Construction Standards The Subrecipient and Developer shall ensure that all Approved Projects comply with the following requirements:
PRODUCTION STANDARDS The Company may establish minimum production standards applicable to Representative.
Institution Standards Residents are also responsible for reading, understanding and adhering to the academic and non-academic policies and procedures that have been established by the Institution, including the Code of Conduct and its penalties.
Reformulation Standards A “reformulated” product (a) contains lead in concentrations that do not exceed 90 parts per million, equivalent to 0.009%, in any exterior parts analyzed pursuant to U.S. Environmental Protection Agency (EPA) methodologies 3050B and 6010B, or (b) yields a result of no more than 1.0 micrograms of lead when sampled according to NIOSH 9100 protocol and analyzed according to EPA 6010B. In addition to the above tests, the Settling Entity may use equivalent methods utilized by any California or federal agency to determine lead content in a solid substance or the amount of the bioavailability of the toxicant through a wipe test, respectively.
WORKLOAD STANDARDS One (1) Direct Service Hour (DSH) will be equal to sixty (60) minutes of direct services.
Reformulation Standard “Reformulated Products” shall mean Products that contain concentrations less than or equal to 0.1% (1,000 parts per million (ppm)) of DEHP when analyzed pursuant to U.S. Environmental Protection Agency testing methodologies 3580A and 8270C or other methodology utilized by federal or state government agencies for the purpose of determining the phthalate content in a solid substance.
Anti-Discrimination Statement by Contractor In every contract over $10,000 the provisions in 1. and 2. below apply:
REPORT STANDARDS Reports or written material prepared by the Contractor in response to the requirements of this Contract or request of the Project Officer shall, unless otherwise provided for in the Contract, meet standards of professional writing established for the type of report or written material provided, shall be thoroughly researched for accuracy of content, shall be grammatically correct and not contain spelling errors, shall be submitted in a format approved in advance by the Project Officer, and shall be submitted for advance review and comment by the Project Officer. The cost of correcting grammatical errors, correcting report data, or other revisions required to bring the report or written material into compliance with these requirements shall be borne by the Contractor. When submitting documents to APS, The Contractor shall comply with the following guidelines: All submittals and copies shall be printed on at least thirty percent (30%) recycled-content and/or tree-free paper; All submittals must be in the required tabular format in a binder. Report covers / binders shall be recyclable, made from recycled materials, and/or easily removable to allow for recycling of report pages (reports with glued bindings that meet all other requirements are acceptable); The use of plastic covers or dividers should be avoided; and Unnecessary attachments or documents not specifically asked for should not be submitted, and superfluous use of paper should be avoided.
Employment Standards Act Where the provisions of the Employment Standards Act exceed those within this agreement such provisions shall apply.
ENVIRONMENTAL PROTECTION STANDARDS CONTRACTOR shall be in compliance with the Clean Air Act (Title 42 USC Section 7401 et seq.), the Clean Water Act (Title 33 USC Section 1251 et seq.), Executive Order 11738 and Environmental Protection Agency, hereinafter referred to as “EPA,” regulations (Title 40 CFR), as any may now exist or be hereafter amended. Under these laws and regulations, CONTRACTOR assures that: