Tutoring in specific subjects c. Hands on learning; exploring a variety of learning styles coupled with student abilities.
Tutoring in specific subjects Sample Clauses
Related to Tutoring in specific subjects
Reduction in Scope of the Project 16.6.1 If the Concessionaire shall have failed to complete any Construction Works on account of Force Majeure or for reasons solely attributable to the Authority, the Authority may, in its discretion, require the Concessionaire to pay 80% (eighty percent) of the sum saved therefrom, and upon such payment to the Authority, the obligations of the Concessionaire in respect of such works shall be deemed to have been fulfilled. For the avoidance of doubt, it is agreed that in the event such reduction in Scope of the Project causes or will cause a reduction in net after-tax return of the Concessionaire, the Parties shall meet, as soon as reasonably practical, and agree on a full or partial waiver of the aforesaid payment of 80% (eighty per cent) so as to place the Concessionaire in the same financial position as it would have enjoyed had there been no reduction in Scope of the Project. It is further agreed that the liability of the Authority under this Clause 16.6 shall not extend beyond waiver of the aforesaid 80% (eighty per cent). It is also agreed that in the event of a dispute, the Dispute Resolution Procedure shall apply.
Elements Unsatisfactory Needs Improvement Proficient Exemplary IV-A-1. Reflective Practice Demonstrates limited reflection on practice and/or use of insights gained to improve practice. May reflect on the effectiveness of lessons/ units and interactions with students but not with colleagues and/or rarely uses insights to improve practice. Regularly reflects on the effectiveness of lessons, units, and interactions with students, both individually and with colleagues, and uses insights gained to improve practice and student learning. Regularly reflects on the effectiveness of lessons, units, and interactions with students, both individually and with colleagues; and uses and shares with colleagues, insights gained to improve practice and student learning. Is able to model this element.
Measuring DNS parameters Every minute, every DNS probe will make an UDP or TCP “DNS test” to each of the public-‐DNS registered “IP addresses” of the name servers of the domain name being monitored. If a “DNS test” result is undefined/unanswered, the tested IP will be considered unavailable from that probe until it is time to make a new test.
Random Drug Testing All employees covered by this Agreement shall be subject to random drug testing in accordance with Appendix D.
Technical Standards Applicable to a Wind Generating Plant i. Low Voltage Ride-Through (LVRT) Capability A wind generating plant shall be able to remain online during voltage disturbances up to the time periods and associated voltage levels set forth in the standard below. The LVRT standard provides for a transition period standard and a post-transition period standard.
COVID-19 Protocols Contractor will abide by all applicable COVID-19 protocols set forth in the District’s Reopening and COVID-19 Mitigation Plan and the safety guidelines for COVID-19 prevention established by the California Department of Public Health and the Ventura County Department of Public Health.
Subprojects 1. The Borrower shall make Grants to Beneficiaries (Small Farmers, Municipalities and Organizations) for Subprojects (Farmers’ Business Initiatives, Infrastructure Subprojects and Environmental Subprojects) in accordance with eligibility criteria and procedures acceptable to the Bank as further detailed in the Project Operational Manual.
Selection of Subcontractors, Procurement of Materials and Leasing of Equipment The contractor shall not discriminate on the grounds of race, color, religion, sex, national origin, age or disability in the selection and retention of subcontractors, including procurement of materials and leases of equipment. The contractor shall take all necessary and reasonable steps to ensure nondiscrimination in the administration of this contract.
In-Scope Projects Project Based Information Technology (IT) Consulting Services required by an Authorized User must be obtained via a Mini-Bid process under this Contract. The Authorized User shall issue a Mini-Bid with a SOW for the required Project Based IT Consulting Services. A Mini-Bid may include, but will not be limited to, projects requiring: analysis, data classification, design, development, testing, quality assurance, security and associated customized training for IT based applications. Additional examples of in-scope projects include, but are not limited to: Technical architecture advisory services; Business analysis for project development; Proprietary software application development/customization, programming and integration; Data information management (including data migration, data conversion, data manipulation, data integration); Project management project support services - including, but not limited to; project management, project quality assurance and control, and Independent Verification & Validation (IV&V); Disaster recovery/business continuity and testing; Quality assurance; Continuity of operations planning (COOP); Data categorization; and Open-source software implementation. Out-of-Scope Work There are service offerings expressly excluded from the scope of these contracts. In many instances, such services and/or offerings are (or will be) covered by another OGS Centralized Contract. Examples include: Staff augmentation services; Time and material services; Web hosting; Automated network monitoring or any other service provided principally through an automated process; Hardware maintenance and support; Software maintenance and support; Ongoing maintenance and support; Services priced on a per asset basis; Services priced on a contingency basis; Equipment maintenance; Prepackaged training courses; E-Learning; Managed services; Acquisition of equipment (hardware) Acquisition of software, either Commercial off-the-shelf (COTS) software or pre-existing software; Acquisition of non-consulting services, such as network provisioning, voice services (local, long- distance), or video bridging; Cloud based or “As a Service” offerings, including but not limited to SaaS, IaaS, PaaS, and XaaS; Any offering that is a combination of equipment, hardware, software, cloud or “as a service offerings”; and Consulting or other installation work which is considered Public Works is excluded from purchase under the scope of this Contract. Historically, the New York State Bureau of Public Works has maintained that installation, maintenance and repair of equipment attached to any wall, ceiling or floor or affixed by hard wiring or plumbing is public work. In contrast, installation of a piece of equipment which is portable or a “plug-in” free-standing unit would not be considered public work. Thus, this Contract does not authorize installation where the equipment becomes a permanent part of the building structure, or is otherwise incorporated into the fabric of the building (i.e. installation on a wall, ceiling or floor in a fixed location, or affixed by hard- wiring or plumbing). See Appendix A, Clause 6, Wage and Hours Provisions. For questions about whether a proposed work constitutes public work, please contact the New York State Department of Labor’s Bureau of Public Work District Office in a specific area. A listing of district offices and contact information is available at xxxx://xxx.xxxxx.xx.xxx/workerprotection/publicwork/PWContactUs.shtm. Definitions Additional definitions applicable to this Contract can be found in Appendix B. Term Definition Authorized User Agreement The document resulting from the transactional Mini-Bid process, which sets forth the specifics regarding the services to be provided by the Contractor to the Authorized User, under the Project Based Information Technology Consulting Contract. Best Value The basis for awarding all service and technology contracts to the offerer that optimizes quality, cost and efficiency, among responsive and responsible offerers. Such basis shall be, wherever possible, quantifiable (State Finance Law §163 (1) (j)). Billing Contact The name, phone number, e-mail, and billing address a customer uses on a xxxx for contact information. Consultant Disclosure Legislation Chapter 10 of the Laws of 2006 amends State Finance Law § 8 and § 163 by requiring: that the Office of the State Comptroller (OSC) include in the Consulting Services Report it compiles annually on contracts issued by state agencies for consulting services during the previous fiscal year. xxxx://xxx.xxx.xxxxx.xx.xx/agencies/guide/MyWebHelp/Content/XI/18/C.htm Deliverables All services or products created during the performance or provision of Services hereunder or identified as a “Deliverable” in an applicable Mini-Bid. A Deliverable is a building block of an overall project. For the purposes of this Solicitation and the resulting Contract, a deliverable shall not be set forth as a status report, meeting attendance, a block of staff hours, or an invoice submission. Fixed Price Authorized User Agreement An agreement pursuant to the Centralized Contract that provides for a fix cost for a defined project. Government Contract A contract let by a Federal, State, or Local governmental body within the continental United States. Government Entity An entity at the federal, state, county, city or provincial level. Joint Venture A contractual agreement joining together two or more business enterprises for the purpose of performing on a State Contract. Knowledge Transfer The transfer of knowledge from the Contractor to the Authorized User. Knowledge Transfer can include full written system documentation including all system changes, training classes, manuals and other items. Depending on the scope of the transaction, there may or may not be a deliverable cost associated. All materials will be the property of the Authorized User unless specifically negotiated during the award process. May Denotes the permissive in a contract clause or specification. Refers to items or information that the State has deemed are worthy of obtaining, but not required or obligatory. Also see “Should”. Mini-Bid A type of Bid Document used by the Authorized User to obtain Services under the Project Based IT Consulting Services Contracts. Not To Exceed Rates (NTE) Refers to the New York State contract price set forth in Appendix D. Amounts proposed by the Contractor at the transactional level shall not exceed the hourly rates provided under this Contract (which will be defined values in US Dollars). Prime Contractor For the purposes of Technical qualifications, the business entity with whom a government entity directly has a contract. Project Based IT Consulting Services An OGS Centralized Contract which will provide a set of standardized terms and conditions, guidelines, processes, and templates for the development, distribution and award of specific deliverable-based and fixed-price Information Technology projects. Project Plan A formal, approved document used to guide both project execution and project control. The primary uses of the project plan are to document planning assumptions and decisions, facilitate communication among stakeholders, and document approved scope, cost, and schedule baselines. Retainage A portion of the Authorized User and Contractor fixed-price agreement amount that is held back by the Authorized User until the deliverable or project is satisfactorily finished. Should Denotes the permissive in a contract clause or specification. Refers to items or information that the State has deemed are worthy of obtaining, but not required or obligatory. Also see “May”. Term Definition Solicitation A non-competitive periodic recruitment solicitation (“Solicitation”) for vendors that provide Project Based Information Technology Consulting Services. Vendor An enterprise that sells goods or services. Vendor Submission The complete response to this Solicitation submitted by a Vendor to provide, as applicable , the Product and services described in the Solicitation
Minimum Site Requirements for TIPS Sales (when applicable to TIPS Sale). Cleanup: When performing work on site at a TIPS Member’s property, Vendor shall clean up and remove all debris and rubbish resulting from their work as required or directed by the TIPS Member or as agreed by the parties. Upon completion of work, the premises shall be left in good repair and an orderly, neat, clean and unobstructed condition. Preparation: Vendor shall not begin a project for which a TIPS Member has not prepared the site, unless Vendor does the preparation work at no cost, or until TIPS Member includes the cost of site preparation in the TIPS Sale Site preparation includes, but is not limited to: moving furniture, installing wiring for networks or power, and similar pre‐installation requirements. Registered Sex Offender Restrictions: For work to be performed at schools, Vendor agrees that no employee of Vendor or a subcontractor who has been adjudicated to be a registered sex offender will perform work at any time when students are, or reasonably expected to be, present unless otherwise agreed by the TIPS Member. Vendor agrees that a violation of this condition shall be considered a material breach and may result in the cancellation of the TIPS Sale at the TIPS Member’s discretion. Vendor must identify any additional costs associated with compliance of this term. If no costs are specified, compliance with this term will be provided at no additional charge. Safety Measures: Vendor shall take all reasonable precautions for the safety of employees on the worksite, and shall erect and properly maintain all necessary safeguards for protection of workers and the public. Vendor shall post warning signs against all hazards created by the operation and work in progress. Proper precautions shall be taken pursuant to state law and standard practices to protect workers, general public and existing structures from injury or damage. Smoking: Persons working under Agreement shall adhere to the TIPS Member’s or local smoking statutes, codes, ordinances, and policies.
