SHPM Sample Clauses

SHPM. Figure 20 shows the spatial distribution of the maximum fluid overpressure inferred from repeated slip in map view. Assuming a constant stress drop of 1 MPa, obtained fluid overpressure values in the reservoir are mostly in the range of a few megapascals. Several areas could be identified exhibiting overpressure peaks in the range of >10 MPa with maximum overpressures up to approximately 20 MPa. These overpressure maxima occurred at different times of sub-surface operations. In comparison to the results of the Xxxxxx Basin (see Chapter 3.1.2), the area containing fluid overpressure information is rather limited here. Ignoring the single data points in the outer area, the spatial distribution of fluid overpressures is restricted to a lateral extension of approx. 700m. Due to the relatively low earthquake density (and in fact the comparable small number of events in this dataset), the previously mentioned averaging effect will be less strong. As a consequence, the impact of the assumed stress drop on the inferred overpressure evolution might be larger than observed for the Xxxxxx Basin dataset. Since the analysis is based on relative hypocenter locations, the wellbore location relative to the seismic cloud is not well resolved. We speculate that the SHPM overpressure maximum at -750/800 might be located close to the flow exit of the wellbore. Figure 20: Spatial distribution of maximum fluid overpressure inferred from repeated slip in map view. The time at which the maximum fluid overpressure is reached varies over the reservoir. Overpressure is stated in megapascal according to the color map. The dashed contour line denotes main region of seismic activity. Green-, red- and blue-coloured arrows indicate north, east and z direction, respectively (after rotation into block-spring coordinate system). A constant stress drop of 1.0 MPa is assumed for determining fluid overpressure. To test the SHPM results for plausibility, resolved overpressures were compared with calculated reservoir pressure at the wellbore. The data for this analysis (wellhead pressure and fluid density) was provided by X. Xxxxx (St. Xxxxxx Stadtwerke) and prepared by GeoT. Geothermie Neubrandenburg GmbH (GTN) set the static pressure to 37.09 MPa for a depth of 3785 m TVD (Xxxxxxxxx et al., 2014). Since the open hole section is located at a depth of 3818 - 4175 m TVD (according to Figure 4 in Xxxxxxxxx, 2015), static pressure for this depth interval was calculated using the hydrostatic equatio...
AutoNDA by SimpleDocs

Related to SHPM

  • Transnet (i) For legal notices: …………………………………………………… …………………………………………………… …………………………………………………… Fax No. ………… Attention: Group Legal Department

  • Sergeant Twenty percent (20%) over the top step hourly rate for Sergeant when acting as a supervisor (otherwise twenty percent (20%) over the top step hourly rate for Police Officer).

