Taste and Odor Elimination Costs Sample Clauses

Taste and Odor Elimination Costs. Kennecott shall be responsible for all costs necessary to eliminate objectionable tastes and odors from water treated by the Zone A Plant due to causes above the Zone A Meter Station in order to meet the taste and odor standards for Zone A Treated Water established under Section 1.39 and Appendix 3. JVWCD shall be responsible for all taste and odor objections from such water due to causes below the Zone A Meter Station.
AutoNDA by SimpleDocs

Related to Taste and Odor Elimination Costs

  • Termination Costs If a Party elects to terminate this Agreement pursuant to Article 2.3.1 above, the terminating Party shall pay all costs incurred (including any cancellation costs relating to orders or contracts for Attachment Facilities and equipment) or charges assessed by the other Parties, as of the date of the other Parties’ receipt of such notice of termination, that are the responsibility of the terminating Party under this Agreement. In the event of termination by a Party, all Parties shall use commercially Reasonable Efforts to mitigate the costs, damages and charges arising as a consequence of termination. Upon termination of this Agreement, unless otherwise ordered or approved by FERC:

  • Transportation Costs The cost of transporting a Warranted Part claimed to be defective to the facilities designated by the Seller and for the return therefrom of a repaired or replaced Warranted Part shall be borne by the Buyer.

  • Litigation Costs If any legal action or other proceeding is brought for the enforcement of this Agreement or to remedy its breach, the prevailing party in such action or proceeding shall be entitled to recover its actual attorney's fees and other costs incurred in the action or proceeding, in addition to such other relief to which it may be entitled.

  • Construction Costs Under no circumstances shall the Consultant be liable for extra costs or other consequences due to unknown conditions or related to the failure of contractors to perform work in accordance with the plans and specifications. Consultant shall have no liability whatsoever for any costs arising out of the Client’s decision to obtain bids or proceed with construction before the Consultant has issued final, fully-approved plans and specifications. The Client acknowledges that all preliminary plans are subject to substantial revision until plans are fully approved and all permits obtained.

  • Modification Costs Developer shall not be assigned the costs of any additions, modifications, or replacements that Connecting Transmission Owner makes to the Connecting Transmission Owner’s Attachment Facilities or the New York State Transmission System to facilitate the interconnection of a third party to the Connecting Transmission Owner’s Attachment Facilities or the New York State Transmission System, or to provide Transmission Service to a third party under the NYISO OATT, except in accordance with the cost allocation procedures in Attachment S of the NYISO OATT. Developer shall be responsible for the costs of any additions, modifications, or replacements to the Developer Attachment Facilities that may be necessary to maintain or upgrade such Developer Attachment Facilities consistent with Applicable Laws and Regulations, Applicable Reliability Standards or Good Utility Practice.

  • Uncontrollable Forces Tariff Provisions Section 14.1 of the CAISO Tariff shall be incorporated by reference into this Agreement except that all references in Section 14.1 of the CAISO Tariff to Market Participants shall be read as a reference to the Participating Generator and references to the CAISO Tariff shall be read as references to this Agreement.

  • Fire Suppression Costs Purchaser’s obliga- tions for cost of fire suppression vary according to three classifications of fires as follows:

  • Start-Up Costs 4.1.1 The Government of Ontario will provide:

  • Tariff Elimination 1. Except as otherwise provided in this Agreement, no Party may increase any existing customs duty, or adopt any new customs duty, on an originating good.

  • CLOSING COSTS AND ADJUSTMENTS All adjustments are made as of settlement date.

Time is Money Join Law Insider Premium to draft better contracts faster.