PRODUCT ACCEPTANCE Unless otherwise provided by mutual agreement of the Authorized User and the Contractor in the Authorized User Agreement, Authorized User(s) shall have sixty (60) days from the date of delivery to accept all Product. Where the Contractor is responsible for installation, acceptance shall be from completion of installation. Title or other property interest and risk of loss shall not pass from Contractor to the Authorized User until the Products have been accepted. Failure to provide notice of acceptance or rejection or a deficiency statement to the Contractor by the end of the period provided for under this clause constitutes acceptance by the Authorized User(s) as of the expiration of that period. The License Term shall be extended by the time periods allowed for trial use, testing and acceptance unless the Commissioner or Authorized User agrees to accept the Product at completion of trial use. Unless otherwise provided by mutual agreement of the Authorized User and the Contractor, Authorized User shall have the option to run testing on the Product prior to acceptance, such tests and data sets to be specified by User. Where using its own data or tests, Authorized User must have the tests or representative set of data available upon delivery. This demonstration will take the form of a documented installation test, capable of observation by the Authorized User, and shall be made part of the Contractor’s standard documentation. The test data shall remain accessible to the Authorized User after completion of the test. In the event that the documented installation test cannot be completed successfully within the specified acceptance period, and the Contractor or Product is responsible for the delay, Authorized User shall have the option to cancel the order in whole or in part, or to extend the testing period for an additional thirty
CONTRACT ACCEPTANCE By acceptance of this order, Xxxxxx agrees that the scope of the work required is understood by Xxxxxx; that there are no informal commitments by Buyer that in any way affect the work under this order; that there are no open or unresolved issues related to this order except as explicitly stated herein; and that Xxxxxx therefore understands and agrees that this order states the complete agreement of the parties. CAS requirements do not apply if the order does not exceed $650,000 or if the Seller claims an exemption per the Proposal Representation and Certification, or if certified cost or pricing data was not provided.
Deemed Acceptance You are required to accept the terms and conditions set forth in this Agreement prior to the first vest date in order for you to receive the Award granted to you hereunder. If you wish to decline this Award, you must reject this Agreement prior to the first vest date. For your benefit, if you have not rejected the Agreement prior to the first vest date, you will be deemed to have automatically accepted this Award and all the terms and conditions set forth in this Agreement. Deemed acceptance will allow the shares to be released to you in a timely manner and once released, you waive any right to assert that you have not accepted the terms hereof.
Card Acceptance When accepting a Card, Xxxxxxxx will follow the steps provided by Servicer for accepting Cards and will: (a) determine in good faith and to the best of its ability that the Card is valid on its face; (b) obtain Authorization from the Card Issuer to charge the Cardholder's account; (c) unless the Sales Draft is electronically generated or is the result of a mail, internet, phone or preauthorized order, (i) obtain an Imprint of the Card including embossed data from the merchant imprinter plate; and (ii) obtain the Cardholder's signature on the Sales Draft and compare that signature to the signature on the Card; (d) enter a description of the goods or services sold and the price thereof (including any applicable taxes); (e) deliver a true and completed copy of the Sales Draft to the Cardholder at the time the goods are delivered or services performed, or, if the Sales Draft is prepared by a point-of-sale terminal, at the time of the sale; (f) offer the Sales Draft to Servicer for purchase according to Servicer's procedures and the terms of this Agreement; and (g) make a Card Imprint, if the Transaction is not based upon a mail, internet, phone or pre-authorized order.
Inspection; Acceptance The Contractor (immixTechnology, Inc.) can only, and shall only tender for acceptance those items that substantially conform to the software manufacturer’s (“Qualtrics”) published specifications. Therefore, items delivered shall be considered accepted upon delivery. The Government reserves the right to inspect or test any supplies or services that have been delivered. The Government may require repair or replacement of nonconforming supplies or re-performance of nonconforming services at no increase in contract price. If repair/replacement or re-performance will not correct the defects or is not possible, the Government may seek an equitable price reduction or adequate consideration for acceptance of nonconforming supplies or services. The Government must exercise its post-acceptance rights-(1) Within the warranty period; and (2) Before any substantial change occurs in the condition of the item, unless the change is due to the defect in the item.
