PREDELIVERY PAYMENT REFERENCE PRICE CALCULATION METHOD. Notwithstanding the provisions of Subclause 6.2.3 of the Agreement, the Predelivery Payment Reference Price for the Aircraft is ***.
PREDELIVERY PAYMENT REFERENCE PRICE CALCULATION METHOD Sample Clauses
Related to PREDELIVERY PAYMENT REFERENCE PRICE CALCULATION METHOD
Payment Calculation District shall pay Contractor at a rate of $ per . District shall pay Contractor as described in attached Exhibit A
Calculation of Purchase Price The bank’s ownership interest in a security will be quantified one of two ways: (i) number of shares or other units, as applicable (in the case of equity securities) or (ii) par value or notational amount, as applicable (in the case of non-equity securities). As a result, the purchase price (except where determined pursuant to clause (ii) of the preceding paragraph) shall be calculated one of two ways, depending on whether or not the security is an equity security: (i) the purchase price for an equity security shall be calculated by multiplying the number of shares or other units by the applicable market price per unit; and (ii) the purchase price for a non-equity security shall be an amount equal to the applicable market price (expressed as a decimal), multiplied by the par value for such security (based on the payment factor most recently widely available). The purchase price also shall include accrued interest as calculated below (see Calculation of Accrued Interest), except to the extent the parties may otherwise expressly agree, pursuant to clause (ii) of the preceding paragraph. If the factor used to determine the par value of any security for purposes of calculating the purchase price, is not for the period in which the Bank Closing Date occurs, then the purchase price for that security shall be subject to adjustment post-closing based on a “cancel and correct” procedure. Under this procedure, after such current factor becomes publicly available, the Receiver will recalculate the purchase price utilizing the current factor and related interest rate, and will notify the Assuming Institution of any difference and of the applicable amount due from one party to the other. Such amount will then be paid as part of the settlement process pursuant to Article VIII.
Average Log Length and Payment Reduction If the average log length for all logs delivered under this contract is less than the average log length specified in the table in clause G-024.2, The amount of allowable payment reduction shall be calculated by multiplying the payment rate in P-028.2 by the total volume delivered, and the difference between the average length of logs delivered and the average log length specified in G-024.2, times 1% as follows: Log Length Payment Reduction = (B x V x L) x (.01) Where: B = Bid rate from P-028.2 clause V = total delivered log Volume L = Length in feet below specified average (rounded to nearest Average log length payment reductions calculated by the Purchaser must be approved by the State, prior to payment for the final billing period. Third-party scaling organization information is required to determine Xxxxxxxx mbf and Average log length for payment reduction purposes. Average log length is determined on a piece count basis. Value of log length price reduction will be derived from the applicable sort value as described in this contract. Scale information for determining Average log length for payment reduction eligibility must be obtained from roll-out scale. Truck-ramp, sample scaling, and/or bundle scaling information is not acceptable for determining eligibility. Purchaser’s exclusive remedy for below average log lengths shall be the payment reduction described in this clause, notwithstanding other provisions in the Uniform Commercial Code.
PRICE ESCALATION/DE-ESCALATION (CPI) The County may allow a price escalation provision within this award. The original contract prices shall be firm for an initial one (1) year period. A price escalation/de-escalation will be considered at one (1) year intervals thereafter, provided the Contractor notifies the County, in writing, of the pending price escalation/de-escalation a minimum of sixty (60) days prior to the effective date. Price adjustments shall be based on the latest version of the Consumers Price Index (CPI-U) for All Urban Consumers, All Items, U.S. City Average, non-seasonal, as published by the U.S. Department of Labor, Bureau of Labor Statistics. This information is available at xxx.xxx.xxx. Price adjustment shall be calculated by applying the simple percentage model to the CPI data. This method is defined as subtracting the base period index value (at the time of initial award) from the index value at time of calculation (latest version of the CPI published as of the date of request for price adjustment), divided by the base period index value to identify percentage of change, then multiplying the percentage of change by 100 to identify the percentage change. Formula is as follows: Current Index – Base Index / Base Index = % of Change CPI for current period 232.945 Less CPI for base period 229.815 Equals index point change 3.130 Divided by base period CPI 229.815 Equals 0.0136 Result multiplied by 100 0.0136 x 100 Equals percent change 1.4% % of Change x 100 = Percentage Change CPI-U Calculation Example: A price increase may be requested only at each time interval specified above, using the methodology outlined in this section. To request a price increase, Contractor shall submit a letter stating the percentage amount of the requested increase and adjusted price to the Orange County Procurement Division. The letter shall include the complete calculation utilizing the formula above, and a copy of the CPI-U index table used in the calculation. The maximum allowable increase shall not exceed 4%, unless authorized by the Manager, Procurement Division. All price adjustments must be accepted by the Manager, Procurement Division and shall be memorialized by written amendment to this contract. No retroactive contract price adjustments will be allowed. Should the CPI-U for All Urban Consumers, All Items, U.S City Average, as published by the U.S. Department of Labor, Bureau of Labor Statistics decrease during the term of the contract, or any renewals, the Contractor shall notify the Orange County Procurement Division of price decreases in the method outlined above. If approved, the price adjustment shall become effective on the contract renewal date. If the Contractor fails to pass the decrease on to the County, the County reserves the right to place the Contractor in default, cancel the award, and remove the Contractor from the County Vendor List for a period of time deemed suitable by the County. In the event of this occurrence, the County further reserves the right to utilize any options as stated herein.
