Release Conditions As used in this Agreement, "Release Conditions" shall mean the following:
Termination Conditions Such license shall not be terminated or its exploitation enjoined, until and unless: (i) Hitachi has committed a material breach of its obligations under this IP License Agreement, Opto-Device has given written notice of such breach to Hitachi and such breach remains uncured after the Cure Period, or, in the case of a breach, which cannot be cured within such Cure Period, Hitachi has not instituted within such Cure Period steps necessary to remedy the default and/or thereafter has not diligently pursued the same to completion; or (ii) such a material breach is incurable. In the event the breach is a curable breach that cannot be cured within the Cure Period but with respect to which Hitachi has instituted steps necessary to remedy the default and is thereafter diligently pursuing such cure, both parties shall negotiate to determine whether further pursuit of such cure is reasonable. If the parties cannot agree on a resolution in such negotiations, then this issue shall be referred to arbitration pursuant to the arbitration procedures set forth in Exhibit B hereto to decide whether such breach can be cured or any other alternative remedy should be adopted. In the event the breach is an incurable breach, the parties agree that the matter shall be referred to arbitration pursuant to the arbitration procedures set forth in Exhibit B hereto to determine the appropriate remedy. In the event that either party submits the dispute to arbitration, both parties shall cooperate in such binding arbitration in accordance with Exhibit B.
Prior Conditions Satisfied All conditions set forth in §10 shall continue to be satisfied as of the date upon which any Loan is to be made or any Letter of Credit is to be issued.
License Conditions Your exercise of the Licensed Rights is expressly made subject to the following conditions.
GUARANTEE CONDITIONS 4.1 The performance certification requirements for the Aircraft, except where otherwise noted, will be as stated in Section 02 of the Standard Specification. 4.2 For the determination of JAR take-off and landing performance a hard dry level runway surface with no runway strength limitations, no line-up allowances, no obstacles, zero wind, atmosphere according to ISA, except as otherwise noted, and the use of speed brakes, flaps, landing gear and engines in the conditions liable to provide the best results will be assumed. 4.2.1 When establishing take-off and second segment performance no air will be bled from the engines for cabin air conditioning or anti-icing.
Service Conditions Customer acknowledges that in the event of a service issue, Customer is responsible for on-site cooperative testing with LightEdge Technical Support to assist in the diagnosis of the trouble. Customer agrees to be bound to current terms of LightEdge Acceptable Use Policy. Terms of the Acceptable Use Policy are subject to change without notice. Current Acceptable Use Policy can be found here: xxxx://xxx.xxxxxxxxx.xxx/legal Customer agrees that any service complaints including concerns regarding level of support, products, service reliability, or any other concerns related to LightEdge or Services being provided by LIghtEdge will be communicated to LightEdge by sending an email to xx@xxxxxxxxx.xxx.
Vendor’s Conditions The Vendor shall not be obligated to complete the Transaction unless, at or before the Closing Time, each of the conditions listed below in this section has been satisfied, it being understood that the said conditions are included for the exclusive benefit of the Vendor: (a) The representations and warranties of YC in this Agreement shall be true and correct on the Closing Date. (b) YC shall have performed and complied with all of the terms and conditions in this Agreement and the Payment Undertaking on its part to be performed or complied with on or before the Closing Date. (c) As evidence of the satisfaction of the conditions in sections 7.1 (a) and (b), YC shall deliver to the Vendor at the Closing Time a certificate of YC confirming the matters in sections 7.1 (a) and (b) and to the effect that as of the Closing Time all other conditions set forth in this section have been satisfied. The certificate shall be signed by two senior executive officers of YC acceptable to the Vendor, acting reasonably. Notwithstanding the foregoing, the receipt of such certificate and the completion of the Transaction shall not constitute a waiver (in whole or in part) of, or have the effect of modifying or qualifying in any way, any of the representations and warranties of YC made in or pursuant to this Agreement, each of which shall survive the Closing and remain in full force and effect for the benefit of the Vendor as provided in Article 9. (d) YC and the Buyer shall have delivered to the Vendor a legal opinion from counsel acceptable to the Vendor, acting reasonably, and in form and content satisfactory to the Vendor subject to reasonable qualifications, as to the due incorporation and organization of YC and the Buyer, the corporate power and authority of YC and the Buyer, the receipt of all necessary approvals by YC and the Buyer and the enforceability of this Agreement, the Payment Undertaking and the Covenant Escrow Agreement as against YC and the Buyer and the non-conflict of this Agreement, the Payment Undertaking and the Covenant Escrow Agreement with respect to the constating documents of YC and the Buyer and any Applicable Laws. (e) The Vendor Regulatory Approval shall have been granted, obtained and received unconditionally or on terms satisfactory to the Vendor, acting reasonably. (f) No Order shall have been made and no Legal Proceeding shall have been commenced or shall be pending or threatened against the other Party or its affiliates or which enjoins, restricts or prohibits, or which asserts a claim or seeks a remedy that would have the effect of enjoining, restricting or prohibiting the completion of the Transaction. If any condition in this section has not been fulfilled on or before the Closing Date or if any such condition is or becomes impossible to satisfy, other than as a result of the failure of the Vendor to comply with its obligations under this Agreement, then the Vendor in its sole discretion may, without limiting any rights or remedies available to the Vendor at law or in equity, either terminate this Agreement by written notice to YC, in which case the provisions of sections 2.5(c)(iii), (iv) or (v) shall be applicable, or waive compliance with any such condition without prejudice to its right of termination in the event of non-fulfilment of any other condition.