Order Acceptance Xxxxxxx’x acceptance of the Order and consequent agreement to the Contract by either: (a) delivering the Goods, Services, or Digital Services; or
Engagement; Acceptance The Issuer engages Xxxxxxx Fixed Income Services LLC to act as the Asset Representations Reviewer for the Issuer. Xxxxxxx Fixed Income Services LLC accepts the engagement and agrees to perform the obligations of the Asset Representations Reviewer on the terms in this Agreement.
Bankers’ Acceptances (a) The Canadian Administrative Agent, promptly following receipt of a Notice of Borrowing or Notice of Continuation, requesting BA Loans, shall advise each applicable Canadian Lender of the face or principal amount and term of each BA Loan to be accepted (and purchased) or advanced by it. The aggregate face or principal amount of BA Loans to be accepted or advanced by a Canadian Lender shall be determined by the Canadian Administrative Agent by reference to that Canadian Lender’s applicable pro rata portion of the issue or advance of BA Loans, except that the aggregate face amount of Bankers’ Acceptances to be accepted by the applicable Canadian Lenders shall be increased or reduced by the Canadian Administrative Agent in its sole discretion as may be necessary to ensure that the face amount of the Bankers’ Acceptance to be accepted by each applicable Canadian Lender would be C$100,000 or a whole multiple thereof. For greater certainty, the foregoing C$100,000 minimum face amount of Bankers’ Acceptances for each Lender shall not apply to BA Equivalent Loans. (b) On the date specified in a Notice of Borrowing or Notice of Continuation on which a BA Loan is to be made, the Canadian Administrative Agent shall advise the Canadian Borrower as to the Canadian Administrative Agent’s determination of the BA Discount Rate for the BA Loans to be purchased or advanced, as the case may be. (c) The Canadian Borrower shall sell and each Canadian Lender shall purchase the Bankers’ Acceptance accepted by it at the applicable BA Discount Rate. Subject to clause (d) below, each Canadian Lender shall provide the Canadian Administrative Agent, for the account of the Canadian Borrower, the BA Discount Proceeds less the Applicable Stamping Fee payable by the Canadian Borrower with respect to the Bankers’ Acceptance. (d) In the event the Canadian Borrower requests a continuation of BA Loans for a further Interest Period, or requests conversion from Canadian Prime Loans into BA Loans in accordance with Section 2.6, the Canadian Administrative Agent shall make arrangements satisfactory to it to ensure the BA Discount Proceeds from the replacement BA Loans are applied to repay the face amount of the maturing BA Loans or the principal amount of such loans to be converted (the “Maturing Amount”) and the Canadian Borrower should concurrently pay to the Canadian Administrative Agent any positive difference between the Maturing Amount and such BA Discount Proceeds. (e) Each Canadian Lender may from time to time hold, sell, rediscount or otherwise dispose of any or all Bankers’ Acceptances accepted and purchased by it. (f) In order to facilitate the issuance of Bankers’ Acceptances pursuant to this Agreement, the Canadian Borrower hereby authorizes each of the Canadian Lenders, and appoints each of the Canadian Lenders as the Canadian Borrower’s attorney, to complete, sign and endorse drafts or depository bills (as defined in the Depository Bills and Notes Act (Canada) (each such executed draft or xxxx being herein referred to as a “Draft”) on its behalf in handwritten form or by facsimile or mechanical signature or otherwise in accordance with the applicable Notice of Borrowing or Notice of Continuation and, once so completed, signed and endorsed to accept them as Bankers’ Acceptances under this Agreement and then if applicable, purchase, discount or negotiate such Bankers’ Acceptances in accordance with the provisions of this Agreement. Drafts so completed, signed, endorsed and negotiated on behalf of the Canadian Borrower by a Canadian Lender shall bind the Canadian Borrower as fully and effectively as if so performed by an Authorized Officer of the Canadian Borrower. Each draft of a Bankers’ Acceptance completed, signed or endorsed by a Canadian