Limitation on Market Access Limitation on National Treatment Additional Commitments (b) Accounting and auditing and bookkeeping services (CPC 862) (1) None. (2) None. (3) None. (4) Unbound, except as indicated in the horizontal section. (1) None. (2) None. (3) None. (4) Unbound, except as indicated in the horizontal section.
Restriction on Assignment No party will assign or transfer any part of its respective rights or obligations under this Agreement without the prior consent of the others (such consent not to be unreasonably withheld or delayed), provided that:
Restriction on Use The Contractor agrees that to the extent it receives or is given any information from NYSERDA or a NYSERDA contractor or subcontractor, the Contractor shall treat such data in accordance with any restrictive legend contained thereon or instructions given by NYSERDA, unless another use is specifically authorized by prior written approval of the NYSERDA Project Manager. Contractor acknowledges that in the performance of the Work under this Agreement, Contractor may come into possession of personal information as that term is defined in Section 92 of the New York State Public Officers Law. Contractor agrees not to disclose any such information without the consent of NYSERDA. CASE III: R&D-type contracts:
CONDITION ON DELIVERY If a Vehicle accepted by an Authorized User is found to have been delivered with minor deviations or improper servicing, the Contractor must arrange to have the necessary work done within 48 hours (exclusive of Saturdays, Sundays and Federal or NYS Holidays) after receipt of written notification from the Authorized User and/or NYSPro. If Contractor cannot arrange to have the necessary work done within such time period, the corrections shall be made by an entity of the Authorized User’s choosing and Contractor will be required to reimburse the Authorized User for this expense within thirty (30) calendar days of request. At point of acceptance, the Vehicle shall have an odometer reading that is consistent with the miles, in distance, to the anticipated odometer mileage incurred between the OEM factory, the Contractor’s place of business, or other OEM Dealer location that is nearest to the delivery location, the Aftermarket Component Provider (if applicable), and the point of delivery. In the event that a Vehicle is delivered with an odometer reading that the Authorized User considers to be excessive, the Contractor shall be required to provide a reasonable explanation for the odometer reading. Vehicles that are delivered with an odometer reading that is considered excessive without a reasonable explanation, as determined by the Authorized User, may be rejected by the Authorized User.
SECTION 907 - VEHICLE CONFIGURATIONS AND RESTRICTIONS The SADT on the section shall be understood to be 1,500.
PROHIBITION ON PURCHASE OF TROPICAL HARDWOODS The Contractor certifies and warrants that all wood products to be used under this contract award will be in accordance with, but not limited to, the specifications and provisions of Section 165 of the State Finance Law, (Use of Tropical Hardwoods) which prohibits purchase and use of tropical hardwoods, unless specifically exempted, by the State or any governmental agency or political subdivision or public benefit corporation. Qualification for an exemption under this law will be the responsibility of the contractor to establish to meet with the approval of the State. In addition, when any portion of this contract involving the use of xxxxx, whether supply or installation, is to be performed by any subcontractor, the prime Contractor will indicate and certify in the submitted bid proposal that the subcontractor has been informed and is in compliance with specifications and provisions regarding use of tropical hardwoods as detailed in §165 State Finance Law. Any such use must meet with the approval of the State; otherwise, the bid may not be considered responsive. Under bidder certifications, proof of qualification for exemption will be the responsibility of the Contractor to meet with the approval of the State.
Limitation on Use Tenant shall use the Premises solely for the Permitted Use specified in Section N of the Summary. There shall not be any change in use without the prior written consent of Landlord which will not be unreasonably withheld. Tenant shall not do anything in or about the Premises which will (i) cause structural injury to the Building, or (ii) cause damage to any part of the Building except to the extent reasonably necessary for the installation of Tenant’s Trade Fixtures and Tenant’s Alterations, and then only in a manner which has been first approved by Landlord in writing. Tenant shall not operate any equipment within the Premises which will (i) materially damage the Building or the Common Area, (ii) overload existing electrical systems or other mechanical equipment servicing the Building, (iii) impair the efficient operation of the sprinkler system or the heating, ventilating or air conditioning (“HVAC”) equipment within or servicing the Building, or (iv) damage, overload or corrode the sanitary sewer system. Tenant shall not attach, hang or suspend anything from the ceiling, roof, walls or columns of the Building or set any load on the floor in excess of the load limits for which such items are designed nor operate hard wheel forklifts within the Premises. Any dust, fumes, or waste products generated by Tenant’s use of the Premises shall be contained and disposed so that they do not (i) create an unreasonable fire or health hazard, (ii) damage the Premises, or (iii) result in the violation of any Law. Except as approved by Landlord, Tenant shall not change the exterior of the Building or install any equipment or antennas on or make any penetrations of the exterior or roof of the Building. Tenant shall not commit any waste in or about the Premises, and Tenant shall keep the Premises in a neat, clean, attractive and orderly condition, free of any nuisances. If Landlord designates a standard window covering for use throughout the Building, Tenant shall use this standard window covering to cover all windows in the Premises. Tenant shall not conduct on any portion of the Premises or the Project any sale of any kind, including any public or private auction, fire sale, going-out-of-business sale, distress sale or other liquidation sale.
BUY AMERICA REQUIREMENT (Applies only to Federally Funded Highway and Transit Projects) With respect to products purchased by Customer for use in federally funded highway projects, Contractor shall comply with all federal procurement laws and regulations with respect to such projects, including the Buy American provisions set forth in 23 U.S.C. Section 313, 23 C.F.R. Section 635.410, as amended, and the Steel and Iron Preference provisions of Texas Transportation Code Section 223.045, to the extent applicable. Contractor agrees to provide all certifications required by Customer regarding such programs. With respect to products purchased by Customer for use in federally funded transit projects, Contractor shall comply with all federal procurement laws and regulations with respect to such projects, including the Buy American provisions set forth in 49 U.S.C. Section 5323(j)(1), 49 C.F.R. Sections 661.6 or 661.12, to the extent applicable. Contractor agrees to provide all certifications required by Customer regarding such programs.
Limitation on Out of-State Litigation - Texas Business and Commerce Code § 272 This is a requirement of the TIPS Contract and is non-negotiable. Texas Business and Commerce Code § 272 prohibits a construction contract, or an agreement collateral to or affecting the construction contract, from containing a provision making the contract or agreement, or any conflict arising under the contract or agreement, subject to another state’s law, litigation in the courts of another state, or arbitration in another state. If included in Texas construction contracts, such provisions are voidable by a party obligated by the contract or agreement to perform the work. By submission of this proposal, Vendor acknowledges this law and if Vendor enters into a construction contract with a Texas TIPS Member under this procurement, Vendor certifies compliance.
Limitation on Services Except in cases of Emergency Services or Urgent Care, or as otherwise provided under this Certificate, services are available only from Participating Providers and HMO shall have no liability or obligation whatsoever on account of any service or benefit sought or received by a Member from any Physician, Hospital, Skilled Nursing Facility, home health care agency, or other person, entity, institution or organization unless prior arrangements are made by HMO.
