Access to NID 2.7.3.1 NewPhone may access the customer’s premises wiring by any of the following means and NewPhone shall not disturb the existing form of electrical protection and shall maintain the physical integrity of the NID:
2.7.3.1.1 BellSouth shall allow NewPhone to connect its Loops directly to BellSouth’s multi-line residential NID enclosures that have additional space and are not used by BellSouth or any other telecommunications carriers to provide service to the premises;
2.7.3.1.2 Where an adequate length of the customer’s premises wiring is present and environmental conditions permit, either Party may remove the customer premises wiring from the other Party’s NID and connect such wiring to that Party’s own NID;
2.7.3.1.3 Either Party may enter the subscriber access chamber or dual chamber NID enclosures for the purpose of extending a cross-connect or spliced jumper wire from the customer premises wiring through a suitable “punch-out” hole of such NID enclosures; or
2.7.3.1.4 NewPhone may request BellSouth to make other rearrangements to the customer premises wiring terminations or terminal enclosure on a time and materials cost basis.
2.7.3.2 In no case shall either Party remove or disconnect the other Party’s loop facilities from either Party’s NIDs, enclosures, or protectors unless the applicable Commission has expressly permitted the same and the disconnecting Party provides prior notice to the other Party. In such cases, it shall be the responsibility of the Party disconnecting loop facilities to leave undisturbed the existing form of electrical protection and to maintain the physical integrity of the NID. It will be NewPhone’s responsibility to ensure there is no safety hazard, and NewPhone will hold BellSouth harmless for any liability associated with the removal of the BellSouth Loop from the BellSouth NID. Furthermore, it shall be the responsibility of the disconnecting Party, once the other Party’s loop has been disconnected from the NID, to reconnect the disconnected loop to a nationally recognized testing laboratory listed station protector, which has been grounded as per Article 800 of the National Electrical Code. If no spare station protector exists in the NID, the disconnected loop must be appropriately cleared, capped and stored.
2.7.3.3 NewPhone shall not remove or disconnect ground wires from BellSouth’s NIDs, enclosures, or protectors.
2.7.3.4 NewPhone shall not remove or disconnect NID modules, protectors, or terminals from BellSouth’s NID enclosures.
2.7.3.5 Due to the wide variety of NID enclosures and outside plant environments, BellSouth will work with NewPhone to develop specific procedures to establish the most effective means of implementing this section if the procedures set forth herein do not apply to the NID in question.
Access to Work Locations Reasonable access to employee work locations shall be granted officers of the Association and their officially designated representatives for the purpose of processing grievances or contacting members of the Association concerning business within the scope of representation. Such officers or representatives shall not enter any work location without the consent of the City Manager. Access shall be restricted so as not to interfere with the normal operations of the department or with established safety or security requirements. Solicitation of membership and activities concerned with the internal management of the Association, such as collecting dues, holding membership meetings, campaigning for office, conducting elections and distributing literature, shall not be conducted during working hours.
Access to Site 3.05.1 Contractor may enter and leave the premises at all reasonable times without charge. Contractor and its employees may use the common areas and roadways of the premises where it is to perform the services together with all facilities, equipment, improvements, and services provided in connection with the premises for common use. This excludes parking for Contractor’s personnel. Contractor shall repair any damage caused by it or its employees as a result of its use of the common areas.
Use of Attachment Facilities by Third Parties Purpose of Attachment Facilities. Except as may be required by Applicable Laws and Regulations, or as otherwise agreed to among the Parties, the Attachment Facilities shall be constructed for the sole purpose of interconnecting the Large Generating Facility to the New York State Transmission System and shall be used for no other purpose.
Specific Provisions for Access Rights to Software For the avoidance of doubt, the general provisions for Access Rights provided for in this Section 9 are applicable also to Software. Parties’ Access Rights to Software do not include any right to receive source code or object code ported to a certain hardware platform or any right to receive respective Software documentation in any particular form or detail, but only as available from the Party granting the Access Rights.
Rights of Use of the results and of pre-existing rights by the NA and the Union
(a) for its own purposes and in particular to make available to persons working for the NA, Union institutions, agencies and bodies and to Member States’ institutions, as well as to copy and reproduce in whole or in part and in an unlimited number of copies." For the rest of this article, the references to the "Union" must be read as reference to "the NA and/or the Union".
Installation and Use Rights You may install and use any number of copies of the software on your devices.
Use of Interconnection Facilities by Third Parties 6551 Error! Hyperlink reference not valid.9.9.1 Purpose of Interconnection Facilities. 6551
Access to Information Systems Access, if any, to DXC’s Information Systems is granted solely to perform the Services under this Order, and is limited to those specific DXC Information Systems, time periods and personnel as are separately agreed to by DXC and Supplier from time to time. DXC may require Supplier’s employees, subcontractors or agents to sign individual agreements prior to access to DXC’s Information Systems. Use of DXC Information Systems during other time periods or by individuals not authorized by DXC is expressly prohibited. Access is subject to DXC business control and information protection policies, standards and guidelines as may be modified from time to time. Use of any other DXC Information Systems is expressly prohibited. This prohibition applies even when an DXC Information System that Supplier is authorized to access, serves as a gateway to other Information Systems outside Supplier’s scope of authorization. Supplier agrees to access Information Systems only from specific locations approved for access by DXC. For access outside of DXC premises, DXC will designate the specific network connections to be used to access Information Systems.
Protection of Customer Data The Supplier shall not delete or remove any proprietary notices contained within or relating to the Customer Data. The Supplier shall not store, copy, disclose, or use the Customer Data except as necessary for the performance by the Supplier of its obligations under this Call Off Contract or as otherwise Approved by the Customer. To the extent that the Customer Data is held and/or Processed by the Supplier, the Supplier shall supply that Customer Data to the Customer as requested by the Customer and in the format (if any) specified by the Customer in the Call Off Order Form and, in any event, as specified by the Customer from time to time in writing. The Supplier shall take responsibility for preserving the integrity of Customer Data and preventing the corruption or loss of Customer Data. The Supplier shall perform secure back-ups of all Customer Data and shall ensure that up-to-date back-ups are stored off-site at an Approved location in accordance with any BCDR Plan or otherwise. The Supplier shall ensure that such back-ups are available to the Customer (or to such other person as the Customer may direct) at all times upon request and are delivered to the Customer at no less than six (6) Monthly intervals (or such other intervals as may be agreed in writing between the Parties). The Supplier shall ensure that any system on which the Supplier holds any Customer Data, including back-up data, is a secure system that complies with the Security Policy and the Security Management Plan (if any). If at any time the Supplier suspects or has reason to believe that the Customer Data is corrupted, lost or sufficiently degraded in any way for any reason, then the Supplier shall notify the Customer immediately and inform the Customer of the remedial action the Supplier proposes to take. If the Customer Data is corrupted, lost or sufficiently degraded as a result of a Default so as to be unusable, the Supplier may: require the Supplier (at the Supplier's expense) to restore or procure the restoration of Customer Data to the extent and in accordance with the requirements specified in Call Off Schedule 8 (Business Continuity and Disaster Recovery) or as otherwise required by the Customer, and the Supplier shall do so as soon as practicable but not later than five (5) Working Days from the date of receipt of the Customer’s notice; and/or itself restore or procure the restoration of Customer Data, and shall be repaid by the Supplier any reasonable expenses incurred in doing so to the extent and in accordance with the requirements specified in Call Off Schedule 8 (Business Continuity and Disaster Recovery) or as otherwise required by the Customer.
