Bumping Procedure In the application of this Article, permanent part-time employees cannot displace permanent full-time employees or vice versa provided that permanent full-time employees who have exhausted their bumping rights hereunder and are to be laid off from work shall have the right to displace a permanent part-time employee with lesser GO seniority, within their section. Such bumping within the section may only be in a downward or lateral direction provided they are qualified, willing and able to do the work (refer to Schedule “E-I” and “E-I OFPT”). Downward shall be defined as lesser pay per hour and/or lesser hours per week (permanent full-time vs. permanent part-time). Lateral shall be defined as same pay per hour. In the application of this Article, permanent part-time employees cannot displace permanent full-time employees or vice versa provided that permanent full-time employees who have exhausted their bumping rights hereunder and are to be laid off from work, shall have the right to displace any permanent part-time employee with lesser GO Transit seniority, within their section provided they are able, willing and qualified. Due to the nature of the bumping procedure and the unpredictability of the direction and results of that bumping, the layoff must take precedent over all other normal movement of employees (i.e., standing applications). During layoffs an employee may choose to accept an open position for which he/she is qualified rather than bumping within their classification or section and should he/she elect this option, they shall retain recall rights to the original classification without loss of seniority. Where an OFPT employee who has been notified or is on layoff and currently possesses the qualifications and skills of a position they have held previously, then the employee may bump laterally or downward within their section or another section where the previously held position is identified. At the time of layoff the employee must satisfy the criteria identified in the current job description, and the employee must have satisfied the performance standards of that classification. Should the parties agree that the bumping procedure will likely cause significant movement within a classification or section, then the parties may agree to have a “master” sign-up take place which will be the sole responsibility of the Union to administer.
Testing Procedures The following test procedure shall apply to all urine tests administered to bargaining unit employees:
a. Urine specimens shall be collected at the approved laboratory as stated below in section (e), or at an accredited medical facility when necessary after an accident.
b. The employee shall not be observed when the urine specimen is given.
c. All specimen containers, vials or bags used to transport the samples shall be sealed with evidence tape and labeled in the presence of the employee.
d. The testing shall be done by another approved laboratory.
e. The employer shall choose the testing/collection facility to be utilized for toxicology testing on a yearly basis.
f. The following standards shall be used to determine what levels of detected substances shall be considered positive. Note: - These are current levels subject to change by Federally Mandated Regulations. Current Federal Regulations shall be controlling in case of change or conflict: DRUG SCREENING TEST CONFIRMATION Amphetamines 500 ng/ml Amphetamine 250 ng/ml GC-MS Marijuana Metabolites 50 ng/▇▇ ▇▇▇▇▇-THC 15 ng/ml GC-MS Cocaine Metabolites 150 ng/ml Metabolites 100 ng/ml GC-MS Opiates Morphine 2,000 ng/ml 2,000 ng/ml GC-MS PCP 25 ng/ml PCP 25 ng/ml GC-MS MDMA 500 ng/ml 250 ng/ml Alcohol .08 Breath .04 Breath – Employees with CDL .02 - .039 Breath - Employees with CDL will be removed from service for 24 hrs.
g. Tests which are below the levels set forth above shall be determined as negative. If test results are negative, all non-required documentation regarding supervisors' observations and testing will be destroyed.
h. At the time the urine specimen is collected two samples will be taken. One sample will be sent to the laboratory to be tested at the employer's expense. If the first sample tests positive then upon written request by the employee within twenty-four
Access Toll Connecting Trunk Group Architecture 9.2.1 If WCS chooses to subtend a Verizon access Tandem, WCS’s NPA/NXX must be assigned by WCS to subtend the same Verizon access Tandem that a Verizon NPA/NXX serving the same Rate Center Area subtends as identified in the LERG.
9.2.2 WCS shall establish Access Toll Connecting Trunks pursuant to applicable access Tariffs by which it will provide Switched Exchange Access Services to Interexchange Carriers to enable such Interexchange Carriers to originate and terminate traffic to and from WCS’s Customers.
9.2.3 The Access Toll Connecting Trunks shall be two-way trunks. Such trunks shall connect the End Office WCS utilizes to provide Telephone Exchange Service and Switched Exchange Access to its Customers in a given LATA to the access Tandem(s) Verizon utilizes to provide Exchange Access in such LATA.
9.2.4 Access Toll Connecting Trunks shall be used solely for the transmission and routing of Exchange Access to allow WCS’s Customers to connect to or be connected to the interexchange trunks of any Interexchange Carrier which is connected to a Verizon access Tandem.
Signaling protocol 4.1.3.1 SS7 Signaling is AT&T-21STATE’s preferred method for signaling. Where MF signaling is currently used, the Parties agree to use their best efforts to convert to SS7. If SS7 services are provided by AT&T-21STATE, they will be provided in accordance with the provisions of the applicable access tariffs.
4.1.3.2 Where MF signaling is currently used, the Parties agree to interconnect their networks using MF or dual tone MF (DTMF) signaling, subject to availability at the End Office Switch or Tandem Switch at which Interconnection occurs. The Parties acknowledge that the use of MF signaling may not be optimal. AT&T-21STATE will not be responsible for correcting any undesirable characteristics, service problems or performance problems that are associated with MF/SS7 inter-working or the signaling protocol required for Interconnection with CLEC employing MF signaling.
Closing Procedures Subject to satisfaction or waiver by the relevant Party of the conditions of Closing, on the Closing Date, the Sellers shall deliver actual possession of the Purchased Interest to the Purchaser and upon such delivery the Purchaser shall pay and issue the Purchase Price in accordance with Section 2.3.
