THE FOLLOWING PARTS OF THE FUEL SYSTEM Sample Clauses

THE FOLLOWING PARTS OF THE FUEL SYSTEM. Fuel transfer pump, injection pump, intake manifold, throttle housing, injection nozzles, air-mass sensor, lambda, pressure and heat sensors, fuel tank sensors (not additive systems such as AdBlue or equivalent, piping, filters, sealing components, etc.)
THE FOLLOWING PARTS OF THE FUEL SYSTEM. Fuel transfer pump, injection pump, fuel injectors, and fuel tank sensors

Related to THE FOLLOWING PARTS OF THE FUEL SYSTEM

  • Definitions of Key Terms Relating to Additional Rent As used in this Article 4, the following terms shall have the meanings hereinafter set forth:

  • Testing of Metering Equipment Connecting Transmission Owner shall inspect and test all of its Metering Equipment upon installation and at least once every two (2) years thereafter. If requested to do so by NYISO or Developer, Connecting Transmission Owner shall, at Developer’s expense, inspect or test Metering Equipment more frequently than every two (2) years. Connecting Transmission Owner shall give reasonable notice of the time when any inspection or test shall take place, and Developer and NYISO may have representatives present at the test or inspection. If at any time Metering Equipment is found to be inaccurate or defective, it shall be adjusted, repaired or replaced at Developer’s expense, in order to provide accurate metering, unless the inaccuracy or defect is due to Connecting Transmission Owner’s failure to maintain, then Connecting Transmission Owner shall pay. If Metering Equipment fails to register, or if the measurement made by Metering Equipment during a test varies by more than two percent from the measurement made by the standard meter used in the test, Connecting Transmission Owner shall adjust the measurements by correcting all measurements for the period during which Metering Equipment was in error by using Developer’s check meters, if installed. If no such check meters are installed or if the period cannot be reasonably ascertained, the adjustment shall be for the period immediately preceding the test of the Metering Equipment equal to one-half the time from the date of the last previous test of the Metering Equipment. The NYISO shall reserve the right to review all associated metering equipment installation on the Developer’s or Connecting Transmission Owner’s property at any time.

  • Additional Requirements for Sleeping Rooms The Contractor shall provide departing Attendees a secured area for storing belongings.

  • Accounting Terms; Utilization of GAAP for Purposes of Calculations Under Agreement Except as otherwise expressly provided in this Agreement, all accounting terms not otherwise defined herein shall have the meanings assigned to them in conformity with GAAP. Financial statements and other information required to be delivered by Company to Lenders pursuant to clauses (ii), (iii) and (xii) of subsection 6.1 shall be prepared in accordance with GAAP as in effect at the time of such preparation (and delivered together with the reconciliation statements provided for in subsection 6.1(v)). Calculations in connection with the definitions, covenants and other provisions of this Agreement shall utilize GAAP as in effect on the date of determination, applied in a manner consistent with that used in preparing the financial statements referred to in subsection 5.3. If at any time any change in GAAP would affect the computation of any financial ratio or requirement set forth in any Loan Document, and Company, Administrative Agent or Requisite Lenders shall so request, Administrative Agent, Lenders and Company shall negotiate in good faith to amend such ratio or requirement to preserve the original intent thereof in light of such change in GAAP (subject to the approval of Requisite Lenders), provided that, until so amended, such ratio or requirement shall continue to be computed in accordance with GAAP prior to such change therein and Company shall provide to Administrative Agent and Lenders reconciliation statements provided for in subsection 6.1(v).

  • Construction With Other Parts Of The Tariff This ISA shall not be construed as an application for service under Part II or Part III of the Tariff.

  • Additional Acceptable Uses of Student Data Contractor is prohibited from using Student Data for any secondary use not described in this agreement except: a. for adaptive learning or customized student learning purposes; b. to market an educational application or product to a parent or legal guardian of a student if Contractor did not use Data, shared by or collected per this Contract, to market the educational application or product; c. to use a recommendation engine to recommend to a student i. content that relates to learning or employment, within the third-party contractor's internal application, if the recommendation is not motivated by payment or other consideration from another party; or

  • Ownership and Location of Metering Equipment The Metering Equipment to be constructed, the capability of the Metering Equipment to be constructed, and the ownership thereof, are identified on the attached Schedule C to this ISA.

  • Switching System Hierarchy and Trunking Requirements For purposes of routing PNG traffic to Verizon, the subtending arrangements between Verizon Tandem Switches and Verizon End Office Switches shall be the same as the Tandem/End Office subtending arrangements Verizon maintains for the routing of its own or other carriers’ traffic (i.e., traffic will be routed to the appropriate Verizon Tandem subtended by the terminating End Office serving the Verizon Customer). For purposes of routing Verizon traffic to PNG, the subtending arrangements between PNG Tandem Switches and PNG End Office Switches shall be the same as the Tandem/End Office subtending arrangements that PNG maintains for the routing of its own or other carriers’ traffic.

  • Geographic Area and Sector Specific Allowances, Conditions and Exceptions The following allowances and conditions shall apply where relevant. Where the Employer does work which falls under the following headings, the Employer agrees to pay and observe the relevant respective conditions and/or exceptions set out below in each case.

  • Use of Basement and Service Areas The basement(s) and service areas, if any, as located within the