Units of Measurement and Calibration Sample Clauses

Units of Measurement and Calibration. The Parties shall co-operate in the design, selection and acquisition of devices to be used for measurements and tests in order that all measurements and tests may be conducted in the SI system of units, except for the quantity delivered which is expressed in MMBtu, the Gross Heating Value (volume based) which is expressed in Btu/SCF and the pressure which is expressed in millibar and temperature in Celsius. In the event that it becomes necessary to make measurements and tests using a new system of units of measurements, the Parties shall establish agreed upon conversion tables.
AutoNDA by SimpleDocs
Units of Measurement and Calibration. The Parties will cooperate closely in the design, selection, and acquisition of devices to be used for measurements and tests under this Article 13 in order that, to the maximum extent possible, all measurements and tests may be conducted either in Imperial units of measurement or in S.I. units of measurement. In the event that it becomes necessary to make measurements and tests using a new system of units of measurement, the Parties shall establish mutually agreeable conversion tables, or, if they are unable to agree, such tables may be established by the procedures provided for resolution of disputes on measurement and testing in Section 13.11. Measurement devices shall be calibrated as follows : 47
Units of Measurement and Calibration. The parties will cooperate closely in the design, selection, and acquisition of devices to be used for measurements and tests under this Article 13 in order that, to the maximum extent possible, all measurements and tests may be conducted either in American units of measurement or in metric units of measurement. In the event that it becomes necessary to make measurements and tests using a new system of units of measurement, the parties shall establish mutually agreeable conversion tables, or, if they are unable to agree, such tables may be established by the procedures provided for resolution of disputes on measurement and testing in Section 13.11. Measurement devices shall be calibrated as follows : -58- 61 Measurement American Units Metric Units ----------- -------------- ------------ Volume Cubic feet Cubic Meters Temperature Degrees Fahrenheit Degrees Centigrade Pressure Pounds per square Kilograms per square inch or inches of centimeter or mercury millimeters of mercury Length Feet Meters Weight Pounds Kilograms Density Pounds per cubic Kilograms per Cubic foot Meter

Related to Units of Measurement and Calibration

  • Measurement All quantities of Products received or delivered by or into truck, rail, or marine vessel shall be measured and determined based upon the meter readings at each Terminal, as reflected by delivery tickets or bills of lading, or if such meters are unavailable, by applicable calibration tables. All quantities of Products received and delivered by pipeline shall be measured and determined based upon the meter readings of the pipeline operator, as reflected by delivery tickets, or if such meters are unavailable, by applicable calibration tables. Deliveries to a Terminal rack at Mandan, Salt Lake City or Wilmington from a Tesoro Refinery shall be deemed to be the same as the corresponding volumes delivered contemporaneously from the Terminal rack. Deliveries by book transfer shall be reflected by entries in the books of TLO. All quantities shall be adjusted to net gallons at 60° F in accordance with ASTM D-1250 Petroleum Measurement Tables, or latest revisions thereof. A barrel shall consist of 42 U.S. gallons and a gallon shall contain 231 cubic inches. Meters and temperature probes shall be calibrated according to applicable API standards. Tesoro shall have the right, at its sole expense, and in accordance with rack location procedure, to independently certify said calibration. Storage tank gauging shall be performed by TLO’s personnel. TLO’s gauging shall be deemed accurate unless challenged by an independent certified xxxxxx. Tesoro may perform joint gauging at its sole expense with TLO’s personnel at the time of delivery or receipt of Product, to verify the amount involved. If Tesoro should request an independent xxxxxx, such xxxxxx must be acceptable to TLO, and such gauging shall be at Tesoro’s sole expense.

  • Performance Measure The number of Performance Shares earned at the end of the three-year Performance Period will vary depending on the degree to which cumulative adjusted earnings per share performance goals for the Performance Period, as established by the Committee, are met.

