Removal or Replacement of a Lender Anything contained herein to the contrary notwithstanding, in the event that: (a)
(i) any Lender (an “Increased Cost Lender”) shall give notice to Borrower that such Lender is an Affected Lender or that such Lender is entitled to receive payments under Section 2.18, 2.19 or 2.20, (ii) the circumstances which have caused such Lender to be an Affected Lender or which entitle such Lender to receive such payments shall remain in effect, and (iii) such Lender shall fail to withdraw such notice within five Business Days after Borrower’s request for such withdrawal; or (b) (i) any Lender shall become a Defaulting Lender, (ii) the Default Period for such Defaulting Lender shall remain in effect, and (iii) such Defaulting Lender shall fail to cure the default as a result of which it has become a Defaulting Lender within five Business Days after Borrower’s request that it cure such default; or (c) in connection with any proposed amendment, modification, termination, waiver or consent with respect to any of the provisions hereof as contemplated by Section 10.5(b), the consent of Requisite Lenders shall have been obtained but the consent of one or more of such other Lenders (each a “Non-Consenting Lender”) whose consent is required shall not have been obtained; then, with respect to each such Increased Cost Lender, Defaulting Lender or Non-Consenting Lender (the “Terminated Lender”), Borrower may, by giving written notice to Administrative Agent and any Terminated Lender of its election to do so, elect to cause such Terminated Lender (and such Terminated Lender hereby irrevocably agrees) to assign its outstanding Loans and its Revolving Commitments, if any, in full to one or more Eligible Assignees (each a “Replacement Lender”) in accordance with the provisions of Section 10.6 and Borrower shall pay the fees, if any, payable thereunder in connection with any such assignment from an Increased Cost Lender, a Non-Consenting Lender or Insolvency Defaulting Lender, and the Funds Defaulting Lender (if not also an Insolvency Defaulting Lender) shall pay the fees, if any, payable thereunder in connection with any such assignment from such Defaulting Lender; provided, (1) on the date of such assignment, the Replacement Lender shall pay to Terminated Lender an amount equal to the sum of (A) an amount equal to the principal of, and all accrued interest on, all outstanding Loans of the Terminated Lender, (B) an amount equal to all unreimbursed drawings that have been funded by such Terminated Lender, together with all then unpaid interest with respect thereto at such time and (C) an amount equal to all accrued, but theretofore unpaid fees owing to such Terminated Lender pursuant to Section 2.11; (2) on the date of such assignment, Borrower shall pay any amounts payable to such Terminated Lender pursuant to Section 2.18(c), 2.19 or 2.20; or otherwise as if it were a prepayment; (3) in the case of any assignment resulting from a claim for compensation under Section 2.19 or payments required to be made under Section 2.20, such assignment will result in a reduction in such compensation or payment and (4) in the event such Terminated Lender is a Non-Consenting Lender, each Replacement Lender shall consent, at the time of such assignment, to each matter in respect of which such Terminated Lender was a Non-Consenting Lender; provided that Borrower may not make such election with respect to any Terminated Lender that is also an Issuing Bank unless, prior to the effectiveness of such election, Borrower shall have caused each outstanding Letter of Credit issued thereby to be cancelled. Upon the prepayment of all amounts owing to any Terminated Lender and the termination of such Terminated Lender’s Revolving Commitments, if any, such Terminated Lender shall no longer constitute a “Lender” for purposes hereof; provided that any rights of such Terminated Lender to indemnification hereunder shall survive as to such Terminated Lender. Each Lender agrees that if Borrower exercises its option hereunder to cause an assignment by such Lender as a Terminated Lender, such Lender shall, promptly after receipt of written notice of such election, execute and deliver all documentation necessary to effectuate such assignment in accordance with Section 10.6. In the event that a Terminated Lender does not comply with the requirements of the immediately preceding sentence within one Business Day after receipt of such notice, each Lender hereby authorizes and directs the Administrative Agent to execute and deliver such documentation as may be required to give effect to an assignment in accordance with Section 10.6 on behalf of such Terminated Lender and any such documentation so executed by the Administrative Agent shall be effective for purposes of documenting an assignment pursuant to Section 10.6.
Removal or Replacement of a Manager Any Manager may be removed or replaced without “Cause” at any time by a majority of the Board and each Manager may be removed and or replaced and our Board can be reconstituted for any reason by the Class C Member, if any.
Withdrawal or Removal and Replacement of Administrator The Administrator may withdraw for any reason upon notice to the Initial Member, provided that such withdrawal shall be effective only following a Sale of the Artwork and distribution of the proceeds. The Administrator may be removed and replaced at any time for any reason with or without approval of the Board upon the affirmative vote of Voting Members holdings at least two-thirds of the Voting Shares. In the event of any such withdrawal or removal and replacement of the Administrator, any unvested ASA Shares shall be forfeited as of the effective date of such withdrawal or removal and such ASA Shares shall no longer be deemed to be issued and outstanding for any purposes of this Agreement.
