of these General Conditions In case of conflict between any time requirements in this paragraph and any time requirements for action by the Architect on Contractor’s Application for Payment contained in the State-Contractor Agreement, the time requirements contained in the State- Contractor Agreement shall control.
General Conditions (i) Each party will make each payment or delivery specified in each Confirmation to be made by it, subject to the other provisions of this Agreement. (ii) Payments under this Agreement will be made on the due date for value on that date in the place of the account specified in the relevant Confirmation or otherwise pursuant to this Agreement, in freely transferable funds and in the manner customary for payments in the required currency. Where settlement is by delivery (that is, other than by payment), such delivery will be made for receipt on the due date in the manner customary for the relevant obligation unless otherwise specified in the relevant Confirmation or elsewhere in this Agreement. (iii) Each obligation of each party under Section 2(a)(i) is subject to (1) the condition precedent that no Event of Default or Potential Event of Default with respect to the other party has occurred and is continuing, (2) the condition precedent that no Early Termination Date in respect of the relevant Transaction has occurred or been effectively designated and (3) each other applicable condition precedent specified in this Agreement.
General Condition The Aircraft will: (a) be clean by international airline standards; (b) have installed the full complement of engines and other material equipment, parts and accessories and loose equipment required under the Agreed Maintenance Program and installed in the other Boeing/XxXxxxxxx Xxxxxxx MD-87 aircraft operated by Lessee (together with any additions and improvements thereto, or replacements thereof, effected pursuant to and in accordance with this Agreement) and be in a condition suitable for immediate operation in commercial service; (c) be airworthy, conform to type design and be in a condition for safe operation with all equipment, components and systems operating in accordance with their intended use and within limits established by the manufacturer and approved by the Aviation Authority, and all pilot discrepancies and deferred maintenance items cleared on a terminating action basis; (d) have a U.S. Standard Transport Category Certificate of Airworthiness issued by the FAA in accordance with FAR Part 129 (or if required by the Lessor, be eligible for a valid export certificate of airworthiness with respect to the Aircraft issued by the Aviation Authority) and unconditionally meet all FAA requirements for immediate operations under FAR Part 129; (e) comply with the manufacturer's original specification to the extent that it so complied on the date of this Agreement and subject to any alterations made pursuant to and in accordance with this Agreement after such date; (f) have undergone, immediately prior to redelivery, the MSG-3 equivalent of a "C" Check in accordance with the Agreed Maintenance Program so that all Airframe inspections falling due within the next 3,000 hours, 3,000 cycles or twelve months (whichever is applicable and most limiting) of operation in accordance with the Agreed Maintenance Program have been accomplished; (g) if the Flight Hours of the Airframe remaining until the scheduled completion of the Major Checks (collectively, a "Complete Heavy Work Package") on the Expiry Date are: (i) less than on the Delivery Date, then the Lessee shall pay to the Lessor an amount equal to the product of (a) the number of Flight Hours remaining until the scheduled completion of a Complete Heavy Work Package as of the Expiry Date that are less than the number of Flight Hours that were remaining until the scheduled completion of a Complete Heavy Work Package as of the Delivery Date (b) multiplied by US$50.00, provided, however, that no payment shall be due from -------- ------- Lessee under this clause (g)(i) if, immediately preceding the redelivery of the Aircraft, the Lessee has performed a Complete Heavy Work Package; (ii) more than on the Delivery Date, then the Lessor shall pay to the Lessee an amount equal to the product of (a) the number of Flight Hours remaining until the scheduled completion of a Complete Heavy Work Package as of the Expiry Date that are more than the number of Flight Hours that were remaining until the scheduled completion of a Complete Heavy Work Package as of the Delivery Date (b) multiplied by US$50.00; For the avoidance of doubt, any amounts due to the Lessor pursuant to this clause (g) may be set off against any amounts due to Lessee pursuant to paragraphs (b) or (d) of Schedule 10 and a payment made for the net amount due; (h) have complied with all airworthiness directives and mandatory orders affecting that model of Aircraft issued by the Aviation Authority (and, if different, the FAA) that are required terminating action during the Term; (i) no special or unique manufacturer inspection or check requirements specific to the Aircraft will exist unless there is no terminating action available from any source; (j) have installed all applicable vendor's and manufacturer's service bulletin kits received free of charge by the Lessee that are appropriate for the Aircraft and, to the extent not installed, those kits which have been received with respect to this Aircraft will be furnished free of charge to the Lessor; (k) be free of any system-related leaks which are outside maintenance manual limitations; (l) all fluid reservoirs (including fuel, oil, oxygen, hydraulic and water) will be full, and the waste tank serviced in accordance with the manufacturer's instructions; (m) if required under the Approved Maintenance Program, all fuel tanks will have recently undergone an anti-fungus/biological growth contamination laboratory evaluation, and any excessive levels of contamination corrected; (n) have an FAA-approved aging aircraft program in operation and up-to-date; and (o) have all signs and decals clean, secure and legible.
