Removal of parts The Borrower shall not remove any material part of the Ship, or any item of equipment installed on the Ship, unless the part or item so removed is forthwith replaced by a suitable part or item which is in the same condition as or better condition than the part or item removed, is free from any Security Interest or any right in favour of any person other than the Lender and becomes on installation on the Ship the property of the Borrower and subject to the security constituted by the Mortgage Provided that the Borrower may install equipment owned by a third party if the equipment can be removed without any risk of damage to the Ship.
Replacement of Parts Except as otherwise provided herein, so long as the Airframe or Engine is subject to the Lien of this Indenture, Owner, at its own cost and expense, will, or will cause a Permitted Lessee to, at its own cost and expense, promptly replace (or cause to be replaced) all Parts which may from time to time be incorporated or installed in or attached to the Aircraft, Airframe or any Engine and which may from time to time become worn out, lost, stolen, destroyed, seized, confiscated, damaged beyond repair or permanently rendered unfit for use for any reason whatsoever. In addition, Owner may, at its own cost and expense, or may permit a Permitted Lessee at its own cost and expense to, remove (or cause to be removed) in the ordinary course of maintenance, service, repair, overhaul or testing any Parts, whether or not worn out, lost, stolen, destroyed, seized, confiscated, damaged beyond repair or permanently rendered unfit for use; provided, however, that Owner, except as otherwise provided herein, at its own cost and expense, will, or will cause a Permitted Lessee at its own cost and expense to, replace such Parts as promptly as practicable. All replacement parts shall be free and clear of all Liens, except for Permitted Liens and pooling arrangements to the extent permitted by Section 4.04(c) below (and except in the case of replacement property temporarily installed on an emergency basis) and shall be in good operating condition and have a value and utility not less than the value and utility of the Parts replaced (assuming such replaced Parts were in the condition required hereunder).
Supply of Materials Unless the parties otherwise agree in a Work Order, Manufacturer will supply, in accordance with the relevant approved raw material specifications, all materials to be used by Manufacturer in the performance of Services under a Work Order other than the Rhythm Materials specified in such Work Order. Rhythm or its designees will provide Manufacturer with the Rhythm Materials. Manufacturer agrees (a) to account for all Rhythm Materials, (b) not to provide Rhythm Materials to any third party (other than an Affiliate acting as a permitted subcontractor) without the express prior written consent of Rhythm, (c) not to use Rhythm Materials for any purpose other than conducting the Services, including, without limitation, not to analyze, characterize, modify or reverse engineer any Rhythm Materials or take any action to determine the structure or composition of any Rhythm Materials unless required * CONFIDENTIAL TREATMENT REQUESTED. OMITTED PORTIONS FILED WITH THE SECURITIES AND EXCHANGE COMMISSION PURSUANT TO RULE 406 PROMULGATED UNDER THE SECURITIES ACT OF 1933, AS AMENDED. pursuant to a signed Work Order, and (d) to destroy or return to Rhythm all unused quantities of Rhythm Materials according to Rhythm’s written directions.
Pooling of Parts Any Part removed from the Aircraft, Airframe or an Engine may be subjected by the Owner or a Permitted Lessee to a normal pooling arrangement customary in the airline industry and entered into in the ordinary course of business of Owner or Permitted Lessee, provided that the part replacing such removed Part shall be incorporated or installed in or attached to such Airframe or any Engine in accordance with Sections 4.04(a) and 4.04(b) as promptly as practicable after the removal of such removed Part. In addition, any replacement part when incorporated or installed in or attached to the Airframe or any Engine may be owned by any third party, subject to a normal pooling arrangement, so long as the Owner or a Permitted Lessee, at its own cost and expense, as promptly thereafter as reasonably possible, either (i) causes such replacement part to become subject to the Lien of this Trust Indenture, free and clear of all Liens except Permitted Liens, at which time such replacement part shall become a Part or (ii) replaces (or causes to be replaced) such replacement part by incorporating or installing in or attaching to the Aircraft, Airframe or any Engine a further replacement part owned by the Owner free and clear of all Liens except Permitted Liens and which shall become subject to the Lien of this Trust Indenture in accordance with Section 4.04(b).
No Improper Use of Materials During his or her employment with the Company, Employee will not improperly use or disclose any Confidential Information or trade secrets, if any, of any former employer or any other person to whom Employee has an obligation of confidentiality, and Employee will not bring onto the premises of the Company any unpublished documents or any property belonging to any former employer or any other person to whom Employee has an obligation of confidentiality unless consented to in writing by that former employer or person.
