Reportable Events Involving the Xxxxx Law Notwithstanding the reporting requirements outlined above, any Reportable Event that involves solely a probable violation of section 1877 of the Social Security Act, 42 U.S.C. §1395nn (the Xxxxx Law) should be submitted by Practitioner to CMS through the self-referral disclosure protocol (SRDP), with a copy to the OIG. If Practitioner identifies a probable violation of the Xxxxx Law and repays the applicable Overpayment directly to the CMS contractor, then Practitioner is not required by this Section III.G to submit the Reportable Event to CMS through the SRDP.
Penalties for Non-compliance to Service Level Agreement Where the Supplier/Service Provider fails to deliver the Goods/Services within the agreed and accepted milestone timelines and provided that the cause of the delay was not due to a fault of Transnet, penalties shall be imposed at …………………………………………………… .
Minimum Shipping Requirements for TIPS Sales Vendor shall ship, deliver, or provide ordered goods and services within a commercially reasonable time after acceptance of the order. If a delay in delivery is anticipated, Vendor shall notify the TIPS Member as to why delivery is delayed and provide an updated estimated time for completion. The TIPS Member may cancel the order if the delay is not commercially acceptable or not consistent with the Supplemental Agreement applicable to the order.
CERTIFICATION REGARDING DEBARMENT OR SUSPENSION Contractor certifies that neither Contractor or its principals; its subcontractors or their principals; the sub-recipients (if applicable) or their principals are suspended, debarred, proposed for debarment, voluntarily excluded from covered transactions, or otherwise disqualified by any federal department or agency from doing business with the Federal Government pursuant to Executive Orders 12549 and 12689. Contractor specifically covenants that neither the Contractor or its principals, its sub-contractors or their principals, or the sub-recipients (if applicable) or their principals are included on the Excluded Parties List System (“EPLS”) maintained by the General Services Administration (“GSA”).
Minimum Site Requirements for TIPS Sales (when applicable to TIPS Sale). Cleanup: When performing work on site at a TIPS Member’s property, Vendor shall clean up and remove all debris and rubbish resulting from their work as required or directed by the TIPS Member or as agreed by the parties. Upon completion of work, the premises shall be left in good repair and an orderly, neat, clean and unobstructed condition. Preparation: Vendor shall not begin a project for which a TIPS Member has not prepared the site, unless Vendor does the preparation work at no cost, or until TIPS Member includes the cost of site preparation in the TIPS Sale Site preparation includes, but is not limited to: moving furniture, installing wiring for networks or power, and similar pre‐installation requirements. Registered Sex Offender Restrictions: For work to be performed at schools, Vendor agrees that no employee of Vendor or a subcontractor who has been adjudicated to be a registered sex offender will perform work at any time when students are, or reasonably expected to be, present unless otherwise agreed by the TIPS Member. Vendor agrees that a violation of this condition shall be considered a material breach and may result in the cancellation of the TIPS Sale at the TIPS Member’s discretion. Vendor must identify any additional costs associated with compliance of this term. If no costs are specified, compliance with this term will be provided at no additional charge. Safety Measures: Vendor shall take all reasonable precautions for the safety of employees on the worksite, and shall erect and properly maintain all necessary safeguards for protection of workers and the public. Vendor shall post warning signs against all hazards created by the operation and work in progress. Proper precautions shall be taken pursuant to state law and standard practices to protect workers, general public and existing structures from injury or damage. Smoking: Persons working under Agreement shall adhere to the TIPS Member’s or local smoking statutes, codes, ordinances, and policies.
PROCEDURE FOR DEALING WITH SAFETY ISSUES OR INCIDENTS 11.1 The Employer, the Employees and the Union agree that for the purposes of s. 81 of the WHS Act matters about work health and safety arising at the workplace shall be resolved in accordance with this procedure.
11.2 The Parties agree that for the purposes of this procedure and s. 81(3) of the WHS Act the following persons shall be the representatives of the following parties:
(a) the Principal Contractor (as defined in the WHS Act) - Site Manager or any other person nominated by the Principal Contractor
(b) the Employers - the Site Manager or any other person nominated by the Employer(s)
(c) The Employees - the Union or other representatives. (Collectively referred to as "Nominated Parties”)
11.3 The Nominated Parties agree that representatives shall be entitled to:
(a) inspect any work system, plant, substance, structure, or other thing relevant to resolving the issue
(b) consult with relevant Employees in relation to resolving the issue
(c) consult with the relevant PCBU (as defined in the WHS Act) about resolving the issue
(d) inspect and take copies of any document that is directly relevant to resolving the issue; and
(e) advise any person whom the representative reasonably believes to be exposed to a serious risk to his or her health and safety, emanating from an immediate and imminent exposure to a hazard of that risk.
