worker’s compensation insurance coverage for its employees. If Vendor fails to comply with the workers’ compensation act and applicable rules when required to do so the purchase order may be canceled effective immediately.
Progress Reports and Invoices The goals of this subtask are to: (1) periodically verify that satisfactory and continued progress is made towards achieving the project objectives of this Agreement; and (2) ensure that invoices contain all required information and are submitted in the appropriate format. • Submit a monthly Progress Report to the CAM. Each progress report must: o Summarize progress made on all Agreement activities as specified in the scope of work for the preceding month, including accomplishments, problems, milestones, products, schedule, fiscal status, and an assessment of the ability to complete the Agreement within the current budget and any anticipated cost overruns. See the Progress Report Format Attachment for the recommended specifications. • Submit a monthly or quarterly Invoice that follows the instructions in the “Payment of Funds” section of the terms and conditions, including a financial report on Match Fund and in-state expenditures. • Progress Reports • Invoices
Payment Invoicing The Contractor will be paid upon submission of invoices to the Customer after delivery and acceptance of commodities or contractual services is confirmed by the Customer. Invoices must contain sufficient detail for an audit and contain the Contract Number and the Contractor’s Federal Employer Identification Number.
PURCHASE ORDERS AND INVOICING All invoices shall at a minimum, include the items listed below and any additional information identified in the Authorized User RFQ and resulting Authorized User Agreement: Contract Number; Contractor/Reseller Name; NYS Vendor ID; Manufacturer Part Number (SKU); Product Name; Product Description; Quantity; NYS Net Price for each Product; Specific designation of special price(s) which may be better than the NYS Net Contract Price; and Invoice Total.