Substitution of Party Effective as of the date first written above, the Adviser is substituted into the Agreement in place of ILIAC for all purposes.
Removal of Improvements Except as otherwise expressly agreed to by Lessor and Lessee, Lessee shall have the right to remove all Tank Farm Assets and other improvements, fixtures, equipment, materials, supplies and personal property installed by Lessee from the Premises upon the termination or expiration of this Lease, but in no event later than the date that is 120 days following the expiration or termination of this Lease (the “Removal Date”) and Lessor shall provide Lessee with access to the Premises at reasonable times until expiration of the Removal Date for the purpose of removing such items. Lessee shall provide Lessor with written notice of its election to remove the Tank Farm Assets and other improvements, fixtures, equipment, materials, supplies and personal property from the Premises at least 60 days prior to the expiration of the Lease. If Lessee elects to remove the Tank Farm Assets and Improvements from the Premises after such removal Lessee shall restore any damage to the Premises and clean the Premises so as to eliminate therefrom any accumulation (other than any de minimis and non-hazardous accumulation) of foreign substances, materials, or debris, in addition to any Environmental Cleanup that may be required under Article 10. Lessee shall pay Lessor pro rata Rent (based on the amount of Rent applicable during the last month prior to the termination or expiration) through the date of Lessee’s complete removal of all such items. During the period of such removal and clean-up, all terms and conditions of this Lease, including, the indemnity and insurance provisions shall continue in full force and effect. If Lessee elects not to remove all of the Tank Farm Assets and Improvements from the Premises on or before the Removal Date, and provided that such facilities are in good working condition at the expiration of the Term (ordinary wear and tear excepted) then, such Tank Farm Assets and Improvements shall be deemed permanently abandoned to Lessor’s sole ownership, and Lessor may remove and dispose of such facilities in any manner which Lessor may deem appropriate, without any liability whatsoever to Lessee. If Lessee elects not to remove all of the Tank Farm Assets and Improvements from the Premises on or before the Removal Date and such facilities are not in good working condition at the expiration of the term (ordinary wear and tear excepted), or Lessee fails to so remove any or all of the Tank Farm Assets and Improvements from the Premises before the Removal Date, then, in addition to all rights and remedies available at law or in equity, without any prior notice, Lessor may (but shall be under no obligation), at Lessor’s option, deem such Tank Farm Assets and Improvements to be permanently abandoned to Lessor’s sole ownership, and Lessor may remove and dispose of such facilities in any manner which Lessor may deem appropriate, without any liability whatsoever to Lessee, and Lessee shall reimburse Lessor for all costs of such removal and disposal upon demand from Lessor. If requested by Lessor, Lessee shall execute any and all documents necessary to evidence that title to the Tank Farm Assets and Improvements that Lessee does not remove by the Removal Date is in Lessor and to extinguish and remove any cloud or potential cloud on the title to the Premises and/or such facilities created by Lessee.
Defective Product If Client rejects Products under Section 6.1 and the deviation is determined to have arisen from Patheon’s failure to provide the Manufacturing Services in accordance with the Specifications, cGMPs, or Applicable Laws, Patheon will credit Client’s account for Patheon’s invoice price for the defective Products. If Client previously paid for the defective Products, Patheon will promptly, at Client’s election, either: (i) refund the invoice price for the defective THIS EXHIBIT HAS BEEN REDACTED AND IS THE SUBJECT OF A CONFIDENTIAL TREATMENT REQUEST. REDACTED MATERIAL IS MARKED WITH [***] AND HAS BEEN FILED SEPARATELY WITH THE SECURITIES AND EXCHANGE COMMISSION. Products; (ii) offset the amount paid against other amounts due to Patheon hereunder; or (iii) replace the Products with conforming Products without Client being liable for payment therefor under Section 3.1, contingent upon the receipt from Client of all Active Materials and Client-Supplied Components required for the manufacture of the replacement Products. For greater certainty, Patheon’s responsibility for any loss of Active Materials in defective Product will be captured and calculated in the Active Materials Yield under Section 2.2.
Transfer of Materials In the event Acceleron exercises its rights pursuant to Section 10.5.1, Celgene shall negotiate in good faith with Acceleron regarding Celgene transferring to Acceleron, at Acceleron’s cost, materials developed under this Agreement in the course of Developing and Commercializing Licensed Compounds or Licensed Products that are directly related to Licensed Compounds or Licensed Products to the extent provided in and in accordance with such agreement.
Product Specifications The Company agrees that all Products sold to Xxxx hereunder shall conform to the respective specifications set forth on Schedule A or to such other specifications as are from time to time agreed upon by the Parties.