Aircraft Basic Price The Aircraft Basic Price is listed in Table 1 and is subject to escalation in accordance with the terms of this Purchase Agreement.
Price Adjustment Civil works contracts of long duration (more than 18 months) shall contain an appropriate price adjustment clause.
Subsequent Recalculation In the event the Internal Revenue Service adjusts the computation of the Company under Section 5.2 herein so that the Executive did not receive the greatest net benefit, the Company shall reimburse the Executive for the full amount necessary to make the Executive whole, plus a market rate of interest, as determined by the Committee, within 30 days after such adjustment.
Commercial Price List Reductions Where NYS Net Prices are based on a discount from Contractor’s list prices, price decreases shall take effect automatically during the Contract term and apply to Purchase Orders submitted on or after the date Contractor lowers its pricing to its customers generally or to similarly situated government customers during the Contract term; or
Purchase Price Adjustment (a) Within 90 days following the Closing, the Buyer shall prepare and deliver, or cause to be prepared and delivered, to the Seller a statement (the “Closing Schedule”) setting forth: (i) the Buyer’s determination of the actual amounts of (A) the Adjustment Amount, including the Final Adjustment Amount Overage or the Final Adjustment Amount Underage (the “Final Adjustment Amount”), and (B) the Seller Indebtedness Amount, in each case as of 12:01 a.m. Eastern Time on the Closing Date without taking into account any of the transactions to be completed on the Closing Date in accordance with the terms of this Agreement; (ii) a calculation of any adjustments to the Closing Payment based on such calculations (the adjusted Closing Payment as a result of such calculation being the “Final Closing Payment”); and (iii) a calculation of the accounts receivable contained in the Preliminary Adjustment Amount that were not collected by Buyer within the thirty (30) days immediately following the Closing and the accounts receivable existing at the Closing but not taken into account in calculating the Adjustment Amount (the “Excluded AR”). (b) Within fifteen (15) days after delivery of the Closing Schedule, the Seller may deliver a notice to Buyer either: (i) concurring with the Closing Schedule (a “Notice of Concurrence”); or (ii) disagreeing therewith (a “Notice of Disagreement”). If the Seller delivers a Notice of Disagreement, then it shall be accompanied by the Seller’s proposed revisions to the Closing Schedule. If the Seller fails to deliver any notice within such 15-day period, the Seller shall be deemed to have delivered a Notice of Concurrence. (c) If a Notice of Concurrence is delivered or deemed delivered, and if the Final Closing Payment is less than the Closing Payment, the Buyer shall be entitled to payment out of the Royalty Consideration in the full amount of such shortfall. If a Notice of Concurrence is delivered or deemed delivered, and the Final Closing Payment is greater than the Closing Payment, Buyer shall pay to the Seller the full amount of such excess (with such payment being in shares of Buyer Common Stock priced at $1.50 per share) within thirty (30) days of the delivery of the Notice of Concurrence. (d) If a Notice of Disagreement is delivered, then the Seller and the Buyer shall, during the 15-day period following such delivery (the “Negotiation Period”), use commercially reasonable efforts to agree on the Final Adjustment Amount. If, during such period, the Seller and the Buyer are unable to reach agreement, they promptly shall engage a nationally recognized certified public accounting firm reasonably acceptable to each such party (the “Independent Auditor”) to resolve the disagreement, and any such resolution shall be final, conclusive and binding upon the parties hereto, absent fraud or manifest error. To the extent the Final Closing Payment as determined by the Independent Auditor is less than the Closing Payment, the Buyer shall be entitled to payment out of the Royalty Consideration in the full amount of such shortfall. To the extent the Final Closing Payment as determined by the Independent Auditor is more than the Closing Payment, the Buyer shall pay to the Seller the full amount of such excess (with such payment being in shares of Buyer Common Stock priced at $1.50 per share) within thirty (30) days of such resolution. (e) Each of the Seller and the Buyer shall pay fifty percent (50%) of the fees and expenses of the Independent Auditor.
Non pre-priced Adjustment Factor To be applied to Work determined not to be included in the CTC but within the general scope of the work: 1.6500.