  • meminta nasihat daripada Pihak Xxxxxx dalam semua perkara berkenaan dengan jualan lelongan, termasuk Syarat-syarat Jualan (iii) membuat carian Hakmilik Xxxxx xxxxxx rasmi di Pejabat Tanah xxx/atau xxxx-xxxx Pihak-pihak Berkuasa yang berkenaan xxx (iv) membuat pertanyaan dengan Pihak Berkuasa yang berkenaan samada jualan ini terbuka kepada semua bangsa atau kaum Bumiputra Warganegara Malaysia sahaja atau melayu sahaja xxx juga mengenai persetujuan untuk jualan ini sebelum jualan lelong.Penawar yang berjaya (“Pembeli”) dikehendaki dengan segera memohon xxx mendapatkan kebenaran pindahmilik (jika ada) daripada Pihak Pemaju xxx/atau Pihak Tuanpunya xxx/atau Pihak Berkuasa Negeri atau badan-badan berkenaan (v) memeriksa xxx memastikan samada jualan ini dikenakan cukai. BUTIR-BUTIR HARTANAH : HAKMILIK : Hakmilik strata bagi hartanah ini masih belum dikeluarkan oleh pihak berkuasa. NO. HAKMILIK INDUK / NO. LOT : Geran 203771, Lot 106 Seksyen 3 PEKAN/DAERAH/NEGERI : Pekan Batu Tiga / Petaling / Selangor Darul Ehsan PEGANGAN : Selama-lamanya KELUASAN LANTAI : 93.65 meter persegi (1,008 kaki persegi) PEMAJU : Shanghai Realty (M) Sdn Bhd (350799-U) XXXXXXXX XXX : Xxxxxxxx Xxxxx Bin Xxxxxx BEBANAN : Diserahhak kepada RHB Islamic Bank Berhad (200501003283/680329-V) LOKASI XXX PERIHAL HARTANAH Hartanah tersebut terletak di Pangsapuri Indahria, Xx. 0, Xxxxx Xxxx Xxxx-Xxxxxx Xxxxx, Xxxxx Xxxxxxx, Xxxxxxx 00, 00000 Xxxx Xxxx, Xxxxxxxx Xxxxx Xxxxx. Hartanah tersebut adalah sebuah unit pangsapuri dikenali sebagai Xxxxx Pemaju No. P5-2-11, Tingkat No. 2, Bangunan No. P5, berserta dengan Xxxxx Aksesori No. GRD-07, Pangsapuri Indahria xxx mempunyai alamat surat-menyurat di Unit No. P5-02-11, Pangsapuri Indahria, Xx. 0, Xxxxx Xxxx Xxxx-Xxxxxx Xxxxx, Xxxxx Xxxxxxx, Xxxxxxx 00, 00000 Xxxx Xxxx, Xxxxxxxx Xxxxx Xxxxx. HARGA RIZAB: Harta ini dijual “keadaan seperti mana sediada” dengan harga rizab sebanyak RM 270,000.00 (RINGGIT MALAYSIA: DUA RATUS XXX TUJUH PULUH RIBU SAHAJA) xxx tertakluk kepada syarat-syarat Jualan xxx melalui penyerahan hakkan dari Pemegang Serahak, tertakluk kepada kelulusan di perolehi oleh pihak Pembeli daripada pihak berkuasa, jika ada, termasuk semua terma, syarat xxx perjanjian yang dikenakan xxx mungkin dikenakan oleh Pihak Berkuasa yang berkenaan. Pembeli bertanggungjawab sepenuhnya untuk memperolehi xxx mematuhi syarat- syarat berkenaan daripada Pihak Berkuasa yang berkenaan, jika ada xxx semua xxx xxx perbelanjaan ditanggung xxx dibayar oleh Xxxxx Xxxxxxx.Pembeli atas talian (online) juga tertakluk kepada terma-terma xxx syarat-syarat terkandung dalam xxx.xxxxxxxxxxxxxxxx.xxx Pembeli yang berminat adalah dikehendaki mendeposit kepada Pelelong 10% daripada harga rizab dalam bentuk Bank Draf atau Cashier’s Order di atas nama RHB Islamic Bank Berhad sebelum lelongan awam xxx xxxx xxxx xxxxxx bersama-sama dengan segala cukai jualan xxx perkhidmatan (SST) xxx/atau cukai yang menggantikan SST hendaklah dibayar dalam tempoh sembilan puluh (90) hari dari tarikh lelongan kepada RHB Islamic Bank Berhad melalui XXXXXX. Butir-butir pembayaran melalui XXXXXX, xxxx berhubung dengan Tetuan T. Rajagopalu & Co. Untuk maklumat lanjut, xxxx berhubung dengan TETUAN T. RAJAGOPALU & CO, Solicitors for Assignee herein whose address is at Xxxxx 0-0, Xxxxxxxx Xxxx Xxxxxx Xxxxx Xxxxx, 00000 Xxxxxxxx Xxxxxx Xxxxxxxx. Tel: 00-0000000 / Fax: 00-0000000 [Ruj: RG/RHB/0339/2023/SYAFIQAH(yusof)], peguamcara bagi pihak pemegang xxxxx xxx atau pelelong yang tersebut dibawah. RAJAN AUCTIONEERS SDN. BHD. X. XXXXX Xx.00X,Xxxxxxx Xxxx,Xxxxx Xxxx Xxxxxx, ( Xxxxxxxx Berlesen ) 41000 Klang, Selangor Darul Ehsan. H/P: 000-0000000 Tel: 00-00000000 / Fax : 00-00000000 H/P: 012-2738109 Ruj Kami: RA/RHBI/TRC/NS/4220-24(fz) CONDITIONS OF SALE

