Router Configure and Commission Sample Clauses

Router Configure and Commission. The Managed Routers and network service will be configured and installed (both hardware and software) to deliver connectivity for the Customer’s traffic across the network. BT will perform network commissioning and acceptance testing (up to layer 3 of the Open Systems Interconnection Reference Model) before giving the Customer the design and configuration details.
AutoNDA by SimpleDocs

Related to Router Configure and Commission

  • Trunk Group Architecture and Traffic Routing 5.2.1 The Parties shall jointly establish Access Toll Connecting Trunks between CLEC and CBT by which they will jointly provide Tandem-transported Switched Exchange Access Services to Interexchange Carriers to enable such Interexchange Carriers to originate and terminate traffic from and to CLEC's Customers. 5.2.2 Access Toll Connecting Trunks shall be used solely for the transmission and routing of Exchange Access and non-translated Toll Free traffic (e.g., 800/888) to allow CLEC’s Customers to connect to or be connected to the interexchange trunks of any Interexchange Carrier that is connected to the CBT access Tandem. 5.2.3 The Access Toll Connecting Trunks shall be one-way or two-way trunks, as mutually agreed, connecting an End Office Switch that CLEC utilizes to provide Telephone Exchange Service and Switched Exchange Access Service in the given LATA to an access Tandem Switch CBT utilizes to provide Exchange Access in the LATA.

  • LICENSURE AND CERTIFICATION 25.1 The Employer will continue its current practices related to licensure and certification or comply with 25.2, 25.3 and 25.4, below, whichever provides the greater benefit to the employee.

  • Manufacture and Supply As between the Parties, Otsuka shall be responsible for, shall bear all costs associated with, and shall have all decision-making authority over, all Manufacturing Activities (subject to discussion of CMC matters with Acucela through the JDC or applicable Operating Team as discussed below); provided, that Otsuka shall supply Licensed Product to Acucela or its permitted subcontractors for use in clinical trials conducted in accordance with each Development Plan and, if applicable, Commercialization Plan (i.e., Phase 3b Clinical Trials or Post-Approval Studies, if any), free of charge and in such quantities as are agreed by the JDC or the JCC (as applicable) or are otherwise required to seek or obtain Regulatory Approval. In addition, if and after Acucela exercises an Opt-In Right under Section 3.1, Otsuka shall supply promotional samples of Licensed Product to Acucela for use in its performance of Co-Promotion, in such quantities and on such terms as are determined by the JCC. The cost of promotional samples of Licensed Product, which shall be included in Commercialization Costs, shall be established by the JCC based on Otsuka’s per-unit cost to manufacture such promotional samples (but, for the avoidance of doubt, Otsuka shall have no obligation to disclose any information relating to its manufacturing costs), but in no event shall such promotional sample cost exceed * per promotional sample unless mutually agreed otherwise by the Parties. Acucela’s and its permitted subcontractors’ obligations to conduct Development activities, and upon Acucela’s exercise of its Opt-in Right pursuant to Section 3.1, to conduct Development and Commercialization activities, shall be expressly conditioned upon Otsuka fulfilling its Licensed Product supply obligations as set forth in the Development Plan or the Commercialization Plan, as applicable. To the extent that Otsuka reasonably believes is necessary for performance of Development or Commercialization, Otsuka agrees to keep Acucela reasonably informed from time to time, through the JDC, JCC or applicable Operating Team, regarding the general status of Manufacturing Activities related to the Licensed Product (including Other Indication Product(s), as applicable) and from time to time shall update Acucela on any foreseeable delays and/or other material issues relating to Manufacturing the Licensed Product (including Other Indication Product(s), as applicable). Through the JDC or applicable Operating Team, Otsuka and Acucela shall confer and discuss CMC matters, and Otsuka agrees to consider suggestions of Acucela regarding CMC matters.

  • Disclosure and Use Restrictions Executive agrees and covenants: (i) to treat all Confidential Information as strictly confidential; (ii) not to directly or indirectly disclose, publish, communicate, or make available Confidential Information, or allow it to be disclosed, published, communicated, or made available, in whole or part, to any entity or person whatsoever (including other employees of the Company) not having a need to know and authority to know and use the Confidential Information in connection with the business of the Company and, in any event, not to anyone outside of the direct employ of the Company except as required in the performance of Executive’s authorized employment duties to the Company or with the prior consent of the Board acting on behalf of the Company in each instance (and then, such disclosure shall be made only within the limits and to the extent of such duties or consent); and (iii) not to access or use any Confidential Information, and not to copy any documents, records, files, media, or other resources containing any Confidential Information, or remove any such documents, records, files, media, or other resources from the premises or control of the Company, except as required in the performance of Executive’s authorized employment duties to the Company or with the prior consent of the Board acting on behalf of the Company in each instance (and then, such disclosure shall be made only within the limits and to the extent of such duties or consent). Nothing herein shall be construed to prevent disclosure of Confidential Information as may be required by applicable law or regulation, or pursuant to the valid order of a court of competent jurisdiction or an authorized government agency, provided that the disclosure does not exceed the extent of disclosure required by such law, regulation, or order. Executive shall promptly provide written notice of any such order to the Board.

