Water and Energy Conservation Sample Clauses

Water and Energy Conservation. The Concessionaire shall implement water and energy conservation measures. As new technologies are developed, Concessionaire shall explore the possibility of integrating them into existing operations where there is potential for increased efficiency, reduced water or energy consumption, and/or reduced impacts on the environment.
AutoNDA by SimpleDocs

Related to Water and Energy Conservation

  • Energy Conservation The Contractor agrees to comply with mandatory standards and policies relating to energy efficiency which are contained in the state energy conservation plan issued in compliance with the Energy Policy and Conservation Act.

  • Conservation Operations hereunder and production of unitized substances shall be conducted to provide for the most economical and efficient recovery of said substances without waste, as defined by or pursuant to State or Federal law or regulation.

  • Pollution Control The Employer and the Union agree to limit all forms of environmental pollution.

  • Arkansas CANCELLATION section is amended as follows: A ten percent (10%) penalty per month shall be applied to refunds not paid or credited within forty-five (45) days of receipt of returned Service Agreement.

  • Energy Policy and Conservation Act Both parties hereby agree to comply with all mandatory standards and policies relating to energy efficiency, which are contained in the state energy conservation plan issued in compliance with the Energy Policy and Conservation Act (Pub. L. 94-163, 89 Stat. 871).

  • HEALTH, SAFETY AND ENVIRONMENT In the performance of this Contract, Contractor and Operator shall conduct Petroleum Operations with due regard to health, safety and the protection of the environment (“HSE”) and the conservation of natural resources, and shall in particular:

  • Energy Cooperation shall focus on: (a) renewable energy; (b) promoting the saving of energy; (c) applied research relating to networks of databases linking the two Parties' economic and social operators; (d) backing efforts to modernise and develop energy networks and the interconnection of such networks with Community networks.

  • HEALTH AND SAFETY 25.01 The Employer is subject to the provisions of the Occupational Health and Safety Act of the Province of Ontario and its regulations, including the provision that calls for a worker representative selected by the Union on the University Joint Health and Safety Committees. It is agreed that the University and the Union will cooperate to the fullest possible extent in the prevention of accidents and the promotion of safety and health at University workplaces. To this end, the parties acknowledge and agree that all University Employees on University and third-party premises where Employees work, are required to comply with work- site specific policies, procedures, regulations, and standards relating to health and safety. 25.02 The Employer recognizes the right of workers to be informed about hazards in the workplace, to be provided with appropriate training, and the right to refuse unsafe work in accordance with the Occupational Health and Safety Act where there is an immediate danger to the Employee’s health and safety or to the health and safety of others. 25.03 The Union will select a worker representative for each applicable Joint Health and Safety Committee formed under the Occupational Health and Safety Act. Time spent attending meetings of the Committee or carrying out duties as a worker representative shall be considered time worked. 25.04 A worker representative on a Joint Health and Safety Committee may become a certified worker representative on the Committee. The University will provide the required training for certification at no cost to the Employee or the Union. Time spent in such training shall be considered time worked, as outlined in Article 13 – Hours of Work and Overtime. 25.05 When a worker representative on a Joint Health and Safety Committee ceases to be employed in the Bargaining Unit, he/she will cease to be a worker representative on the Committee. 25.06 The University will supply, and Employees will wear and/or utilize, personal protective equipment and the other devices that the University requires Employees to wear and/or utilize. 25.07 The Employer shall provide information, training and supervision to an Employee to protect the health and safety of that Employee. With reference to Article 13, time spent in such training shall be considered time worked, as outlined in Article 13 – Hours of Work and Overtime. 25.08 The name and contact information of the Health and Safety Officer in each Academic Unit shall be posted in the Department/Academic Unit. 25.09 In accordance with the Occupational Health and Safety Act, persons with authority in the workplace, including any Employees, shall ensure that persons under their authority are informed of health and safety hazards, and advised of policies and procedures associated with the safe handling of materials and equipment.

  • Electric Storage Resources Developer interconnecting an electric storage resource shall establish an operating range in Appendix C of its LGIA that specifies a minimum state of charge and a maximum state of charge between which the electric storage resource will be required to provide primary frequency response consistent with the conditions set forth in Articles 9.5.5, 9.5.5.1, 9.5.5.2, and 9.5.5.3 of this Agreement. Appendix C shall specify whether the operating range is static or dynamic, and shall consider (1) the expected magnitude of frequency deviations in the interconnection; (2) the expected duration that system frequency will remain outside of the deadband parameter in the interconnection; (3) the expected incidence of frequency deviations outside of the deadband parameter in the interconnection; (4) the physical capabilities of the electric storage resource; (5) operational limitations of the electric storage resources due to manufacturer specification; and (6) any other relevant factors agreed to by the NYISO, Connecting Transmission Owner, and Developer. If the operating range is dynamic, then Appendix C must establish how frequently the operating range will be reevaluated and the factors that may be considered during its reevaluation. Developer’s electric storage resource is required to provide timely and sustained primary frequency response consistent with Article 9.5.5.2 of this Agreement when it is online and dispatched to inject electricity to the New York State Transmission System and/or receive electricity from the New York State Transmission System. This excludes circumstances when the electric storage resource is not dispatched to inject electricity to the New York State Transmission System and/or dispatched to receive electricity from the New York State Transmission System. If Developer’s electric storage resource is charging at the time of a frequency deviation outside of its deadband parameter, it is to increase (for over-frequency deviations) or decrease (for under-frequency deviations) the rate at which it is charging in accordance with its droop parameter. Developer’s electric storage resource is not required to change from charging to discharging, or vice versa, unless the response necessitated by the droop and deadband settings requires it to do so and it is technically capable of making such a transition.

  • Environmental Health and Safety i. Environment, Health and Safety Performance. Seller acknowledges and accepts full and sole responsibility to maintain an environment, health and safety management system ("EMS") appropriate for its business throughout the performance of this Contract. Buyer expects that Seller’s EMS shall promote health and safety, environmental stewardship, and pollution prevention by appropriate source reduction strategies. Seller shall convey the requirement of this clause to its suppliers. Seller shall not deliver goods that contain asbestos mineral fibers.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!