Calculation of Purchase Price The bank’s ownership interest in a security will be quantified one of two ways: (i) number of shares or other units, as applicable (in the case of equity securities) or (ii) par value or notational amount, as applicable (in the case of non-equity securities). As a result, the purchase price (except where determined pursuant to clause (ii) of the preceding paragraph) shall be calculated one of two ways, depending on whether or not the security is an equity security: (i) the purchase price for an equity security shall be calculated by multiplying the number of shares or other units by the applicable market price per unit; and (ii) the purchase price for a non-equity security shall be an amount equal to the applicable market price (expressed as a decimal), multiplied by the par value for such security (based on the payment factor most recently widely available). The purchase price also shall include accrued interest as calculated below (see Calculation of Accrued Interest), except to the extent the parties may otherwise expressly agree, pursuant to clause (ii) of the preceding paragraph. If the factor used to determine the par value of any security for purposes of calculating the purchase price, is not for the period in which the Bank Closing Date occurs, then the purchase price for that security shall be subject to adjustment post-closing based on a “cancel and correct” procedure. Under this procedure, after such current factor becomes publicly available, the Receiver will recalculate the purchase price utilizing the current factor and related interest rate, and will notify the Assuming Institution of any difference and of the applicable amount due from one party to the other. Such amount will then be paid as part of the settlement process pursuant to Article VIII.
Price Adjustment Civil works contracts of long duration (more than 18 months) shall contain an appropriate price adjustment clause.
Average Log Length and Payment Reduction If the average log length for all logs delivered under this contract is less than the average log length specified in the table in clause G-024.2, The amount of allowable payment reduction shall be calculated by multiplying the payment rate in P-028.2 by the total volume delivered, and the difference between the average length of logs delivered and the average log length specified in G-024.2, times 1% as follows: Log Length Payment Reduction = (B x V x L) x (.01) Where: B = Bid rate from P-028.2 clause V = total delivered log Volume L = Length in feet below specified average (rounded to nearest Average log length payment reductions calculated by the Purchaser must be approved by the State, prior to payment for the final billing period. Third-party scaling organization information is required to determine Xxxxxxxx mbf and Average log length for payment reduction purposes. Average log length is determined on a piece count basis. Value of log length price reduction will be derived from the applicable sort value as described in this contract. Scale information for determining Average log length for payment reduction eligibility must be obtained from roll-out scale. Truck-ramp, sample scaling, and/or bundle scaling information is not acceptable for determining eligibility. Purchaser’s exclusive remedy for below average log lengths shall be the payment reduction described in this clause, notwithstanding other provisions in the Uniform Commercial Code.
Payment Calculation District shall pay Contractor at a rate of $ per . District shall pay Contractor as described in attached Exhibit A
PRICE ESCALATION/DE-ESCALATION (CPI) The County may allow a price escalation provision within this award. The original contract prices shall be firm for an initial one (1) year period. A price escalation/de-escalation will be considered at one (1) year intervals thereafter, provided the Contractor notifies the County, in writing, of the pending price escalation/de-escalation a minimum of sixty (60) days prior to the effective date. Price adjustments shall be based on the latest version of the Consumers Price Index (CPI-U) for All Urban Consumers, All Items, U.S. City Average, non-seasonal, as published by the U.S. Department of Labor, Bureau of Labor Statistics. This information is available at xxx.xxx.xxx. Price adjustment shall be calculated by applying the simple percentage model to the CPI data. This method is defined as subtracting the base period index value (at the time of initial award) from the index value at time of calculation (latest version of the CPI published as of the date of request for price adjustment), divided by the base period index value to identify percentage of change, then multiplying the percentage of change by 100 to identify the percentage change. Formula is as follows: Current Index – Base Index / Base Index = % of Change CPI for current period 232.945 Less CPI for base period 229.815 Equals index point change 3.130 Divided by base period CPI 229.815 Equals 0.0136 Result multiplied by 100 0.0136 x 100 Equals percent change 1.4% % of Change x 100 = Percentage Change CPI-U Calculation Example: A price increase may be requested only at each time interval specified above, using the methodology outlined in this section. To request a price increase, Contractor shall submit a letter stating the percentage amount of the requested increase and adjusted price to the Orange County Procurement Division. The letter shall include the complete calculation utilizing the formula above, and a copy of the CPI-U index table used in the calculation. The maximum allowable increase shall not exceed 4%, unless authorized by the Manager, Procurement Division. All price adjustments must be accepted by the Manager, Procurement Division and shall be memorialized by written amendment to this contract. No retroactive contract price adjustments will be allowed. Should the CPI-U for All Urban Consumers, All Items, U.S City Average, as published by the U.S. Department of Labor, Bureau of Labor Statistics decrease during the term of the contract, or any renewals, the Contractor shall notify the Orange County Procurement Division of price decreases in the method outlined above. If approved, the price adjustment shall become effective on the contract renewal date. If the Contractor fails to pass the decrease on to the County, the County reserves the right to place the Contractor in default, cancel the award, and remove the Contractor from the County Vendor List for a period of time deemed suitable by the County. In the event of this occurrence, the County further reserves the right to utilize any options as stated herein.
