Radon Reduction. In units known to have high radon levels:
Radon Reduction Sample Clauses
Related to Radon Reduction
Staff Reduction In the event the District adopts a reduced educational program by reason of financial necessity, including but not limited to, levy failure and/or decreased State or Federal support, certificated employees who will be retained to implement the District’s reduced or modified program and those certificated employees who will be non-renewed from employment or adversely affected in contract status shall be identified by the provisions contained in this Article. If the District is only reducing provisional employees, the following procedures do not need to be implemented.
WORKFORCE REDUCTION In the event that funding reductions or shortfalls in funding occur in a department or are expected, which may result in layoffs, the department will notify the union and take the following actions:
Average Log Length and Payment Reduction If the average log length for all logs delivered under this contract is less than the average log length specified in the table in clause G-024.2, The amount of allowable payment reduction shall be calculated by multiplying the payment rate in P-028.2 by the total volume delivered, and the difference between the average length of logs delivered and the average log length specified in G-024.2, times 1% as follows: Log Length Payment Reduction = (B x V x L) x (.01) 1/10th) Where: B = Bid rate from P-028.2 clause V = total delivered log Volume L = Length in feet below specified average (rounded to nearest Average log length payment reductions calculated by the Purchaser must be approved by the State, prior to payment for the final billing period. Third-party scaling organization information is required to determine Xxxxxxxx mbf and Average log length for payment reduction purposes. Average log length is determined on a piece count basis. Value of log length price reduction will be derived from the applicable sort value as described in this contract. Scale information for determining Average log length for payment reduction eligibility must be obtained from roll-out scale. Truck-ramp, sample scaling, and/or bundle scaling information is not acceptable for determining eligibility. Purchaser’s exclusive remedy for below average log lengths shall be the payment reduction described in this clause, notwithstanding other provisions in the Uniform Commercial Code.
Rate Redetermination after Catastro- phic Damage In event of Catastrophic Damage and ad- justment, if any, of Included Timber, Contracting Officer shall make an appraisal to determine for each species the catastrophe-caused difference between the appraised unit value of Included Timber remaining immediately prior to the catastrophe and the appraised unit value of existing and potential Included Timber immediately after the ca- tastrophe. Included Timber is any that would not be elimi- nated under B8.32. Potential Included Timber is any that would be added under B8.32. Tentative Rates and Flat Rates in effect at the time of catastrophe shall be adjusted by said differences to be- come the redetermined rates for the purpose of a contract modification under B8.32. Accordingly, Base Rates shall be adjusted to correspond to the redetermined rates if redetermined rates are less than the original Base Rates, subject to new Base Rate limitations of 25 cents per hun- dred cubic feet or equivalent. However, existing Base In- dices shall not be changed under this Subsection. Upon agreement under B8.32, redetermined rates and Required Deposits shall be considered established under B3.1 for timber Scaled subsequent to Catastrophic Damage. At time of such appraisal, Specified Road construc- tion cost shall include the estimated cost of any construc- tion work listed in the Schedule of Items performed and abandoned.
Reduction A. No regular employee or limited-term regular employee shall be reduced to a position in a lower class for reasons of unsatisfactory performance or physical disability except for reasonable cause.
Allocation of Subordinate Reduction Amount to the Reference Tranches On each Payment Date prior to the Termination Date, after allocation of the Senior Reduction Amount and the Tranche Write-down Amount or Tranche Write-up Amount, if any, for such Payment Date as described above, the Subordinate Reduction Amount will be allocated to reduce the Class Notional Amount of each Class of Reference Tranche in the following order of priority, in each case until its Class Notional Amount is reduced to zero:
Reduction in scope of agreement for fault 19.1.1 If the Grantee does not comply with an obligation under this Agreement and the Commonwealth believes that the non‐compliance is incapable of remedy, or if the Grantee has failed to comply with a notice to remedy, the Commonwealth may by written notice reduce the scope of the Agreement.
Workforce Adjustment (a) The Parties recognize that workforce adjustment may be necessary due to the elimination of positions resulting from a reduction in the amount of work required to be done by the Commission, reorganization or program termination.
Reduction of Compensation If the Firm fails to meet the submission date by less than thirty days for the draft report and/or working papers submitted to the Office of the State Auditor for review and approval or by less than thirty days from the completion date for the final reports and/or corrections to the working papers prescribed herein, the District may, with the consent of the Office of the State Auditor, reduce the agreed compensation by an amount not to exceed ten percent of the total contract price for the applicable fiscal year. If reports and/or corrections to the working papers are overdue by 30 days or more, the District may reduce, with the consent of the Office of the State Auditor, the agreed compensation by an amount not to exceed twenty percent of the total contract price for the Rev. 10/20 applicable fiscal year.
Salary on Reduction A. 1. When a probationary employee is reduced to a class not previously occupied by the employee, the employee shall receive the recruiting step for the lower class and shall receive a new merit increase eligibility date as provided in Section 3.C., above, or the employee's salary and merit increase eligibility date may be determined by the Chief Human Resources Officer.
