Selection of Architect/Construction Drawings Landlord shall retain, on behalf of Tenant, FPBA Architects (the “Architect”) to prepare the “Construction Drawings,” as that term is defined in this Section 3.1. Landlord shall retain, on behalf of Tenant, engineering consultants and/or design-build consultants designated by Landlord (the “Engineers”) to prepare all plans and engineering working drawings relating to the structural, mechanical, electrical, plumbing and HYAC work of the Improvements and any relevant components of the Landlord Work. The plans and drawings to be prepared by Architect and the Engineers hereunder shall be known collectively as the “Construction Drawings.” All Construction Drawings shall comply with the drawing format and specifications as determined by Landlord, and shall be subject to Landlord’s approval as more particularly set forth in Sections 3.2 and 3.3, below. Notwithstanding Landlord’s retention of the Architect and Engineers, Tenant shall be responsible for, and shall fully cooperate and coordinate in good faith with Landlord, the Architect and the Engineers to supply all of the necessary information within Tenant’s possession to allow the Architect and the Engineers to initially prepare and then complete, the Construction Drawings. Landlord hereby agrees (at no cost to Landlord) to cooperate, on a commercially reasonable basis, with Tenant to assist Tenant in the preparation of the Construction Drawings. Landlord’s review of the Construction Drawings applicable to the Improvements (as opposed to Landlord Work) and as set forth in this Section 3, shall be for its sole purpose and shall not imply Landlord’s review of the same, or obligate Landlord to review the same, for quality, design, Code compliance or other like matters. Accordingly, notwithstanding that any Improvement-related portions of such Construction Drawings are reviewed by Landlord, and notwithstanding any advice or assistance which may be rendered to Tenant by Landlord, Landlord shall have no liability whatsoever in connection therewith and shall not be responsible for any omissions or errors contained in such portions of the Construction Drawings, and Tenant’s waiver and indemnity set forth in this Lease shall specifically apply to such portions of the Construction Drawings.
Manufacturing Technology Transfer Upon AbbVie’s written request with respect to a given Collaboration CAR-T Product and Licensed Product, Caribou shall effect a full transfer to AbbVie or its designee (which designee may be an Affiliate or a Third Party Provider) of all Materials and Know-How Controlled by Caribou relating to the then-current process for the Manufacture of such Collaboration CAR-T Product and any corresponding Licensed Products (each, a “Manufacturing Process”). Caribou shall provide, shall cause its Affiliates to provide, and shall use Commercially Reasonable Efforts to assist AbbVie in causing all Third Party Providers to provide, all reasonable assistance requested by AbbVie to enable AbbVie (or its Affiliate or designated Third Party Provider, as applicable) to implement each Manufacturing Process at the facilities designated by AbbVie. If requested by AbbVie, such assistance shall include facilitating the entering into of agreements with applicable Third Party suppliers relating to such Collaboration CAR-T Product and any corresponding Licensed Products. Without limitation of the foregoing, in connection with the Manufacturing Process and related transfer: (a) Caribou shall, and shall cause its Affiliates to, make available to AbbVie (or its Affiliate or designated Third Party Provider, as applicable), and shall use Commercially Reasonable Efforts to assist AbbVie in causing all Third Party Providers to make available to AbbVie, from time to time as AbbVie may request, all Materials and Manufacturing-related Know-How Controlled by Caribou relating to each Manufacturing Process, including methods, reagents and processes and testing/characterization Know-How, and all documentation constituting material support, performance advice, shop practice, standard operating procedures, specifications as to Materials to be used, and control methods, that are necessary or reasonably useful to enable AbbVie (or its Affiliate or designated Third Party manufacturer, as applicable) to use and practice such Manufacturing Process; (b) Caribou shall cause all appropriate employees and representatives of Caribou and its Affiliates, and shall use Commercially Reasonable Efforts to assist AbbVie in causing all appropriate employees and representatives of Third Party Providers, to meet with employees or representatives of AbbVie (or its Affiliate or designated Third Party Provider, as applicable) at the applicable manufacturing facility at mutually convenient times to assist with the working up and use of each Manufacturing Process and with the training of the personnel of AbbVie (or its Affiliate or designated Third Party Provider, as applicable) to the extent necessary or reasonably useful to enable AbbVie (or its Affiliate or designated Third Party