Supply Price The Initial Term “Supply Price” for the “Monthly Fixed Price Volume” set forth on Exhibit A shall be $[______]/MWh for the first [***] years of the Initial Term, and thereafter shall be the then-current market price as mutually agreed by Customer and Supplier prior to the end of the [***] year. The Extension Term Supply Price, if any, will be the then-current market price as mutually agreed by Customer and Supplier prior to entering into the Extension Term. Supplier and Customer may agree to fix the Supply Price for one or more periods during the Term that individually and in total are shorter than the full Term. Exhibit A sets forth the hourly delivery volume for which the Energy Price will be fixed during each month of the Term to take into account the phase-in of the facility which is expected to progress at a rate of approximately [***]MW per month (the “Monthly Fixed Price Volume”). Supplier represents that Supplier has used commercially reasonable efforts to set such Supply Price at approximately [***]% discount to the forward price at which Supplier xxxxxx its delivery obligations under this Transaction Confirmation with respect to any financial or physical energy supply arrangement intended to cover the Monthly Fixed Price Volume, the settlement index (ERCOT North Load Zone), and this Transaction Confirmation term. The [***]% discount shall be revised to take into account any physical or software limitations originating from Customer and limiting Supplier’s ability to curtail 100% of the load at the Data Center. Exhibit A also sets forth the minimum load that Customer has designated as not subject to economic curtailment (“Non-Curtailable Load”), which represents, among other things, the Motor Control Center (MCC), and other essential server and administrative load. Customer and Supplier can, in the context of the immediately preceding sentence, agree on a lesser than [***]% discount with respect to the Supply Price to account for Supplier’s incremental cost of providing a fixed Supply Price for Non-Curtailable Load.
Purchase Price Adjustment (a) Within 90 days following the Closing, the Buyer shall prepare and deliver, or cause to be prepared and delivered, to the Seller a statement (the “Closing Schedule”) setting forth: (i) the Buyer’s determination of the actual amounts of (A) the Adjustment Amount, including the Final Adjustment Amount Overage or the Final Adjustment Amount Underage (the “Final Adjustment Amount”), and (B) the Seller Indebtedness Amount, in each case as of 12:01 a.m. Eastern Time on the Closing Date without taking into account any of the transactions to be completed on the Closing Date in accordance with the terms of this Agreement; (ii) a calculation of any adjustments to the Closing Payment based on such calculations (the adjusted Closing Payment as a result of such calculation being the “Final Closing Payment”); and (iii) a calculation of the accounts receivable contained in the Preliminary Adjustment Amount that were not collected by Buyer within the thirty (30) days immediately following the Closing and the accounts receivable existing at the Closing but not taken into account in calculating the Adjustment Amount (the “Excluded AR”). (b) Within fifteen (15) days after delivery of the Closing Schedule, the Seller may deliver a notice to Buyer either: (i) concurring with the Closing Schedule (a “Notice of Concurrence”); or (ii) disagreeing therewith (a “Notice of Disagreement”). If the Seller delivers a Notice of Disagreement, then it shall be accompanied by the Seller’s proposed revisions to the Closing Schedule. If the Seller fails to deliver any notice within such 15-day period, the Seller shall be deemed to have delivered a Notice of Concurrence. (c) If a Notice of Concurrence is delivered or deemed delivered, and if the Final Closing Payment is less than the Closing Payment, the Buyer shall be entitled to payment out of the Royalty Consideration in the full amount of such shortfall. If a Notice of Concurrence is delivered or deemed delivered, and the Final Closing Payment is greater than the Closing Payment, Buyer shall pay to the Seller the full amount of such excess (with such payment being in shares of Buyer Common Stock priced at $1.50 per share) within thirty (30) days of the delivery of the Notice of Concurrence. (d) If a Notice of Disagreement is delivered, then the Seller and the Buyer shall, during the 15-day period following such delivery (the “Negotiation Period”), use commercially reasonable efforts to agree on the Final Adjustment Amount. If, during such period, the Seller and the Buyer are unable to reach agreement, they promptly shall engage a nationally recognized certified public accounting firm reasonably acceptable to each such party (the “Independent Auditor”) to resolve the disagreement, and any such resolution shall be final, conclusive and binding upon the parties hereto, absent fraud or manifest error. To the extent the Final Closing Payment as determined by the Independent Auditor is less than the Closing Payment, the Buyer shall be entitled to payment out of the Royalty Consideration in the full amount of such shortfall. To the extent the Final Closing Payment as determined by the Independent Auditor is more than the Closing Payment, the Buyer shall pay to the Seller the full amount of such excess (with such payment being in shares of Buyer Common Stock priced at $1.50 per share) within thirty (30) days of such resolution. (e) Each of the Seller and the Buyer shall pay fifty percent (50%) of the fees and expenses of the Independent Auditor.
Base Purchase Price Buyer agrees to pay for the Assets the total sum of Thirty Million and No/100 Dollars ($30,000,000.00) (“Base Purchase Price”) to be paid by direct bank deposit or wire transfer in same day funds at the Closing, subject only to the price adjustments set forth in this Agreement.
Price Schedule, Payment Terms and Billing, and Price Adjustments (a) Price Schedule: Price Schedule under this Contract is set forth in Exhibit B.
Determination of Purchase Price The Securities Administrator will be responsible for determining the Purchase Price for any Mortgage Loan that is sold by the Trust or with respect to which provision is made for the escrow of funds pursuant to this Section 2.03 and shall at the time of any purchase or escrow certify such amounts to the Depositor; provided that the Securities Administrator may consult with the Servicer to determine the Purchase Price unless the Servicer is the Purchaser of such Mortgage Loan. If, for whatever reason, the Securities Administrator shall determine that there is a miscalculation of the amount to be paid to the Trust, the Securities Administrator shall from monies in a Distribution Account return any overpayment that the Trust received as a result of such miscalculation to the applicable Purchaser upon the discovery of such overpayment, and the Securities Administrator shall collect from the applicable Purchaser for deposit to the Securities Account any underpayment that resulted from such miscalculation upon the discovery of such underpayment. Recovery may be made either directly or by set-off of all or any part of such underpayment against amounts owed by the Trust to such Purchaser.
