PRE-STRESSING STEEL Sample Clauses

PRE-STRESSING STEEL. The pre stressing steel wires including those used as untentioned wires should conform to IS:1785 –1966 Part.I (Specification for plain hard drawn steel wire) or IS:"6003/1970 (Specification for indented wire for pre stressed concrete). The type design for plain wires of 4 mm diameter are with a guaranteed ultimate strength of 175 Kg./xx.xx.
AutoNDA by SimpleDocs

Related to PRE-STRESSING STEEL

  • Loop Provisioning Involving Integrated Digital Loop Carriers 2.6.1 Where Xxxx has requested an Unbundled Loop and BellSouth uses IDLC systems to provide the local service to the End User and BellSouth has a suitable alternate facility available, BellSouth will make such alternative facilities available to Xxxx. If a suitable alternative facility is not available, then to the extent it is technically feasible, BellSouth will implement one of the following alternative arrangements for Xxxx (e.g. hairpinning): 1. Roll the circuit(s) from the IDLC to any spare copper that exists to the customer premises. 2. Roll the circuit(s) from the IDLC to an existing DLC that is not integrated. 3. If capacity exists, provide "side-door" porting through the switch. 4. If capacity exists, provide "Digital Access Cross Connect System (DACS)- door" porting (if the IDLC routes through a DACS prior to integration into the switch). 2.6.2 Arrangements 3 and 4 above require the use of a designed circuit. Therefore, non- designed Loops such as the SL1 voice grade and UCL-ND may not be ordered in these cases. 2.6.3 If no alternate facility is available, and upon request from Xxxx, and if agreed to by both Parties, BellSouth may utilize its Special Construction (SC) process to determine the additional costs required to provision facilities. Xxxx will then have the option of paying the one-time SC rates to place the Loop.

  • Shared Transport The Shared Transport Network Element (“Shared Transport”) provides the collective interoffice transmission facilities shared by various Carriers (including Qwest) between end-office switches and between end-office switches and local tandem switches within the Local Calling Area. Shared Transport uses the existing routing tables resident in Qwest switches to carry the End User Customer’s originating and terminating local/extended area service interoffice Local traffic on the Qwest interoffice message trunk network. CLEC traffic will be carried on the same transmission facilities between end- office switches, between end-office switches and tandem switches and between tandem switches on the same network facilities that Qwest uses for its own traffic. Shared Transport does not include use of tandem switches or transport between tandem switches and end-office switches for Local Calls that originate from end users served by non- Qwest Telecommunications Carriers (“Carrier(s)”) which terminate to QLSP End Users.

  • Portfolio Transactions The Manager is authorized to select the brokers or dealers that will execute the purchases and sales of portfolio securities for the Portfolio and is directed to use its best efforts to obtain the best available prices and most favorable executions, except as prescribed herein. It is understood that the Manager will not be deemed to have acted unlawfully, or to have breached a fiduciary duty to the Fund or to the Portfolio, or be in breach of any obligation owing to the Fund or to the Portfolio under this Agreement, or otherwise, solely by reason of its having caused the Portfolio to pay a member of a securities exchange, a broker, or a dealer a commission for effecting a securities transaction for the Portfolio in excess of the amount of commission another member of an exchange, broker, or dealer would have charged if the Manager determines in good faith that the commission paid was reasonable in relation to the brokerage or research services provided by such member, broker, or dealer, viewed in terms of that particular transaction or the Manager’s overall responsibilities with respect to its accounts, including the Fund, as to which it exercises investment discretion. The Manager will promptly communicate to the officers and directors of the Fund such information relating to transactions for the Portfolio as they may reasonably request.

  • TREE TRIMMING Grantee or its designee shall have the authority to trim trees on public property at its own expense as may be necessary to protect its wires and facilities.