Modifications to the General Conditions The modifications to the General Conditions are as follows: 1. Paragraph (a) of Section 2.07 is modified to read as follows:
General conditions precedent The agreement of the Finance Parties referred to in clause 2 (Agreement of the Finance Parties) shall be further subject to: (a) the representations and warranties in clause 4 (Representations and warranties) being true and correct on the Effective Date as if each was made with respect to the facts and circumstances existing at such time; and (b) no Event of Default or Default having occurred and continuing at the time of the Effective Date.
of the General Conditions The certified or cashier's check or bond shall be in the amount of the 5% of the original contract amount, and shall have an expiration date consistent with the final correction or warranty period.
GENERAL CONDITIONS OF CONTRACT (National Treasury - General Conditions of Contract (revised July 2010))
SPECIAL CONDITIONS A submitted appeal must;
General Conditions Costs Contractor is entitled to receive payment for the actual cost of the allowable General Conditions items incurred after receipt of a Notice to Proceed with Construction from Owner through Substantial Completion of the Project, plus 30 calendar days. Contractor is not entitled to reimbursement for General Conditions Costs incurred before receipt of the Notice to Proceed. General Conditions Costs incurred after Substantial Completion, plus 30 calendar days, must be approved in advance by Owner. Allowable General Conditions items are identified below and in Exhibit “D” attached to this Agreement. These items shall be included in the General Conditions Cost amount shown as a line item in the Guaranteed Maximum Price Proposal and as detailed on the Schedule of Values. Items not specifically included below or in Exhibit “D” will not be allowed as General Condition Costs.
Environmental Conditions A Phase I environmental site assessment (or update of a previous Phase I and or Phase II environmental site assessment) and, with respect to certain Mortgage Loans, a Phase II environmental site assessment (collectively, an “ESA”) meeting ASTM requirements conducted by a reputable environmental consultant in connection with such Mortgage Loan within 12 months prior to its origination date (or an update of a previous ESA was prepared), and such ESA (i) did not identify the existence of recognized environmental conditions (as such term is defined in ASTM E1527-13 or its successor, hereinafter “Environmental Condition”) at the related Mortgaged Property or the need for further investigation, or (ii) if the existence of an Environmental Condition or need for further investigation was indicated in any such ESA, then at least one of the following statements is true: (A) an amount reasonably estimated by a reputable environmental consultant to be sufficient to cover the estimated cost to cure any material noncompliance with applicable Environmental Laws or the Environmental Condition has been escrowed by the related Mortgagor and is held or controlled by the related Mortgagee; (B) if the only Environmental Condition relates to the presence of asbestos-containing materials, radon in indoor air, lead based paint or lead in drinking water, the only recommended action in the ESA is the institution of such a plan, an operations or maintenance plan has been required to be instituted by the related Mortgagor that can reasonably be expected to mitigate the identified risk; (C) the Environmental Condition identified in the related environmental report was remediated or abated in all material respects prior to the date hereof, and, if and as appropriate, a no further action or closure letter was obtained from the applicable governmental regulatory authority (or the environmental issue affecting the related Mortgaged Property was otherwise listed by such governmental authority as “closed” or a reputable environmental consultant has concluded that no further action is required); (D) an environmental policy or a lender’s pollution legal liability insurance policy that covers liability for the identified circumstance or condition was obtained from an insurer rated no less than “A-” (or the equivalent) by Xxxxx’x Investors Service, Inc., S&P Global Ratings, acting through Standard & Poor’s Financial Services LLC, Fitch Ratings, Inc. and/or A.M. Best Company; (E) a party not related to the Mortgagor was identified as the responsible party for such condition or circumstance and such responsible party has financial resources reasonably estimated to be adequate to address the situation; or (F) a party related to the Mortgagor having financial resources reasonably estimated to be adequate to address the situation is required to take action. To the Mortgage Loan Seller’s knowledge, except as set forth in the ESA, there is no Environmental Condition (as such term is defined in ASTM E1527-13 or its successor) at the related Mortgaged Property.