11.4 The Nominated Parties and/or their representatives may commence the procedure by informing, either by themselves or their representative, the other Parties and/or representatives that:
(a) there is an issue to be resolved; and
(b) the nature and scope of the issue.
11.5 As soon as the Parties and/or their representatives are informed of the issue, the Nominated Parties and/or their representatives must meet or communicate with each other to attempt to resolve the issue.
11.6 The Nominated Parties and/or their representatives must have regard to all relevant matters including:
(a) the degree and imminent risk to the Employees or other persons affected by the issue.
(b) the number and location of Employees and other persons affected by the issue.
(c) the measures both temporary and permanent that must be implemented to resolve the issue.
(d) who will be responsible for implementing the resolution measures.
(e) whether the hazard or risk can be isolated; and
(f) the time that may elapse before the hazard or risk is permanently corrected.
11.7 Once the issue is resolved details of the issue and its resolution must be set out in writing with all Nominated Parties and/or their representatives to be satisfied that the agreement reflects the resolution of the issue with a copy given to all Nominated Parties and/or their representatives to the issue. The issue, once resolved, shall be recorded in the next safety committee meeting minutes with the agreed resolution.
11.8 The Nominated Parties and/or their representatives must make reasonable efforts to achieve a timely and final resolution of the issue. If within a reasonable time there is still no resolution, any of the Nominated Parties attempting to resolve the issue may then ask Work Health and Safety Queensland, and/or the QBCC, where applicable, to arrange for an inspector to attend the workplace to assist in resolving the issue.
11.9 Direction to cease work
(a) If -
(i) an issue concerning health or safety arises at a workplace or from the conduct of the undertaking of the Employer; and
(ii) the issue concerns work which involves an immediate threat to the health or safety of any person; and
(iii) given the nature of the threat and degree of risk, it is not appropriate to adopt the processes set out in clause 11.7 above
(b) the Employer and/or the health and safety representative for the designated work group in relation to which the issue has arisen may, after consultation between them, direct that the work is to cease.
(c) During any period for which work has ceased in accordance with such a direction, the Employer may assign any Employees whose work is affected to suitable and safe alternative work.
11.10 Fundamental to this process is a standing invitation for Union representatives to attend site to assist with all matters relating to health and safety.
11.11 Employees are not required to work in circumstances where the employee or a Union representative reasonably believes a safety law is being, or will be, contravened. Consultation between the relevant parties will occur throughout this procedure including with senior representatives of the Employer and the Union.
Penalties for non-conformity of production 9.1. The approval granted in respect of a vehicle type pursuant to this Regulation may be withdrawn if the requirements set forth above are not met.
9.2. If a Contracting Party to the Agreement applying this Regulation withdraws an approval it has previously granted, it shall forthwith so notify the other Contracting Parties applying this Regulation, by means of a communication form conforming to the model in Annex 1 to this Regulation.
Minimum Condition and Warranty Requirements for TIPS Sales All goods quoted or sold through a TIPS Sale shall be new unless clearly stated otherwise in writing. All new goods and services shall include the applicable manufacturers minimum standard warranty unless otherwise agreed to in the Supplemental Agreement.
Selection of Subcontractors, Procurement of Materials and Leasing of Equipment The contractor shall not discriminate on the grounds of race, color, religion, sex, national origin, age or disability in the selection and retention of subcontractors, including procurement of materials and leases of equipment. The contractor shall take all necessary and reasonable steps to ensure nondiscrimination in the administration of this contract.
a. The contractor shall notify all potential subcontractors and suppliers and lessors of their EEO obligations under this contract.
b. The contractor will use good faith efforts to ensure subcontractor compliance with their EEO obligations.
Minimum Customer Support Requirements for TIPS Sales Vendor shall provide timely and commercially reasonable support for TIPS Sales or as agreed to in the applicable Supplemental Agreement.