Provider, as applicable) to use and practice such Manufacturing Process; (c) Without limiting the generality of this Section 4.4.2, Caribou shall cause all appropriate analytical and quality control laboratory employees and representatives of Caribou and its Affiliates, and shall use Commercially Reasonable Efforts to assist AbbVie in causing all appropriate analytical and quality control laboratory employees and representatives of Third Party Providers, to meet with employees or representatives of AbbVie (or its Affiliate or designated Third Party Provider, as applicable) at the applicable manufacturing facility and make available all necessary equipment, at mutually convenient times, to support and execute the provision of all applicable analytical methods and the validation thereof (including all applicable Know-How, Information and Materials Controlled by Caribou, and sufficient supplies of all primary and other reference standards); (d) Caribou shall, and shall cause its Affiliates to, take such steps, and shall use Commercially Reasonable Efforts to assist AbbVie in causing Third Party Providers take such steps, as are necessary or reasonably useful to assist AbbVie (or its Affiliate or designated Third Party Provider, as applicable) in obtaining any necessary licenses, permits or approvals from Regulatory Authorities with respect to the Manufacture of the applicable Collaboration CAR-T Products and corresponding Licensed Products at the applicable facilities; and (e) Caribou shall, and shall cause its Affiliates to, provide, and shall use Commercially Reasonable Efforts to assist AbbVie in causing Third Party Providers to provide, such other assistance as AbbVie (or its Affiliate or designated Third Party Provider, as applicable) may reasonably request to enable AbbVie (or its Affiliate or designated Third Party Provider, as applicable) to use and practice each Manufacturing Process and otherwise to Manufacture the applicable Collaboration CAR-T Products and corresponding Licensed Products.
Cooperative Drafting This Agreement has been drafted through a cooperative effort of City and Contractor, and both Parties have had an opportunity to have the Agreement reviewed and revised by legal counsel. No Party shall be considered the drafter of this Agreement, and no presumption or rule that an ambiguity shall be construed against the Party drafting the clause shall apply to the interpretation or enforcement of this Agreement.
Development Phase contractual phase initiated with the approval of ANP for the Development Plan and which is extended during the Production Phase while investments in xxxxx, equipment, and facilities for the Production of Oil and Gas according to the Best Practices of the Oil Industry are required.
Regulatory Submissions With respect to the Governmental Approvals of the Agreement Products in the Territory: (a) Unless otherwise required by Applicable Law, any Governmental Approvals and any Regulatory Submissions relating to Agreement Products in the Territory shall be filed, owned and held in the name of EVOLUS or its Affiliates. (b) EVOLUS shall be solely responsible, at its expense, and shall use commercially reasonable efforts to timely prepare, file, prosecute, and maintain all Regulatory Submissions relating to Agreement Products in the Territory, including any reports or amendments necessary to maintain Governmental Approvals, and for seeking any revisions of the conditions of each Governmental Approval. (c) EVOLUS shall have sole authority and responsibility and shall use commercially reasonable efforts to develop, modify, seek and/or obtain any necessary Governmental Approvals of any Labeling, packaging, advertising or other promotional or informational materials used in connection with Agreement Products in the Territory, and Promotional Materials and for determining whether the same requires Regulatory Approval. (d) EVOLUS will be the primary contact with the Regulatory Authorities in the Territory and shall be solely responsible for all communications with such Regulatory Authorities that relate to any Regulatory Submission relating to Agreement Products in the Territory prior to and after any Governmental Approval. (e) Subject to the terms and conditions of this Agreement, EVOLUS may file any submissions that are intended to change or modify Labeling or prescribing information approved by Health Canada for the Agreement Products in the field for the Territory; provided that, except as required by Applicable Laws, EVOLUS will provide to the DISTRIBUTOR a draft of such submission at least ten (10) business days prior to a planned submission to the applicable Regulatory Authority and EVOLUS will give reasonable consideration to any comments the DISTRIBUTOR may have. For greater certainty it is acknowledged and agreed that the labeling with respect to Products for distribution in Canada will be different than labeling for Products for distribution in the United States, as a result of among other things, the requirement in Canada to have the label in both English and French languages.