  • Disclosure and Use 20.2.1 Each Receiving Party agrees that, from and after the Effective Date: (a) all such Proprietary Information communicated or discovered, whether before, on or after the Effective Date, in connection with this Agreement shall be held in confidence to the same extent as such Receiving Party holds its own confidential information; provided, that such Receiving Party shall not use less than a reasonable standard of care in maintaining the confidentiality of such information; (b) it will not, and it will not permit any of its employees, contractors, consultants, agents or affiliates to disclose such Proprietary Information to any other third person; (c) it will disclose Proprietary Information only to those of its employees, contractors, consultants, agents and affiliates who have a need for it in connection with the use or provision of services required to fulfill this Agreement; (d) it will, and will cause each of its employees, contractors, consultants, agents and affiliates to use such Proprietary Information only to effectuate the terms and conditions of this Agreement and for no other purpose; (e) it will cause each of its affiliates to execute individual confidentiality agreements containing the same restrictions as this Article XX; and (f) it will, and will cause each of its employees, contractors, consultants, agents and affiliates, to use such Proprietary Information to create only that Derivative Information necessary for such Receiving Party's compliance with Applicable Law or its performance under the terms of this Agreement. 20.2.2 Any Receiving Party so disclosing Proprietary Information to its employees, contractors, consultants, agents or affiliates shall be responsible for any breach of this Agreement by any of its employees, contractors, consultants, agents or affiliates and such Receiving Party agrees to use its reasonable efforts to restrain its employees, contractors, consultants, agents or affiliates from any prohibited or unauthorized disclosure or use of the Proprietary Information and to assist the Disclosing Party in its efforts to protect such information from disclosure. Each Receiving Party making such disclosure shall notify the Disclosing Party as soon as possible if it has knowledge of a breach of this Agreement in any material respect. 20.2.3 Proprietary Information shall not be reproduced by any Receiving Party in any form except to the extent (i) necessary to comply with the provisions of Section 20.3 and (ii) reasonably necessary to perform its obligations under this Agreement. All such reproductions shall bear the same copyright and proprietary rights notices as are contained in or on the original.

  • HUB Subcontracting Plan The Owner has adopted Exhibit H, Policy on Utilization of Historically Underutilized Business ("Policy"), which is incorporated herein by reference. Contractor, as a provision of the Agreement must comply with the requirements of the Policy and adhere to the HUB Subcontracting Plan submitted with Contractor's Proposal and attached as Exhibit I. No changes to the HUB Subcontracting Plan can be made by the Contractor without the prior written approval of the Owner in accordance with the Policy.

  • Interconnection Customer Authority Consistent with Good Utility Practice, this LGIA, and the CAISO Tariff, the Interconnection Customer may take actions or inactions with regard to the Large Generating Facility or the Interconnection Customer’s Interconnection Facilities during an Emergency Condition in order to (i) preserve public health and safety, (ii) preserve the reliability of the Large Generating Facility or the Interconnection Customer’s Interconnection Facilities,

  • Data Encryption Contractor must encrypt all State data at rest and in transit, in compliance with FIPS Publication 140-2 or applicable law, regulation or rule, whichever is a higher standard. All encryption keys must be unique to State data. Contractor will secure and protect all encryption keys to State data. Encryption keys to State data will only be accessed by Contractor as necessary for performance of this Contract.

  • Software Licensing Contractor represents and warrants that the software, if any, as delivered to City, does not contain any program code, virus, worm, trap door, back door, time or clock that would erase data or programming or otherwise cause the software to become inoperable, inaccessible, or incapable of being used in accordance with its user manuals, either automatically, upon the occurrence of licensor-selected conditions or manually on command. Contractor further represents and warrants that all third party software, delivered to City or used by Contractor in the performance of the Contract, is fully licensed by the appropriate licensor.

  • STATEWIDE CONTRACT MANAGEMENT SYSTEM If the maximum amount payable to Contractor under this Contract is $100,000 or greater, either on the Effective Date or at any time thereafter, this section shall apply. Contractor agrees to be governed by and comply with the provisions of §§00-000-000, 00-000-000, 00-000-000, and 00- 000-000, C.R.S. regarding the monitoring of vendor performance and the reporting of contract information in the State’s contract management system (“Contract Management System” or “CMS”). Contractor’s performance shall be subject to evaluation and review in accordance with the terms and conditions of this Contract, Colorado statutes governing CMS, and State Fiscal Rules and State Controller policies.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!