  • RAI MDS Without limiting the foregoing, the HSP (1) will conduct quarterly assessments of Residents, and all other assessments of Residents required by the RAI MDS Tools, using the RAI MDS Tools; (2) will ensure that the RAI MDS Tools are used correctly to produce an accurate assessment of the HSP’s Residents (“RAI MDS Data”);

  • Loss Leader; Recycled Products Contractor shall not sell or use any article or product as a “loss leader” as defined in Section 17030 of the Business and Professions Code. If Contractor will sell to the Judicial Council, or use in the performance of this Agreement, goods specified in PCC 12207 (for example, certain paper products, office supplies, mulch, glass products, lubricating oils, plastic products, paint, antifreeze, tires and tire-derived products, and metal products), then with respect to those goods: (i) Contractor shall use recycled products in the performance of this Agreement to the maximum extent doing so is economically feasible, and (ii) upon request, Contractor shall certify in writing under penalty of perjury, the minimum, if not exact, percentage of post consumer material as defined in the PCC 12200, in such goods regardless of whether the goods meet the requirements of PCC 12209.

  • Dark Fiber Transport Dark Fiber Transport is defined as Dedicated Transport that consists of unactivated optical interoffice transmission facilities without attached signal regeneration, multiplexing, aggregation or other electronics. Except as set forth in Section 6.9.1 below, BellSouth shall not be required to provide access to Dark Fiber Transport Entrance Facilities pursuant to this Agreement.

  • Single Source Selection Services for tasks in circumstances which meet the requirements of paragraph 3.10 of the Consultant Guidelines for Single Source Selection, may, with the Association's prior agreement, be procured in accordance with the provisions of paragraphs 3.9 through 3.13 of the Consultant Guidelines.

  • Components Patheon will purchase and test all Components (with the exception of Client-Supplied Components) at Patheon’s expense and as required by the Specifications.

  • Fund/SERV Transactions If the parties choose to use the National Securities Clearing Corporation’s Mutual Fund Settlement, Entry and Registration Verification (“Fund/SERV”) or any other NSCC service, the following provisions shall apply: The Company and the Fund or its designee will each be bound by the rules of the National Securities Clearing Corporation (“NSCC”) and the terms of any NSCC agreement filed by it or its designee with the NSCC. Without limiting the generality of the following provisions of this section, the Company and the Fund or its designee will each perform any and all duties, functions, procedures and responsibilities assigned to it and as otherwise established by the NSCC applicable to Fund/SERV, the Mutual Fund Profile Service, the Networking Matrix Level utilized and any other relevant NSCC service or system (collectively, the “NSCC Systems”). Any information transmitted through the NSCC Systems by any party or its designee to the other or its designee and pursuant to this Agreement will be accurate, complete, and in the format prescribed by the NSCC. Each party or its designee will adopt, implement and maintain procedures reasonably designed to ensure the accuracy of all transmissions through the NSCC Systems and to limit the access to, and the inputting of data into, the NSCC Systems to persons specifically authorized by such party. On each day on which the New York Stock Exchange is open for trading and on which the Fund calculates its net asset value pursuant to the rules of the SEC (“Business Day”), the Company shall aggregate and calculate the net purchase and redemption orders for each Account received by the Company by the close of the New York Stock Exchange (generally, 4:00 p.m. Eastern Time) (the “Close of Trading”) on the Business Day. The Company shall communicate to the Fund or its designee for that Business Day, by Fund/SERV, the net aggregate purchase or redemption orders (if any) for each Account received by the Close of Trading on such Business Day (the “Trade Date”) no later than 7:00 a.m. Eastern Time (or such other time as may be agreed by the parties from time to time) (the “Fund/SERV Transactions Deadline”) on the Business Day following the Trade Date. All such aggregated orders communicated to the Fund or its designee by the Fund/SERV Transactions Deadline on the Business Day following the Trade Date shall be treated by the Fund or its designee as if received prior to the Close of Trading on the Trade Date. All orders received by the Company after the Close of Trading on a Business Day shall not be aggregated with Orders received by the Company prior to the Close of Trading on such Business Day and shall be communicated to BRIL or its designee as part of an aggregated order no sooner than after the FUND/SERV Transactions Deadline or such other time as may be agreed by the parties from time to time) the following Business Day. Cash settlement shall be transmitted pursuant to the normal NSCC settlement process. In the case of delayed settlement, the Fund or its designee shall make arrangements for the settlement of redemptions by wire no later than the time permitted for settlement of redemption orders by the 1940 Act. Unless otherwise informed in writing, such redemption wires should be sent to an account specified by the Company and agreed to by Fund Parties.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!