Patent Filing Prosecution and Maintenance 7.1 Except as otherwise provided in this Article 7, the IC agrees to take responsibility for, but to consult with, the Licensee in the preparation, filing, prosecution, and maintenance of any and all patent applications or patents included in the Licensed Patent Rights and shall furnish copies of relevant patent-related documents to the Licensee. 7.2 Upon the IC’s written request, the Licensee shall assume the responsibility for the preparation, filing, prosecution, and maintenance of any and all patent applications or patents included in the Licensed Patent Rights and shall, on an ongoing basis, promptly furnish copies of all patent-related documents to the IC. In this event, the Licensee shall, subject to the prior approval of the IC, select registered patent attorneys or patent agents to provide these services on behalf of the Licensee and the IC. The IC shall provide appropriate powers of attorney and other documents necessary to undertake this action to the patent attorneys or patent agents providing these services. The Licensee and its attorneys or agents shall consult with the IC in all aspects of the preparation, filing, prosecution and maintenance of patent applications and patents included within the Licensed Patent Rights and shall provide the IC sufficient opportunity to comment on any document that the Licensee intends to file or to cause to be filed with the relevant intellectual property or patent office. 7.3 At any time, the IC may provide the Licensee with written notice that the IC wishes to assume control of the preparation, filing, prosecution, and maintenance of any and all patent applications or patents included in the Licensed Patent Rights. If the IC elects to reassume these responsibilities, the Licensee agrees to cooperate fully with the IC, its attorneys, and agents in the preparation, filing, prosecution, and maintenance of any and all patent applications or patents included in the Licensed Patent Rights and to provide the IC with complete copies of any and all documents or other materials that the IC deems necessary to undertake such responsibilities. The Licensee shall be responsible for all costs associated with transferring patent prosecution responsibilities to an attorney or agent of the IC’s choice. 7.4 Each party shall promptly inform the other as to all matters that come to its attention that may affect the preparation, filing, prosecution, or maintenance of the Licensed Patent Rights and permit each other to provide comments and suggestions with respect to the preparation, filing, prosecution, and maintenance of the Licensed Patent Rights, which comments and suggestions shall be considered by the other party.
New Application for Licensure Any time after the three-month period has lapsed from the Effective Date of this Agreement and Respondent has paid the Administrative Penalty set forth in Section III, Paragraph 1 of this Order, Respondent may apply for a new mortgage loan originator license or, as applicable, petition for the reinstatement of an MLO Activity Endorsement in any or all of the Participating States with the understanding that each State Mortgage Regulator reserves the rights to fully investigate such application for licensure or petition for reinstatement of an MLO Activity Endorsement and may either approve or deny such application or petition pursuant to the normal process for such licensing or endorsement investigations. No license application or petition described in this paragraph will be denied solely based on the facts, circumstances, or consensual resolution provided for in this Agreement. Respondent further agrees that Respondent must satisfy the Administrative Penalty provision prior to submitting an application for a new mortgage loan originator license or, as applicable, petition for the reinstatement of an MLO Activity Endorsement.
Joint Drafting The Parties have participated jointly in the negotiation and drafting of this Agreement. In the event an ambiguity or question of intent or interpretation arises, this Agreement shall be construed as if drafted jointly by the Parties and no presumption or burden of proof shall arise favoring or disfavoring any Party by virtue of the authorship of any of the provisions of this Agreement.
Background Screening VENDOR shall comply with all requirements of Sections 1012.32 and 1012.465, Florida Statutes, and all of its personnel who (1) are to be permitted access to school grounds when students are present, (2) will have direct contact with students, or (3) have access or control of school funds, will successfully complete the background screening required by the referenced statutes and meet the standards established by the statutes. This background screening will be conducted by SBBC in advance of VENDOR or its personnel providing any services under the conditions described in the previous sentence. VENDOR shall bear the cost of acquiring the background screening required by Section 1012.32, Florida Statutes, and any fee imposed by the Florida Department of Law Enforcement to maintain the fingerprints provided with respect to VENDOR and its personnel. The parties agree that the failure of VENDOR to perform any of the duties described in this section shall constitute a material breach of this Agreement entitling SBBC to terminate immediately with no further responsibilities or duties to perform under this Agreement. VENDOR agrees to indemnify and hold harmless SBBC, its officers and employees from any liability in the form of physical or mental injury, death or property damage resulting from VENDOR’s failure to comply with the requirements of this section or with Sections 1012.32 and 1012.465, Florida Statutes.
GRANT AND SCOPE OF LICENCE 1.1 In consideration of payment by you of the agreed licence fee and you agreeing to abide by the terms of this Licence, we grant to you a non-exclusive, non-transferable and non-sublicensable licence to use the Software and the Documents in the UK on the terms of this Licence.