REPAIRED OR REPLACED PARTS / COMPONENTS Where the Contractor is required to repair, replace or substitute Product or parts or components of the Product under the Contract, the repaired, replaced or substituted Products shall be subject to all terms and conditions for new parts and components set forth in the Contract including Warranties, as set forth in the Additional Warranties Clause herein. Replaced or repaired Product or parts and components of such Product shall be new and shall, if available, be replaced by the original manufacturer’s component or part. Remanufactured parts or components meeting new Product standards may be permitted by the Commissioner or Authorized User. Before installation, all proposed substitutes for the original manufacturer’s installed parts or components must be approved by the Authorized User. The part or component shall be equal to or of better quality than the original part or component being replaced.
Licenses for Permanent Installation The contractor must comply with all State mandatory licensing requirements prior to installation. Questions on licensing requirements should be directed to the State Licensing Board. Contractor must furnish and install all furniture and materials in compliance with all applicable codes, whether local, state, or federal; and that all permits or licenses required for installation will be obtained without cost to the State.
Accessories, Spare Parts and Tools Accessories, spare parts and tools dispatched with a piece of equipment, machine, apparatus or vehicle, which are part of the normal equipment and included in the price thereof or which are not separately invoiced, shall be regarded as one with the piece of equipment, machine, apparatus or vehicle in question.
Removal of Equipment Subject, always, to the other terms and provisions of this Fee Agreement, the Company and any Sponsor Affiliates shall be entitled to remove and dispose of components of the Project from the Project in its sole discretion with the result that said components shall no longer be considered a part of the Project and, to the extent such constitute Economic Development Property, shall no longer be subject to the terms of this Fee Agreement. Economic Development Property is disposed of only when it is scrapped or sold or removed from the Project. If it is removed from the Project, it is subject to ad valorem property taxes to the extent the Property remains in the State and is otherwise subject to ad valorem property taxes.
Conveyance of Subsequent Mortgage Loans (a) The Depositor does hereby sell, transfer, assign, set over and convey to the Trustee on behalf of the Trust Fund, without recourse, all of its right, title and interest in and to the Subsequent Mortgage Loans, and including all amounts due on the Subsequent Mortgage Loans after the related Subsequent Cut-off Date, and all items with respect to the Subsequent Mortgage Loans to be delivered pursuant to Section 2.01 of the Pooling and Servicing Agreement; provided, however that the Depositor reserves and retains all right, title and interest in and to amounts due on the Subsequent Mortgage Loans on or prior to the related Subsequent Cut-off Date. The Depositor, contemporaneously with the delivery of this Agreement, has delivered or caused to be delivered to the Trustee each item set forth in Section 2.01 of the Pooling and Servicing Agreement. The transfer to the Trustee by the Depositor of the Subsequent Mortgage Loans identified on the Mortgage Loan Schedule shall be absolute and is intended by the Depositor, the Master Servicer, the Trustee and the Certificateholders to constitute and to be treated as a sale by the Depositor to the Trust Fund.
(b) The Depositor, concurrently with the execution and delivery hereof, does hereby transfer, assign, set over and otherwise convey to the Trustee without recourse for the benefit of the Certificateholders all the right, title and interest of the Depositor, in, to and under the Subsequent Mortgage Loan Purchase Agreement, dated the date hereof, between the Depositor as purchaser and the Master Servicer as originator and as seller, to the extent of the Subsequent Mortgage Loans.
(c) Additional terms of the sale are set forth on Attachment A hereto.
Selection of Subcontractors, Procurement of Materials and Leasing of Equipment The contractor shall not discriminate on the grounds of race, color, religion, sex, national origin, age or disability in the selection and retention of subcontractors, including procurement of materials and leases of equipment. The contractor shall take all necessary and reasonable steps to ensure nondiscrimination in the administration of this contract.
a. The contractor shall notify all potential subcontractors and suppliers and lessors of their EEO obligations under this contract.
b. The contractor will use good faith efforts to ensure subcontractor compliance with their EEO obligations.
Modification of the Small Generating Facility The Interconnection Customer must receive written authorization from the NYISO and Connecting Transmission Owner before making any change to the Small Generating Facility that may have a material impact on the safety or reliability of the New York State Transmission System or the Distribution System. Such authorization shall not be unreasonably withheld. Modifications shall be done in accordance with Good Utility Practice. If the Interconnection Customer makes such modification without the prior written authorization of the NYISO and Connecting Transmission Owner, the Connecting Transmission Owner shall have the right to temporarily disconnect the Small Generating Facility. If disconnected, the Small Generating Facility will not be reconnected until the unauthorized modifications are authorized or removed.