Lender shall mature on the last day of the term thereof. All Bankers’ Acceptances to be accepted by a particular Canadian Lender shall, at the option of such Canadian Lender, be issued in the form of depository bills made payable originally to and deposited with The Depository for Securities Limited pursuant to the Depository Bills and Notes Act (Canada). (g) Any Drafts to be used for Bankers’ Acceptances which are held by a Canadian Lender shall be held in safekeeping with the same degree of care as if they were such Canadian Lender’s own property being kept at the place at which they are to be held. The Canadian Borrower may, by written notice to the Canadian Administrative Agent, designate persons other than Authorized Officers authorized to give the Canadian Administrative Agent instructions regarding the manner in which Drafts are to be completed and the times at which they are to be issued; provided however that receipt by the Canadian Administrative Agent of a Notice of Borrowing or Notice of Continuation requesting an advance or continuation into, Bankers’ Acceptances shall be deemed to be sufficient authority from Authorized Officers or such designated persons for each of the Canadian Lenders to complete, and issue drafts in accordance with such notice. None of the Canadian Administrative Agent or the Canadian Lenders nor any of their respective directors, officers, employees or representatives shall be liable for any action taken or omitted to be taken by any of them under this Section 2.14(g) except for their own respective gross negligence or willful misconduct as determined by a final judgment of a court of competent jurisdiction. (h) The Canadian Borrower waives presentment for payment and any other defense to the payment of any amounts due to a Canadian Lender in respect of a Bankers’ Acceptance accepted and purchased by it pursuant to this Agreement which might exist solely by reason of the Bankers’ Acceptance being held, at the maturity thereof, by the Canadian Lender in its own right and the Canadian Borrower agrees not to claim any days of grace if the Canadian Lender as holder sues the Canadian Borrower on the Bankers’ Acceptance for payment of the amount payable by the Canadian Borrower thereunder. Each Bankers’ Acceptance shall mature and the face amount thereof shall be due and payable on the last day of the Interest Period applicable thereto. (i) Whenever the Canadian Borrower requests a Loan under this Agreement by way of Bankers’ Acceptances, each Non-Acceptance Lender shall, in lieu of accepting a Bankers’ Acceptance, make a BA Equivalent Loan by way of Discount Note in an amount equal to the Non-Acceptance Lender’s pro rata portion of the BA Loan. All terms of this Agreement applicable to Bankers’ Acceptances shall apply equally to Discount Notes evidencing BA Equivalent Loans with such changes as may in the context be necessary. For greater certainty: (i) the term of a Discount Note shall be the same as the Interest Period for Bankers’ Acceptances accepted on the same date of the Borrowing in respect of the same BA Loan; (ii) an acceptance fee will be payable in respect of a Discount Note and shall be calculated at the same rate and in the same manner as the Applicable Stamping Fee in respect of a Bankers’ Acceptance; and (iii) the proceeds from a BA Equivalent Loan shall be equal to the BA Discount Proceeds of the Discount Note.
Appointment and Acceptance The Trust hereby appoints JNLD as distributor of the Shares of the Funds set forth on Schedule A on the terms and for the period set forth in this Agreement, and JNLD hereby accepts such appointment and agrees to render the services and undertake the duties set forth herein.
Electronic Acceptance You expressly confirm that you have read, agree to, and consent to be bound by all of the terms of this User Agreement, including all disclosures in this agreement, including those in Section 18.3. By electronically signing this User Agreement, which may be completed by all methods of “clickwrap” or “click through” including by accepting, clicking a button, or checking a box, you acknowledge and agree that such electronic signature is valid evidence of your consent to be legally bound by this User Agreement and such subsequent