Conditions to Obligation to Close (a) Conditions to Obligation of the Purchaser. The obligation of the Purchaser to consummate the transactions to be performed by it in connection with the Closing is subject to satisfaction of the following conditions: (i) the representations and warranties set forth in Section 3 above that are qualified as to their materiality or to the Knowledge of the Seller shall be true and correct and any such representations and warranties that are not so qualified shall be true and correct in all material respects at and as of the Closing Date (as though made then and as though the Closing Date were substituted for the date of this Agreement); (ii) the Seller and the Company shall have performed and complied with all of their respective covenants hereunder in all material respects through the Closing; (iii) there shall not be any injunction, judgment, order, decree, ruling or charge in effect preventing consummation of any of the transactions contemplated by this Agreement, and no action, suit, claim or proceeding shall be pending before any Authority which seeks to prohibit or enjoin the consummation of the transactions contemplated by this Agreement; (iv) the Seller shall have delivered to the Purchaser a certificate to the effect that the conditions specified above in Section 9(a)(i) and (ii), as they pertain to the Seller, have been satisfied in all respects; (v) the Seller shall have delivered to the Purchaser a certificate to the effect that the conditions specified above in Section 9(a)(i) and (ii), as they pertain to the Company, have been satisfied in all respects; (vi) the Seller shall have delivered to the Purchaser all of the items under Section 2(f) herein; and (vii) there shall be no payables or receivables between the Seller and the Company or between Affiliates of the Seller and the Company. (viii) the Purchaser shall have obtained financing to implement the transactions provided for in this Agreement and to provide sufficient working capital on such terms and conditions as are acceptable to the Purchaser, and the Purchaser shall have satisfied all of the conditions precedent to acquisitions under WinsLoew Furniture, Inc.'s line of credit with Fleet. (ix) all consents, waivers, exemptions, governmental approvals, regulatory approvals and other actions that are necessary in connection with the consummation of the transactions contemplated by this Agreement, shall be in full force and effect on the Closing Date. (x) the Purchaser shall have received from Seller all information available to Seller that is requested by the Purchaser promptly after the date hereof, and the Purchaser, upon review of such matters related to Seller, its assets, liabilities, financial condition, business, prospects or relations with third parties as it shall deem necessary or appropriate (in which review Seller shall cooperate), shall not have learned of any fact or matter that, in the good faith determination of Purchaser, causes Purchaser to be dissatisfied in any material respect with the transactions contemplated by this Agreement. The Purchaser may waive any condition specified in this Section 9(a) if it executes a writing so stating at or prior to the Closing.
Payment Conditions The price of the whole accommodation service booked is always payable by the Guest in advance, at the latest upon arrival in the hotel. Set-off by the Guest is excluded unless the set- off relates to an undisputed or legally confirmed claim. Valid means of payment are cash in Euros, EC card, Master Card, Visa Card, Diners Card and American Express. For payment settlement we use the 3D Secure 2.0 system for secure and additional customer authorisation. For further information on data processing for payment transactions see xxxxx://xxx.xxxxx-xxx.xxx/en/data-privacy/.
Site Conditions A. Existing Site Conditions: Information with respect to the site of the Work given in drawings or specifications has been obtained by County's representatives and is believed to be reasonably correct, but the County does not warrant either the completeness or accuracy of such information, and it is the responsibility of the Contractor to verify all such information.