  • Performance Measures The extent, if any, to which you shall have the right to payment of the Award shall depend upon your satisfying one of the continuous employment conditions set forth in Section 3 and the extent to which the applicable performance measure has been satisfied as of the Final Measurement Date, as specified below: The Award shall have the following performance measures during the Measurement Period:

  • Measurement and Monitoring Tools As of the Effective date, Vendor and Prudential will mutually agree on the measurements and service level management procedures, pursuant to the governance procedures set forth in Attachment G and performance standards set forth in Attachment E-1 and E-2, to measure Vendor's performance of the Services against the applicable Service Levels. Such measurement and monitoring tools and procedures will (a) for Attachment E-1, be implemented upon the Effective Date; (b) for Attachment E-2, be implemented after successful completion of all testing and written acceptance by Prudential of the Transition Services set forth in Attachment B-1; (c) permit reporting at a level of detail sufficient to verify compliance with the Service Levels; and (d) be subject to audit by Prudential or its designee in accordance with the Agreement, except such audit will not include the installation of any audit software on Vendor's network.

  • Performance Adjustment One-twelfth of the annual Performance Adjustment Rate will be applied to the average of the net assets of the Portfolio (computed in the manner set forth in the Fund's Declaration of Trust or other organizational document) determined as of the close of business on each business day throughout the month and the performance period.

  • Cost of Metering The Issuer shall not be obligated to pay any costs associated with the routine metering duties set forth in this Section 2, including the costs of installing, replacing and maintaining meters, nor shall the Issuer be entitled to any credit against the Servicing Fee for any cost savings realized by the Servicer as a result of new metering and/or billing technologies.

  • Testing Procedure Limitations The Asset Representations Reviewer will only be required to perform the Tests, and will not be obligated to perform additional procedures on any Review Receivable or to provide any information other than a Review Report. However, the Asset Representations Reviewer may provide additional information in a Review Report about any Review Receivable that it determines in good faith to be material to the Asset Representations Review.

  • Performance Requirements To receive the Monthly Capacity Payment in Section 8.1.2.1, Seller shall provide the Contract Capacity in each Peak Month for all on-peak hours as such peak hours are defined in Edison's Tariff Schedule No. TOU-8 on file with the Commission, except that Seller is entitled to a 20% allowance for Forced Outages for each Peak Month. Seller shall not be subject to such performance requirements for the remaining hours of the year.

  • Performance Adjustment Rate Except as otherwise provided in sub-paragraph (e) of this paragraph 3, the Performance Adjustment Rate is 0.02% for each percentage point (the performance of the Portfolio and the Index each being calculated to the nearest .01%) that the Portfolio's investment performance for the performance period was better or worse than the record of the Index as then constituted. The maximum performance adjustment rate is 0.20%. For purposes of calculating the performance adjustment of the portfolio, the portfolio's investment performance will be based on the performance of the retail class. The performance period will commence with the first day of the first full month following the retail class's commencement of operations. During the first eleven months of the performance period for the retail class, there will be no performance adjustment. Starting with the twelfth month of the performance period, the performance adjustment will take effect. Following the twelfth month a new month will be added to the performance period until the performance period equals 36 months. Thereafter the performance period will consist of the current month plus the previous 35 months. The Portfolio's investment performance will be measured by comparing (i) the opening net asset value of one share of the retail class of the Portfolio on the first business day of the performance period with (ii) the closing net asset value of one share of the retail class of the Portfolio as of the last business day of such period. In computing the investment performance of the retail class of the Portfolio and the investment record of the Index, distributions of realized capital gains, the value of capital gains taxes per share paid or payable on undistributed realized long-term capital gains accumulated to the end of such period and dividends paid out of investment income on the part of the Portfolio, and all cash distributions of the securities included in the Index, will be treated as reinvested in accordance with Rule 205-1 or any other applicable rules under the Investment Advisers Act of 1940, as the same from time to time may be amended.

  • Performance Targets Threshold, target and maximum performance levels for each performance measure of the performance period are contained in Appendix B.

Time is Money Join Law Insider Premium to draft better contracts faster.