  • Millwright Xxxxx be to assist and work under the direction and instructions I or A. He will work alone at times performing assignments in keeping with his training. During the course of his year, training must become proficient in good practices in the areas of fitting, aligning, lubricating and the operation of all shop tools and machines. In addition to the foregoing, he will be exposed to and the process of learning techniques required in trouble shooting key production machinery, pipe fitting, basic welding and machining but not be expected to display a high degree of proficiency in these areas at this point. Millwright Must be capable of performing the tasks of fittings, aligning, lubricating an able to operate all shop tools and machines. Must under direction become proficient in basic welding and pipe fitting as well as dismantling and reassembly of plant equipment. Under direction,will continueto develop skills in trouble shooting all plant equipment and improve his skills at machining part and be exposed to basic principles of hydraulics and pneumatic. He may work alone frequently, but occasionally will require direction and instructions form Millwright I or A. Millwright 11: be capable, without direction of fitting, aligning and lubrication and taking apart and reassembling plant equipment. In addition, is expected to be able to weld, operate shop tools and do pipe fitting as required. Must under direction, become proficient at effective methods of trouble shooting and repairing hydraulic, pneumatic and mechanical faults in plant machinery. I: Must be capable without direction of performing all practices under Xxxxxxxxxx Must under directionbecomeproficient at reading and understanding blueprints, all phases of installing new equipment, laying out hydraulic and mechanical drives and meet speed and power requirements correctly. Xxxxxxxxxx "A": Must he capable without direction, of performing all under Xxxxxxxxxx X, and Must take full responsibility for work done by himself or his assistant. Must he in possession of a Millwright Certificate or a Machinist Certificate or Welder Certificate. Millwrightspresently employed in this classification will not be required to have a Certificate.

  • MSEA SEIU shall have exclusive rights to payroll deduction of membership dues, service fees, and premiums for current MSEA-SEIU spon- sored insurance programs. Deductions for other programs may be mutually agreed to by the parties.

  • SDBE The Contractor shall comply with all applicable provisions of Article III of Chapter 18 of the Durham City Code (Equal Business Opportunities Ordinance), as amended from time to time. The failure of the Contractor to comply with that article shall be a material breach of contract which may result in the rescission or termination of this contract and/or other appropriate remedies in accordance with the provisions of that article, this contract, and State law. The Participation Plan submitted in accordance with that article is binding on the Contractor. Section 18-59(f) of that article provides, in part, “If the City Manager determines that the Contractor has failed to comply with the provisions of the Contract, the City Manager shall notify the Contractor in writing of the deficiencies. The Contractor shall have 14 days, or such time as specified in the Contract, to cure the deficiencies or establish that there are no deficiencies.” It is stipulated and agreed that those two quoted sentences apply only to the Contractor’s alleged violations of its obligations under Article III of Chapter 18 and not to the Contractor’s alleged violations of other obligations.

  • Cloud storage DSHS Confidential Information requires protections equal to or greater than those specified elsewhere within this exhibit. Cloud storage of Data is problematic as neither DSHS nor the Contractor has control of the environment in which the Data is stored. For this reason:

  • Vynálezy Stávající vynálezy a technologie Zadavatele nebo Zdravotnického zařízení zakládají jejich samostatné vlastnictví a Smlouva na ně nemá žádný vliv. Kompletní práva, nároky a podíly ohledně veškerých vynálezů, know-how, autorských práv nebo jiných práv duševního vlastnictví, které vzniknou, budou vyvinuty nebo použity v praxi (včetně veškerých zlepšení nebo úprav), které i) používají, využívají nebo zahrnují Hodnocené léky; ii) jsou zahrnuty nebo předvídány v Protokolu; nebo iii) používají, využívají nebo zahrnují Důvěrné informace, zakládají výlučné vlastnictví Zadavatele (společně xxxx xxx „Vynálezy Zadavatele“). Zdravotnické zařízení je povinno bezodkladně písemně informovat PRA a/nebo Zadavatele o každém takovém Vynálezu Zadavatele, a tímto převádí (a zajistí, aby všichni členové studijního týmu převedli) na Zadavatele veškerá práva, nároky a podíly týkající se každého jednotlivého Vynálezu Zadavatele. Zdravotnické zařízení se zavazuje poskytnout Zadavateli na jeho náklady přiměřenou pomoc, xxx xxxx Zadavatel smluvně zajistit a vykonávat svá práva na takové Vynálezy Zadavatele. Zdravotnické zařízení má výlučný vlastnický titul ke všem vynálezům nebo objevům, které vzniknou nebo budou použity v praxi výhradně zásluhou Zdravotnického zařízení, a které nenáleží Zadavateli. 9.

  • Clinical Management for Behavioral Health Services (CMBHS) System The CMBHS is the official record of documentation by System Agency. Grantee shall:

  • ARTISTES AND SPORTSPERSONS 1. Notwithstanding the provisions of Articles 14 and 15, income derived by a resident of a Contracting State as an entertainer, such as a theatre, motion picture, radio or television artiste, or a musician, or as a sportsperson, from his personal activities as such exercised in the other Contracting State, may be taxed in that other State.

Time is Money Join Law Insider Premium to draft better contracts faster.